Kiddesigns SL235-49MR RC Toy User Manual

Download:
Mirror Download [FCC.gov]
Document ID	336153
Application ID	FF6bE2UpuRhS5orE+fDQXA==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	5.88kB (73551 bits)
Date Submitted	2003-06-30 00:00:00
Date Available	2003-06-30 00:00:00
Creation Date	2003-05-17 11:16:54
Document Lastmod	2003-05-17 11:28:27
Document Title	User Manual
Document Creator	HP 9100C Digital Sender
Document Author:	ITS ELECTRIC TOY

Barbie of Swan Lake
Model No SL-235
Remote Control Vehicle
This device complies with Part 15 of the FCC Rules. Operation Is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must
accept any interference received, including interference that may cause undesired operation.
FCC Rules also prohibit unauthorized changes or modifications to the transmitter by user.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful Interference In a
residential installation. This equipment generates, uses‘and can radiate radio
frequency energy and, If not Installed and used In accordance with the Instructions,
may cause harmful Interference to radio communications.
However, there is no guarantee that interference will not occur In a particular
Installation. if this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
El Reorlent or relocate the receiving antenna.
D Increase the separation between the equipment and receiver.
El Connect the equipment into an outlet on a circuit different from that to which the
receiver is needed.
El Consult the dealer or an experienced radio/TV technician for help.
Warning: Car contains rechargeable Nickel-Cadmium Battery. Battery must be recycled or
disposed properly.
Getting Started
Use a Phillip head screwdriver to open Battery Door on the controller.
Insert 3 “AA" batteries. checking the + and — ends of the batteries.
Close the battery door properly.
Place antenna into the hole at the top of controller. Turn clockwise to secure antenna to
controller. DO NOT OVER-TIGHTEN. Pull tip of antenna to extend.
We recommend
0 Do not mix old and new batteries.
0 Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
- Removing batteries il unit is not used lor more than 30 days.
Char the r
1. To charge the car, open cover at the bottom of the controller.
2. Align metal nodes on controller with the nodes on the car and place it onto controller.
PPNH
3, The CHARGING INDICATOR will light up when the car is charging. After fully charged (approx
30 seconds) the light will turn off.
4. Take the car off of controller carefully.
ggntrolllng the Car
1. To make the car go, push the FORWARD or REVERSE button. The car will go forward or
backward.
2. To car will only turn left or right when it is moving, So to turn left or right, push the LEFT or
RIGHT button together with FORWARD or REVERSE button.
3, The OPERATION INDICATOR will light up when operating the car, When the indicator
become faint, it is time to replace batteries.
Note: While operating controller. make sure antenna is fully extended.
Remarks: Occasionally the car will sway left or right while moving in forward or backward
direction. To correct this, adjust the directional guild on the bottom of the car, This may need to
be done a few times while operating the care,
Maintenance
For best results operate on a smooth dry surface. Radio waves control this toy and can easily be
interrupted Avoid using near phones, electrical line or 05‘s. The manufacture is not responsible
for radio or TV interference caused by unauthorized modifications could void the users authority
to operate the equipment. If played outdoors. there might be malfunctions dust and rubbish. Dust
and clean it.
Clea the Cabinet
Take cares to keep the unit clean and dry. You may clean the cabinet with mild soap and water.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Creator                         : HP 9100C Digital Sender
Create Date                     : 2003:05:17 11:16:54
Author                          : ITS ELECTRIC TOY
Producer                        : 
Title                           : 
Subject                         : 
Modify Date                     : 2003:05:17 11:28:27+08:00
Page Count                      : 2

EXIF Metadata provided by EXIF.tools