LG Electronics USA LGSWFAC73 RF Module User Manual

LG Electronics USA RF Module

User Manual

User ManualPRODUCT NAME : RF ModuleMODEL NAME : TWCM-B303D(LGSWFAC73)(00)-0073The information contained herein is the exclusive property of LG Innotekand shall not be distributed, reproduced or disclosed in whole or no in partwithout prior written permission of LG Innotek.
User ManualPAGE :DOCUMENT No :REG. DATE : 2016.06.20MODEL NAME: TWCM-B303D(LGIT)LGSWFAC73 (LGE)REV. DATE : 2016.06.20REV.NO : v1.0-Copyrightⓒ. 2016. All Rights Reserved.1 / 11IndexNo Description Page1 Features 22 Picture of Product 23 Installation Manual 34 Block Diagram 45 Absolute Maximum Ratings 46 Operating Conditions 57 Standard Test Conditions 58 Pin Description 6 9 Out Drawing 7 10 Packing Information 811Regulatory Notices 10
User ManualPAGE :DOCUMENT No :REG. DATE : 2016.06.20MODEL NAME: TWCM-B303D(LGIT)LGSWFAC73 (LGE)REV. DATE : 2016.06.20REV.NO : v1.0-Copyrightⓒ. 2016. All Rights Reserved.2 / 112. Picture of Product1. FeaturesTWCM-B303D is the small size and low power module for IEEE 802.11ac wireless LAN. TWCM-B303D is based on Broadcom BCM43569 solution.IEEE 802.11 a/b/g/n/ac Dual Band WLAN infrastructureSize : 68.0mm x 38.0mmTwo stream spatial multiplexing up to 300Mbps(802.11n)/ 867Mbps(802.11ac)FPCB wireless Antenna for WLANUse on-chip OTP (One-Time Programmable)Host Interface : USB2.0Security : WAPI, WEP, WPA, WPA2, WMM, AES, WEP, TKIP, CKPApplication: DTV, DVR, HD DVD Player, Blue-ray Disk Player, STB, Monitor*BT was disabled by S/W.
User ManualPAGE :DOCUMENT No :REG. DATE : 2016.06.20MODEL NAME: TWCM-B303D(LGIT)LGSWFAC73 (LGE)REV. DATE : 2016.06.20REV.NO : v1.0-Copyrightⓒ. 2016. All Rights Reserved.3 / 113. Installation ManualTWCM-B303D installed positionMonitor Rear Panel
User ManualPAGE :DOCUMENT No :REG. DATE : 2016.06.20MODEL NAME: TWCM-B303D(LGIT)LGSWFAC73 (LGE)REV. DATE : 2016.06.20REV.NO : v1.0-Copyrightⓒ. 2016. All Rights Reserved.4 / 114. Block Diagram3.3V802.11ac MACMain Clock(40MHz)ANT12 x 2Radio 802.11acPHY SecurityOTPInternal BusGPIOWLANUSB 2.0 BCM43569Connector5GSPDT2GSPDT5GSPDT2GSPDTDiplexerANT0DiplexerSerial Flash (1M)USB HUBUSB Hub Clock_(24MHz)5. Absolute Maximum RatingsParameter Min Max UnitStorage Temperature -20 +80 ℃Storage Humidity (40℃)- 90 %Caution : The specifications in Table 1 define levels at which permanent damage to thedevice can occur. Function operation is not guaranteed under these conditions.Operating at absolute maximum conditions for extend periods can adversely affect thelong-term reliability of the device.. Other conditions1) Do not use or store modules in the corrosive atmosphere, especially where chloridegas, sulfide gas, acid, alkali, salt or the like are contained.Also, avoid exposure to moisture.2) Store the modules where the temperatureand relative humidity do not exceed 5 to 40℃and 20 to 60%.3) Assemble the modules within 6 months.Check the soldering ability in case of 6 months over.
User ManualPAGE :DOCUMENT No :REG. DATE : 2016.06.20MODEL NAME: TWCM-B303D(LGIT)LGSWFAC73 (LGE)REV. DATE : 2016.06.20REV.NO : v1.0-Copyrightⓒ. 2016. All Rights Reserved.5 / 116. Operating ConditionsParameter Min Typ Max UnitAmbient Temperature 0 - 60 ℃Ambient Humidity (40℃)- - 85 %Supply Voltage 4.75 5.0 5.25 Vdc7. Standard Test ConditionsThe Test for electrical specification shall be performed under the following conditionOtherwise this following conditions, not guaranteed this performance.Temparature 25 ±5℃Humidity 65 ±5%Input Voltage Supply VoltageVDD_3.3V +3.3V ±0.165V7-1. Ambient condition7-2. Power supply voltages
User ManualPAGE :DOCUMENT No :REG. DATE : 2016.06.20MODEL NAME: TWCM-B303D(LGIT)LGSWFAC73 (LGE)REV. DATE : 2016.06.20REV.NO : v1.0-Copyrightⓒ. 2016. All Rights Reserved.6 / 118. Pin DescriptionPin No. Pin Name I/O Pin Description1 GND - Ground2 BT_REG_ON - BT Regulator ON3 3D_Sync - 3D_Sync4 WL_HOST_WAKE - Wake On WLAN5 GND - Ground6 USB D+ I/O USB Communication signal USB D+7 USB D- I/O USB Communication signal USB D-8 VCC I VDD 3.3V
User ManualPAGE :DOCUMENT No :REG. DATE : 2016.06.20MODEL NAME: TWCM-B303D(LGIT)LGSWFAC73 (LGE)REV. DATE : 2016.06.20REV.NO : v1.0-Copyrightⓒ. 2016. All Rights Reserved.7 / 119. Outline DrawingTWCM-B303D
