Levante Panel Heater Instructions Rev 1x LPH

: Kogan Levante Lph Panel Heater Instructions Levante_LPH_Panel_Heater_Instructions usermanuals files

Open the PDF directly: View PDF .
Page Count: 8

www.noirot.com.au

Levanté

Electric Panel Heater

Model: LPH10

LPH15

LPH20

Operating & Installation

Instructions

Levanté International: 1 300 664 768 www.levanteinternational.com.au 2

RECOMMENDATION FOR WALL INSTALLATION

This heater is sold ready for DIY installation, with Wall bracket and flexible cord

supplied. Fit the wall bracket to the wall with suitable fixing method according to

the surface you mount the heater on (not included). Fit the rubber spacers as

shown in Fig. 1 and hang the heater on to the wall bracket.

The heater must not be located immediately below a socket outlet (as per

requirement of Clause 7.12 of AS/NZS 60335.2.30).

LEGEND

1. Heating air outlet

2. Front panel

3. Thermostat dial

4. Control box air outlet

5. On/Off dial

6. Rear panel

7. Castors (optional)

8. Air Inlet

9. Rubber spacer

10. Control box air inlet

11. Control box

12. Wall mounting bracket

SPECIFICATIONS:

Model Power (W) Current (A) Height Width

LPH10 600/1000 2.5/4.2 420 440

LPH15 900/1500 3.8/6.3 420 610

LPH20 1200/2000 5.0/8.3 420 760

Fig. 1

1 2 3 4 5 6

12

11

10

9

8

7

Levanté International: 1 300 664 768 www.levanteinternational.com.au 3

Please note:

Heater temperature settings will vary from house to house according to the

building type and its level of insulation. They will also vary from room to room,

depending on factors such as room orientation (facing north or south) and window

sizes. Items such as computers and lights (which generate heat) and people will

also affect a room’s temperature.

Running costs are not wholly governed by the temperature setting on the panel

heater. The same maximum power is used to reach 10° or 30°. Where the

energy efficiency and economy is obtained is in the sizing of the heater to the

particular room where it is to be used. If the heater is sized correctly, then the

thermostat will cycle on & off as required to maintain your comfort level, no matter

where on the scale your comfort setting is.

RECOMMENDATION FOR USE WITH CASTORS

This heater is tested and approved for use with the optional castors. To fit the

castors to the heater, complete the following:

1. Turn the heater upside down

2. Position the castors over the plates located at either end of the heater

3. Fix the castors in place using the screws provided

This heater is fitted with a Tip-over cut-out switch. If the heater falls over is tipped

upside down, the power will be cut to the element. To restore power to the

element and continue using your heater, stand it back on its castors. The Tip-

over cut-out switch will automatically reset itself.

WARNING:

Do not use the heater on the floor without the castors. Also, when using as a

portable heater do not use in the immediate vicinity of a bath, shower or

swimming pool.

Levanté International: 1 300 664 768 www.levanteinternational.com.au 4

PANEL LOCATIONS

This heater is suitable for use in all rooms including Zone 2 in Bathrooms (Fig.2)

in accordance with AS/NZS 3000: 2000 (Wiring Rules). However, it must be

located so that the controls cannot be touched by a person in the bath or

shower.

For maximum efficiency, this heater

should be wall mounted at a height of

150-200mm off the floor. This is to

allow the necessary volume of air to

flow freely through the vents. It is also

important to allow a minimum of

100mm clearance at the top and sides

of the heater and 500mm from the front

(Fig. 3) so as not to force the air back

into the heater and activate the Over

Temperature Safety Thermal Cut-Out

Switch.

Fig. 2

Fig. 3

Levanté International: 1 300 664 768 www.levanteinternational.com.au 5

ELECTRICAL CONNECTION

This heater is fitted with an Australian Approved Flexible Cord and Plug. For wall-

mounted installations connection can be either by plugging into an existing 10

amp power point (DIY) or direct wired by a Licensed Registered Electrical

Contractor, who is required to issue a Certificate of Electrical Safety.

PLEASE NOTE:

For safety reasons the Flexible Cord must not be modified or repaired in any way.

If the Cord is damaged, it must be replaced by a Noirot appointed and approved

service agent. If there are any concerns, contact Levanté International Pty Ltd on

1 300 664 768 before plugging it in.

IMPORTANT:

Do not plug in to a Power Board, Double Adaptor or Extension Lead.

IMPORTANT: DO NOT COVER THE HEATER

Avoid blocking air flow to and from the heater with clothing, open doors, furniture

and small toys or paper inserted into the louvres. This will cause the heater to

over-heat and activate the safety thermal cut-out switch.

