Kobian Canada 10DTB44 Tablet PC User Manual A16 006 10DTB44 Phantom2 QuickStartGuide ENG indd

Download:
Mirror Download [FCC.gov]
Document ID	2956269
Application ID	MU1sRusinlgGPFVE9mIkyQ==
Document Description	User manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	51.31kB (641427 bits)
Date Submitted	2016-04-12 00:00:00
Date Available	2016-04-12 00:00:00
Creation Date	2016-01-25 16:34:37
Producing Software	Adobe PDF Library 10.0.1
Document Lastmod	2016-03-31 10:06:10
Document Title	A16_006_10DTB44_Phantom2_QuickStartGuide_ENG.indd
Document Creator	Adobe InDesign CS6 (Macintosh)

PHANTOM 2
QUICK START GUIDE
www.hipstreet.com
Getting started
Device Layout
Touch screen
Camera
Speakers
App Menu
01
Back Button
Home Button Menu Button History Button Volume -/+ Buttons
Rear
Camera
Power Button
Volume Buttons
USB Port
Headset Jack
Micro SD Card Port
HDMI Port
02
Basic functions
Charging / Power ON/OFF / Wi-Fi / Menu
*You can access the full user manual for more information.
Prior to using the device, fully charge the battery. The
device has a built in battery that uses only the supplied
charger to charge it.
In order to prolong the service life of the product, use the
device until the battery is depleted for the first two times
before charging the battery again.
To charge the battery, connect one end of the charger to
your wall outlet. Plug the USB cable into the charger and
the other end to the device’s DC jack.
Note:
When the device is not in use, be sure to turn it off to
conserve the battery.
03
1. Press the Power button to power ON the device.To power
ON the device, press and hold the Power button for a few
seconds until the startup image appears on the screen.
Slide the lock icon to unlock the tablet.
2. To Power OFF the tablet, press and hold the Power
button for a few seconds, then a “Power OFF” dialog
box will pop up.
Select “OK” to power OFF your tablet.
3. When the tablet is already powered ON, tap the
power button once to put the tablet in sleep mode.
4. When the tablet is in sleep mode, tap
the Power button once to wake the tablet.
Slide the lock icon to unlock the tablet.
04
Basic functions
Charging / Power ON/OFF / Wi-Fi / Menu
1. Select the “Settings” icon from the Menu.
2. Slide the Wi-Fi switchto the “ON” position.
ON
3. Select your Wi-Finetwork from the list.
4. Enter the required password.
5. Once connected, the Wi-Fi connectivity icon will be
shown at the bottom-right side of the Home screen.
05
1. Menu
From the Home Screen, select the apps menu icon
in the top-right side of the home screen to access
the app list.
2. Select the app you’d like to open.
3. Select the Back button to return to the previous screen;
Select the Home button to return to the Home screen.
06
Personalize your device
Email / Wallpaper / Connect
1. From the Menu, select “Email”.
Email account:
Email address:
Password:
Manual setup
Next
2. Enter your Email address, password and tap “Next”.
3. Select which type of email account you are setting up
and it’s complete settings.
You will need to enter your user name, password,
andserver information depending on the type of
email account, or you can change the settings by
tapping “Manual Setup”. Tap “Next” and select
“OK” to accept the activation.
1. Press and hold on a blank spot on the Home Screen
anda menu will show up. Select from pictures in
your galleryor the pre-loaded live and standard
wallpapers. Once selected, tap “Set Wallpaper”.
Choose wallpaper from
07
Gallery
Live wallpapers
Wallpapers
1. Connect the supplied USB cable from yourtablet to an
unused USB port on your computer.
2. Touch the “USB” icon on the top-left side on
your tablet, and select “USB Connected”.
3. Touch “Turn on USB storage”.
Turn on USB storage
4. Once connected successfully, select the “hipstreet” drive
on your computer to view/edit/add/delete files on your
device.
5. When finished, touch “Turn off USB storage”and
disconnect the cable.
08
Turn off USB storage
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful
interference (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate(SAR). The SAR
limit set by the FCC is 1.6 W/kg. The highest SAR level measured for this device is less than SAR limit, so this device meets the FCC
Requirement.
IC Caution:
RSS-Gen Issue 4 November 2014"&"CNR-Gen 4e éditionNovembre 2014:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept
any interference, including interference that may cause undesired operation of the device.
Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitationestautorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest susceptible d'encompromettre
le fonctionnement.
FCC ID:YH5‐10DTB44
IC: 8012A‐10DTB44
North America
1- 888-456-2426
UK
0800-051-8330
Netherlands
0800-404-0006
Germany
0800-180-7686
Monday through Friday: 8:30am – 5:00pm
Email: support@hipstreet.com
We want you to start enjoying your product right away!
North America: 1 888 456 2426
UK: 0800 051 8330
Netherlands: 0800 404 0006
Germany: 0800 180 7686

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Has XFA                         : No
XMP Toolkit                     : Adobe XMP Core 5.6-c015 81.157285, 2014/12/12-00:43:15
Create Date                     : 2016:01:25 16:34:37-05:00
Metadata Date                   : 2016:03:31 10:06:10+08:00
Modify Date                     : 2016:03:31 10:06:10+08:00
Creator Tool                    : Adobe InDesign CS6 (Macintosh)
Instance ID                     : uuid:9d34d61e-46e9-4bba-af65-db1809011ddd
Original Document ID            : xmp.did:018011740720681188C6FE7713586538
Document ID                     : xmp.id:107C9BA607206811822AE937270180C8
Rendition Class                 : proof:pdf
Version ID                      : 1
Derived From Instance ID        : xmp.iid:FB7F117407206811822AE937270180C8
Derived From Document ID        : xmp.did:FB7F117407206811822AE937270180C8
Derived From Original Document ID: xmp.did:018011740720681188C6FE7713586538
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CS6 (Macintosh)
History Changed                 : /
History When                    : 2016:01:25 16:34:38-05:00
Format                          : application/pdf
Title                           : A16_006_10DTB44_Phantom2_QuickStartGuide_ENG.indd
Producer                        : Adobe PDF Library 10.0.1
Trapped                         : False
GTS PDFX Version                : PDF/X-1:2001
GTS PDFX Conformance            : PDF/X-1a:2001
Slug Checksum                   : 357745129
Slug Post Script Name           : DIN-Black
Slug Foundry                    : FontShop International
Slug Version                    : 001.000
Slug Outline File Size          : 0
Slug Family                     : DIN
Slug Font Sense 12 Checksum     : 357745129
Slug Font Kind                  : OpenType - PS
Slug Kerning Checksum           : 0
Page Count                      : 12
Creator                         : Adobe InDesign CS6 (Macintosh)

EXIF Metadata provided by EXIF.tools