LEADER INNOVATIONS 98925 ECONOMY WIRELESS EARBUDS User Manual
LEADER INNOVATIONS LTD. ECONOMY WIRELESS EARBUDS
User manual
SIZE: 85X112 mm
1: The distance between the smartphone and the headset should be 30 feet.
2: Press and hold the key for about 5 seconds and release it when the red and
blue LEDs alternate. At this point the headset has entered the pairing mode.
3: Enable the Bluetooth function on the smartphone & search for a new connection.
Select "Wireless Earbuds" to pair. After the connection is successful the
blue LED of the headset will blink slowly.
Volume Up, Volume Down,
Pairing and Connection:
/Headphone
/Speaker size:
/Sensitivity:
/Impedance:
/Frequency Response:
/Cord Length:
10mm
96dB±3dB(at 1KHz 0.5vRMS)
16Ω
20-20000hz
≤70CM
/Dimensions:
/Sensitivity:
/Frequency Response:
/Directivity:
4*1.5MM
-42dB+/-3dB
30-16000HZ
Omnidirectional
Microphone
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.
Universal Switch Telephone Answering key
FCC ID:2ADW3-98925
MADE IN CHINA