If the “Over Temperature Safety Thermal Cut-Out Switch” is activated, the heater

will automatically switch off to limit the temperature to a safe value. To reset the

thermal cut-out, simply switch the heater off, unplug it from the power point and

remove the obstruction(s). Plug the heater back in and switch it on. The thermal

cut-out switch will reset after a few minutes and the heater will function normally.

USING YOUR HEATER FOR THE FIRST TIME

Remove the heater from its packaging (please dispose of packaging responsibly).

Contents should be as follows:

1. Heater

2. Wall bracket and rubber spacers

3. Instructions for installation and use (8 page booklet).

Ensure the heater is correctly mounted on the wall or fitted to the castors prior to

turning it on. Remove the white plastic protective covers from the plug pins and

insert the plug into the wall socket.

This heater is not intended for use by young children or infirm persons

unless they have been adequately supervised by a responsible person to

ensure that they can use the heater safely. Children should be supervised

to ensure that they don’t play with the appliance.

NOTE:

When the heater is turned on for the first time, or after it has been off for a long

period, such as during the summer months, you may experience a slight burning

smell. This is quite common and should disappear after a few minutes. If it

should persist, switch the heater off and have it inspected.

Levanté International: 1 300 664 768 www.levanteinternational.com.au 6

HOW TO USE THE THERMOSTAT

The Levanté thermostat is

designed to regulate the room

temperature. This offers

maximum economy, greater

efficiency and is very simple

to use.

1. Plug the heater into

the GPO and turn on

the GPO switch.

2. Turn the heater on by

rotating dial ‘A’ from

‘0’ to ‘2’

3. Rotate dial ‘B’ all the

way to ‘H’

4. Allow time for the room to heat up. This will vary with the size of the room

but usually takes 15-20mins. Once the room reaches your desired

temperature, rotate dial ‘B’ back until you hear a ‘CLICK’

5. To achieve your comfort level simply adjust the dial ‘B’ to suit. If you

require more heat turn the ‘B’ dial up to a larger DOT. If the room is too

hot then turn the dial ‘B’ to a smaller DOT.

6. To operate the heater at the reduced power level, simply rotate dial ‘A’ to

position ‘1’. If the heater does not maintain the room temperature at this

power level, rotate dial ‘A’ back to position ‘2’.

MAINTENANCE

Your Levanté Electric Panel Heater requires very little maintenance. To remove

surface dust use a soft cloth; to remove marks use a damp cloth. Never use

abrasives or metal scourers which could damage the powder coating. It is

recommended to periodically clean the inlet and outlet air vents using the soft

brush on your vacuum cleaner, as dense accumulation of dust will cause the

heater to over-heat and trigger the safety thermal cut-out switch.

0 1 2

•

•

AB

Levanté International: 1 300 664 768 www.levanteinternational.com.au 7

WARRANTY CLAIM:

IMPORTANT: To validate your product warranty, you must keep your panel

heater receipt as proof of purchase and provide it with the heater when making a

warranty claim.

WARRANTY CONDITIONS

Your Levanté electric panel heater comes with a 2 YEAR WARRANTY. Any

replacement of faulty parts or repairs of any kind must be carried out by a

qualified person and authorised by Levanté International Pty Ltd or their approved

representative. Failure to do so will VOID the WARRANTY.

Levanté International Pty. Ltd. reserve the right to reject any warranty claim

deemed to be false. Retailers must have warranty claims authorised by a

representative of Levanté International.

If you believe your product to be faulty and under warranty you are required to do

the following:

1. Return the product, at your expense, to the place of purchase for

assessment by an authorised representative of Levanté International.

2. This may require leaving the product at the place of purchase.

3. If the product is deemed faulty and under warranty, the place of purchase

of the product will order a replacement heater to which Levanté

International, at our cost, will deliver the heater to the place of purchase.

4. The consumer will then be required, at their cost, to pick up the

replacement heater from the place of purchase.

5. If the heater is faulty but not deemed to be under warranty, an

explanation will be provided to the consumer and that the faulty heater

can be picked up by the customer from the place of purchase.

Our goods come with guarantees that cannot be excluded under the Australian

Consumer Law. You are entitled to a replacement or refund for a major failure

and for compensation for any other reasonably foreseeable loss or damage. You

are also entitled to have the goods repaired or replaced if the goods fail to be of

acceptable quality and the failure does not amount to a major failure.

If you have any queries regarding your product or its warranty please contact:

Levanté International Pty Ltd

80-84 Burlington St

Oakleigh VIC 3166

P: 1 300 664 768

E: sales@levanteinternational.com.au

Levanté International: 1 300 664 768 www.levanteinternational.com.au 8