Kidde Kn Cope D Brochure

: Kidde Kidde-Kn-Cope-D-Brochure-748662 kidde-kn-cope-d-brochure-748662 kidde pdf

Open the PDF directly: View PDF .
Page Count: 2

Description

The Kidde Front-Loading Smoke and Carbon Monoxide alarm (part#

CP9000) offers protection from two hazards – fire and CO – in

one unit. This 9-volt battey powered alarm emits a beeping tone

followed by a voice warning that clearly announces the danger by

saying, “Fire! Fire!” or “Warning! Carbon Monoxide!” The uniquely

designed front-loading battery compartment makes battery replace-

ment quick and easy, and ensures proper installation. Manufactured

with a photoelectric sensor for detecting smoke and fire, this alarm

also includes the world’s most accurate CO sensing technology

based on claims by major manufacturers.

Alarm Warnings

Fire: The red LED will flash and be accompanied by three long alarm

beeps followed by a verbal warning message “FIRE! FIRE!” The alarm

will repeat pattern until unit is reset or smoke is eliminated.

Carbon Monoxide: Four short alarm beeps followed by a verbal

warning “WARNING! CARBON MONOXIDE!” After four minutes the

alarm/voice pattern will sound once every minute until the unit is

reset, or the CO is eliminated.

Low Battery: One chirp followed by warning “LOW BATTERY.” The

red LED light will flash. This pattern will continue every minute for

the first hour. After the first hour the red LED light will flash once

every minute accompanied by the chirp sound. The “LOW BATTERY”

warning will only sound once every fifteen minutes. This cycle will

continue for at least 7 days.

Voice Hush Indication: “HUSH MODE ACTIVATED” and “HUSH

MODE CANCELLED” voice announcement

Alarm Memory: The green LED will blink once every 16 seconds to

alert a user when the unit has alarmed for smoke or has detected a

hazardous concentration of CO. If the alarm has detected a CO level

of 100ppm or greater, when the Test/Reset button is pressed the

unit will announce “CO PREVIOUSLY DETECTED.” If the alarm has

detected abnormal levels of smoke since its last test, it will produce

three rapid beeps.

Features and Benefits

• Front-Loading Battery – Speeds up replacement by eliminating the

need to remove the unit from the ceiling or wall.

• Unique Battery Door Design – Will not close if battery is not

installed properly.

• Voice Warning – Supplements warning from the traditional 85-decibel

alarm by clearly stating the danger present, fire or carbon monoxide.

• Photoelectric smoke sensor – May detect visible fire particles associated

with slow smoldering fires sooner than an ionization sensor.

• Electrochemical CO sensor – Provides accurate and continual CO

protection during the product’s life, remains stable during temperature

and humidity changes and resists reactions to household gases that may

cause false readings or reduce sensitivity.

• Smart Touch Button – One button performs the following functions:

– Activates the Hush® feature to temporarily silence nuisance alarms

(will announce “Hush mode activated,” or “Hush mode cancelled.”)

– Simultaneously tests the unit’s electronics and verifies proper operation

– Activates the peak level memory feature (will announce “CO previously

detected” if unit has detected levels of 100 ppm or higher)

– Resets the unit during a CO alarm (Unit will re-enter alarm within

6 minutes of reset if 70ppm or more of CO is present).

– Silences end of life chirp for two days at a time, up to 30 days maximum.

• Tamper Resistant – Unit will lock to mounting bracket and battery

door will lock to deter theft or tampering.

• Green LED – Will flash every 30 seconds to indicate proper operation.

• Red LED – Flashes in conjunction with the alarm sounding.

• End of Life Signal – Ten years after initial power, the unit will “chirp” twice

every 30 seconds to indicate the need to immediately replace the alarm.

• Low Battery Signal – Will chirp

every minute and red LED will flash

to indicate low battery condition.

Battery Operated Combination

Carbon Monoxide & Photoelectric Smoke Alarm

– Alarm/Voice message warning system

– Front loading battery

Part Number CP9000 Model KN-COPE-D

Voice Warning

Warns of hazard by announcing “Fire, Fire” or “Warning, Carbon Monoxide”

Peak Level Memory

Alerts user when the unit has detected CO concentrations of 100ppm or higher

Two LED’s

• Red – Alarm mode

• Green – Indicates power is present

Smart Hush™

Silences the unit during nuisance alarm situations

(Smoke must be present before hush is activated)

Front Load Battery Door

Battery Operated Combination Carbon

Monoxide & Photoelectric Smoke Alarm

Part Number CP9000

Model KN-COPE-D

This alarm uses photoelectric sensing technology. Leading authorities recommend

that both ionization and photoelectric smoke alarms be installed to help insure

maximum detection of the various types of fires that can occur within the home.

