LANYA ELECTRONIC EM529 BLUETOOTH STEREO HEADSET User Manual
LANYA ELECTRONIC CO., Ltd. BLUETOOTH STEREO HEADSET Users Manual
Users Manual
EM529 User’s Manual
User’s Manual ：
1．To switch on.when EM529 is in off state. Until the blue indicator light
turns on and flashes 3 times.
2．To switch off.when EM529 is in on state. Until the red indicator light
turns off and flashes 3 times.
3．Pair the headset with a compatible phone
The headset must be powered on before you begin to initiate the paring .
Press and hold the answer/end key for 7 seconds until blue and red light
flashes alternately. The headset is now in paring mode.
Activate the Bluetooth feature on the phone. And set the phone to search
for Bluetooth devices .Check the user guide of your phone for
instructions.
Select the headset(EM529) from the list of found devices .
When asked the PIN code,Please enter”0000” to pair and connect the
headset to your phone.In some phones you may need to make the
connection separately after pairing .See the user guide of your phone for
details.
4．Answer a call
When there is coming call.press the answer/end key. Or use the phone
key to answer the call.
5．End a call
After finishing the call .press the answer/end key .or use the phone key to
end the call .
6．Refuse a call
When there is a coming call,Press and hold the answer/end key for 3
seconds until you can hear beep sound from the headset.
7．Voice dialing
It is possible to make a call directly from the headset using voice
recognition. Press and hold the answer/end key for 3 seconds until you
can hear beep sound from the headset.(To use this voice dialing
function ,your mobile phone must provide this option and corresponding
voice samples must have been recorded.)
8．Redial
Double press the answer/end key and you can hear beep sound from
headset. Release the answer/end key and the headset will dial the last
dialed telephone number .
9．Play/pause music
In idle state. Press answer/end key one time to play or pause music .
10．Adjust the earphone volume
Press the volume+ key to increase or – to decrease the volume during a
call or listening to music.
11．Previous/Next song
When playing music .press and hold volume + for 3 seconds to play
previous song or volume- to play next song.
12．Mute
In the call status. Press volume+ and volume – at the same time until
there is beep sound from headset. You can open or close the MIC of
headset.
Led Indication
⑴In idle state after paired :flashes 1 time every 5 seconds
⑵In coming call: blue light flashes
⑶Low battery: flashes 3 times every 30 seconds and there is beep sound
⑷Charging: red light keeps on
⑸Switch on : blue light flashes 3 times
⑹Switch off :red light flashes 3 times
⑺Pairing state: red and blue light flashes alternately
Troubleshooting
If you cannot connect the headset to your phone, do as follows:
· Ensure that the headset is charged, switched on, paired with and
connected to your phone.
· Ensure that the Bluetooth feature is activated on your phone.
· Check that the headset is within 10 meter(30 feet ) of your phone
and that there are no obstructions between the headset and the phone,
such as walls or other electronic devices.
Battery information
Your device is powered by a rechargeable battery. The full
performance of a new battery is achieved only after two or three
complete charge and discharge cycles. The battery can be charged
and discharged hundreds of times, but it will eventually wear out.
Recharge your battery only with compatible chargers designated for
this device.
Unplug the charger from the electrical plug and the device when not
in use. Do not leave a fully charged battery connected to a charger,
since overcharging may shorten its lifetime. If left unused, a fully
charged battery will lose its charge over time.
Never use any charger that is damaged.
Leaving the device in hot or cold places, such as in a closed car in
summer or winter conditions, will reduce the capacity and lifetime of
the battery. Always try to keep the battery between 15℃ and 25℃
(59℉ and 77℉). A device with a hot or cold battery may not work
temporarily, even when the battery is fully charged. Battery
performance is particularly limited in temperatures well below
freezing.
Do not dispose of batteries in a fire as they may explode. Batteries
may also explode if damaged. Dispose of batteries according to local
regulations. Please recycle when possible. Do not dispose as
household waste.
FCC Information
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received; including interference that may cause undesired operation.
Federal Communications Commission (FCC) Statement
This Equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user authority to operate the
equipment.
Tested to comply with FCC standard. FOR HOME OR OFFICE USE.
Warning :
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. & This device and its antenna(s) must not be
co-located or conjunction with any other antenna or transmitter.