Kiddesigns 210N FRS 2-Way Radios (Walkie Talkie) User Manual MS 210 EN IB 05072015 OL
Kiddesigns Inc FRS 2-Way Radios (Walkie Talkie) MS 210 EN IB 05072015 OL
User Manual
FRS FREQUENCY CHART (MHz)
CH. No. CH. Freq. CH. No. CH. Freq. CH. No. CH. Freq.
1 462.5625 4 462.6375 7 462.7125
2 462.5875 5 462.6625 --- ---
3 462.6125 6 462.6875 --- ---
FCC Warning
To ensure that your expose to RF electromagnetic
energy is Within the FCC allowable limits for
occupational use, alwaysAdhere to the following
guidelines:
z DO NOT operate the radio without a proper antenna attached, as this may damaged the radio
And may also cause you to exceed FCC RF exposure limits, A proper antenna is the antenna
Supplied with this radio by the manufacturer or antenna specifically authorized by the
manufacturer for use with this radio.
z DO NOT transmits for more than 50% of total radio use time (“50% duty cycle). Transmitting
more than 50% of the time can cause FCC RF exposure compliance requirements to be
exceeded. The radio is transmitting when the “TX indicator” lights red. You can cause the
radio to transmit by pressing the “PTT” switch.
z ALWAYS kepp the antenna at least 2.5cm (1 inch) away from the body when transmitting and
Only use the belt-clip which is listed in instructions when attaching the radio to your belt, etc.,
to ensure FCC RF exposure compliance requirements are not exceeded.
The information listed above provides the user with the information needed to make him or her
aware of RF exposure, and what to do to as-sure that this radio operates with the FCC RF
exposure limits of this radio.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation
NOTE 1: This equipment has been tested and found to comply with the part 95 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.