Ionization sensing alarms may detect invisible fire particles (associated with fast

flaming fires) sooner than photoelectric alarms. Photoelectric sensing alarms may

detect visible fire particles (associated with slow smoldering fires) sooner than

ionization alarms.

Architectural and Engineering

Specifications

The combination smoke and carbon monoxide alarm shall be Kidde Part Number

CP9000 (Model KN-COPE-D) or approved equal. It shall be powered by one 9V

battery. The temperature operating range shall be between 40°F and 100°F (4°C

and 38°C) and the humidity operating range shall be 10% - 95% relative humid-

ity, non condensing.

The unit shall incorporate a photoelectric smoke sensor with nominal sensitivity of

2.5 +/- 0.95%/ft. The CO sensor shall be of a fuel cell design and shall meet the

sensitivity requirements of Underwriters Laboratories UL2034 Single and Multiple

Station Carbon Monoxide Detectors. The unit shall qualify for UL-approved word-

ing on the package: “World’s Most Accurate Carbon Monoxide Alarm.”*

The combination alarm can be installed on the surface of any wall or ceiling fol-

lowing the UL/NFPA/Manufacturer’s recommended placement guidelines. The unit

shall provide optional tamper resistance that deters removal of the unit from the

wall or ceiling. No additional pieces shall be required to activate this feature.

The alarm shall include a test button that will electronically simulate the pres-

ence of smoke and CO and cause the unit to go into both modes of alarm. This

sequence tests the unit’s electronics to ensure proper operation. The CO sensor

will not alarm to levels of CO below 30 ppm and will alarm in the following time

range when exposed to the corresponding levels of CO.

70 ppm CO Concentration 60 – 240 minutes

150 ppm CO Concentration 10 – 50 minutes

400 ppm CO Concentration 4 – 15 minutes

The combination alarm shall have two methods of warning for danger: a piezo-

electric horn that is rated at 85 decibels at 10 feet and a voice warning that identi-

fies the danger. For a CO incident, the horn will sound in the repetitive manner

– four (4) fast beeps, a short pause, four (4) fast beeps, a short pause. In between,

the unit will announce “Warning Carbon Monoxide!” After four minutes the

alarm/voice pattern will sound once every minute until the unit is reset, or the

CO eliminated. In a Smoke incident, the horn will sound in the repetitive man-

ner – three (3) beeps, a pause, three (3) beeps, a pause. In between, the unit will

announce “Fire! Fire!” The unit shall incorporate 2 LED’s. A green LED will flash

every 30 seconds when in standby condition, every 16 seconds to indicate alarm

memory, and every 2 seconds to indicate the Hush“ mode is active. A red LED will

flash in unison with the sounder pattern. The unit shall include the Smart Hush™

feature that silences the unit for approximately 8 minutes if a nuisance alarm condi-

tion occurs. The Green LED on the alarm will flash every 2 seconds while in Smart

Hush™ and will automatically reset itself. Smart Hush™ Feature also provides voice

Technical Specifications

Part Number: CP9000

Model: KN-COPE-D

Power Source:

9V battery

Smoke Sensor: Photoelectric

CO Sensor: Electrochemical

Audio Alarm: 85dB at 10ft

Temperature Range: 40˚F (4.4˚C) to 100˚F (37.8˚C)

Humidity Range: 10%-95% relative humidity,

non-condensing

Size: 5.79” in diameter x 1.85” depth

Weight: .7lb

Interconnects: No

Warranty: 10 year limited

1016 Corporate Park Drive

Mebane NC 27302

1-800-880-6788 www.Kidde.com

KL-CP9000 sheet rev. 04-2014

Distributed by:

annunciation of “Hush Mode Activated” when Smart Hush™ is activated

and “Hush Mode Cancelled” when the Hush cycle ends.

The unit shall also indicate a low battery warning utilizing each of the

following methods: a brief alarm chirp, the voice announcement of

“Low Battery!” The unit shall at a minimum meet the requirements of UL

2034, UL217, NFPA72, (chapter 11 2002 edition) The State of California

Fire Marshall, NFPA101 (One and two family dwellings) Federal Housing

Authority (FHA), Housing and Urban Development (HUD). It shall also

include a 10-year manufacturer’s limited warranty.

*Claim approved by UL, based on manufacturer’s reported testing.

Ordering Information

Ordering Pack Pack Dimensions Cartons/

Number UPC I 2 of 5 Config Qty (w x d x h inches) Weight Pallet

21010031 0-47871-10031-6 100-47871-10031-6 CLAM Cut Case (4 Units) 7.9 x 13.2 x 11.7 1.8 54