LG Electronics USA 9CM2315VD2 Zigbee Lighting Module User Manual 1
LG Electronics USA Zigbee Lighting Module 1
User manual
User Manual 9CM2315VD1
1. Installation to Product
1.1 Lighting product
①Prepare the LED Lighting Product and Module.
1page
This device is for LG Electronics lighting products only.
FCC ID : BEJ9CM2315VD2
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions : (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This transmitter must not co-located or operated in conjunction with any other
antenna or transmitter.
FCC Statement
“Equipment used at position in which the spaces between human body and
antenna exceeded 20cm”
②Insert the modue to LED Lighting Product to be right direction for the
LG Logo.
③Check if the indicator LED is on or off when power is on.
User Manual 9CM2315VD1 1page
Warning
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.