Kiddesigns 200N V200 WALKIE TALKIES User Manual XX V200 IB 04152015

Kiddesigns Inc V200 WALKIE TALKIES XX V200 IB 04152015

Users Manual

ATTENTION: Batteries should only be installed by an adult.1. Open the battery compartment door.2. Install 3 "AA" size batteries into the compartment of each Walkie Talkie, making sure that the + and - polarities match the diagram printed inside.3. Close the battery compartment door.Installing the BatteriesQuestions or CommentsFor questions or comments regarding this or other Tech2Go products, please call our toll-free number: 1-866-832-4022.It is important to keep the unit as dry and clean as possible. Clean the unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as thinner or similar materials are not recommended, as they may damage the surface of the case.Do not allow dirt, sand, small particles, water or other liquids to enter the toy's casing.If the unit is to be left unused for an extended time period, such as a month or longer, have an adult remove the battery to extend its life and to prevent leaking or corrosion.Battery Installation132Walkie Talkie ControlsTurning Power ON/OFFFCC InformationThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.CAN ICES-3 (B)/NMB-3(B)FCC ID : IAJ200MODEL V200Important Message to Customers Thank you for purchasing one of our many top-quality electronic products. Please take a moment to read through these instructions to help you understand the safe and proper way to use this toy to extend its usability.Walkie TalkiesMODEL:XX-V200INSTRUCTION MANUAL (FRONT)DATE : April 15, 2015SIZE: 216 L x 140 H mmCOLOR : 1C +1CMODEL:XX-V200INSTRUCTION MANUAL (BACK)DATE : April 15, 2015SIZE: 216 L x 140 H mmCOLOR : 1C +1CFor the Best Possible Performance• Only use the recommended/supplied batteries or equivalent.• Use alkaline batteries for longer life.• Do not mix old and new batteries, and do not mix alkaline, carbon-zinc or rechargeable nickel-cadmium batteries.• Insert batteries with proper polarity (+/–) as indicated.• Remove exhausted batteries from product.• Recharge rechargeable batteries under adult supervision.• Do not attempt to recharge non-rechargeable batteries.• Do not open batteries or heat them beyond normal ambient temperatures.• To prevent battery leakage or damage remove batteries from a product if it will not be used for a month or longer.• Use extreme caution handling leaking batteries (avoid direct contact with eyes and skin). If battery leakage comes in contact with eyes, IMMEDIATELY flush the eye with lukewarm and gently flowing water for at least 30 minutes. If skin contact occurs, wash skin with clear water for at least 15 minutes. Seek medical attention if any symptoms occur.• Store in cool, dry, ventilated area away from hazardous or combustible material.• Do not dispose of batteries in the household trash or fire.• Follow applicable laws and local regulations for the disposal and transportation of batteries.ON/OFF SwitchTalk ButtonCall Button• Slide the On/Off Switch to the ON position to activate the Walkie Talkies.• Both Walkie Talkies must be turned on in order to send and receive messages.• Slide the On/Off Switch to the OFF position to shut off the Walkie Talkies.Press and hold the Talk Button while speaking into the Microphone.You Should KnowFor clear transmission, keep the Microphone approximately two inches from your mouth.Sending Voice Messages• Both Walkie Talkies must be turned on in order to send and receive messages.• Messages cannot be received while your Talk Button is being pressed.• Messages can be heard through the Speaker.Receiving MessagesSpeaker/MicrophoneWalkie Talkies can be used for all kinds of fun games and activities. Here are two suggestions:Hide and SeekJust like regular Hide and Seek, but with a twist: the “Hider” can send clues to the “Seeker” using the Walkie Talkies.Mystery SoundsCan you recognize the mystery sound? One kid sends a sound over the Walkie Talkies, while another tries to guess what the sound is. Examples can include an animal, song, TV show, or anything else! Walkie Talkie GamesIf one or both of the Walkie Talkies do not work, or if the signal range of the Walkie Talkies decreases notably, this may indicate that the batteries are weak. Insert 3 new “AA” batteries into each unit.Please keep in mind that this product does not transmit well through obstacles such as trees, buildings, and metal structures.If there is a sizable increase in static, it may be due to the proximity of electric motors, fluorescent lights, power lines, or other signal-disrupting objects. You may have to change your location.If problems persist, DO NOT ATTEMPT TO REPAIR THE UNIT. TroubleshootingSCANCALLLMSCANCALLLMSCANCALLLMMaintenanceXX-V200_041415-A Printed in ChinaUsing The Call Button• Use the Call Button to send Morse code signals to one another. As you press and hold the Talk Button, press the Call Button quickly to send a • (dot), or hold the Call Button longer to send a - (dash).

Navigation menu