User ManualPAGE :DOCUMENT No :REG. DATE : 2016.06.20MODEL NAME: TWCM-B303D(LGIT)LGSWFAC73 (LGE)REV. DATE : 2016.06.20REV.NO : v1.0-Copyrightⓒ. 2016. All Rights Reserved.8 / 1110. Packing Information
User ManualPAGE :DOCUMENT No :REG. DATE : 2016.06.20MODEL NAME: TWCM-B303D(LGIT)LGSWFAC73 (LGE)REV. DATE : 2016.06.20REV.NO : v1.0-Copyrightⓒ. 2016. All Rights Reserved.9 / 11TWCM-B303D
User ManualPAGE :DOCUMENT No :REG. DATE : 2016.06.20MODEL NAME: TWCM-B303D(LGIT)LGSWFAC73 (LGE)REV. DATE : 2016.06.20REV.NO : v1.0-Copyrightⓒ. 2016. All Rights Reserved.Regulatory Notices1. FCCFCC Part 15.19 Statements:This device complies with Part 15 of the FCC Rules. Operation is subject to the following twoconditions: (1) this device may not cause harmful interference, and (2) this device must accept anyinterference received, including interference that may cause undesired operation.FCC Part 15.21 statementAny changes or modifications not expressly approved by the party responsible for compliance couldvoid the user's authority to operate this equipment.FCC Part 15.105 statement This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energy and,if not installed and used in accordance with the instructions, may cause harmful interference toradio communications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged to try to correctthe interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiveris connected.Consult the dealer or an experienced radio/TV technician for help.OEM Responsibilities to comply with FCC and Industry Canada RegulationsThe module has been certified for integration into products only by OEM integrators under thefollowing condition:- The antenna(s) must be installed such that a minimum separation distance of at least 20 cm is maintained between the radiator (antenna) and all persons at all times.- The transmitter module must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures.-This device is restricted to indoor use only within the 5.15 ~ 5.25GHz Band.As long as the two condition above is met, further transmitter testing will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.). End Product Labeling The module is labeled with its own FCC ID and IC Certification Number. If the FCC ID and IC Certification Number are not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. In that case, the final end product must be labeled in a visible area with the following:“Contains FCC ID: BEJLGSWFAC73 “Contains IC: 2703H-LGSWFAC7310 / 11
User ManualPAGE :DOCUMENT No :REG. DATE : 2016.06.20MODEL NAME: TWCM-B303D(LGIT)LGSWFAC73 (LGE)REV. DATE : 2016.06.20REV.NO : v1.0-Copyrightⓒ. 2016. All Rights Reserved.2. ICRSS-GEN, Sec. 7.1.3 – (licence-exempt radio apparatus) This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.RF ExposureThe antenna (or antennas) must be installed so as to maintain at all times a distance minimum ofat least 20 cm between the radiation source (antenna) and any individual. This device may not be installed or used in conjunction with any other antenna or transmitter.This device is restricted to indoor use only within the 5.15 ~ 5.25GHz Band.l'exposition aux RFL’antenne (ou les antennes) doit être installée de façon à maintenir à tout instant une distance minimum de au moins 20 cm entre la source de radiation (l’antenne) et toute personne physique.Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate thisequipment.Attention:Les changements ou modifications de cet appareil non expressément approuvé par le fabricant peuvent annuler votre droit à utiliser cet équipement.Étiquetage du produit final (IC) Le module est étiqueté avec sa propre identification FCC et son propre numéro de certification IC. Si l’identification FCC et le numéro de certification IC ne sont pas visibles lorsquele module est installé à l’intérieur d’un autre dispositif, la partie externe du dispositif dans lequelle module est installé devra également présenter une étiquette faisant référence au module inclus. Dans ce cas, le produit final devra être étiqueté sur une zone visible avec les informations suivantes :« Contient module émetteur identification FCC ID : BEJLGSWFAC73 « Contient module émetteur IC : 2703H-LGSWFAC73”3. CEHereby, ' LG Electronics USA, Inc.' declares that this LGSWFAC73 is in compliance with the essential requirements and other relevant provisions of directive 1999/5/EC.11 / 11

Navigation menu