LG Electronics USA M17 LTE Modem User Manual M17
LG Electronics USA LTE Modem M17
Users Manual
M17 Device description Version 0.1 – Aug 26th 2009 Part 15.21 statement " Change or Modifications that are not expressly approved by the manufacturer could void the user's authority to operate the equipment. “ Part 15.105 statement This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Part 15 Class B Compliance This device and its accessories comply with part15 of FCC rules. Operation is subject to the following two conditions: (1) This device & its accessories may not cause harmful interference. (2) This device & its accessories must accept any interference received, including interference that may cause undesired operation. 1.1 Feature Copyright Copyright © 2009 LG Electronics I nc. All Rights Reserved. Though every care has been taken to ensure the accuracy of this document, LG Electronics I nc. cannot accept responsibility for any errors or omissions or for any loss occurred to any person, whether legal or natural, from acting, or refraining from action, as a result of the information contained herein. I nformation in this document is subject to change at any time without obligation to notify any person of such changes. LG Electronics I nc. may have patents or patent pending applications, trademarks copyrights or other intellectual property rights covering subject matter in this document. The furnishing of this document does not give the recipient or reader any license to these patents, trademarks copyrights or other intellectual property rights. No part of this document may be communicated, distributed, reproduced or transmitted in any form or by any means, electronic or mechanical or otherwise, for any purpose, without the prior written permission of LG Electronics I nc. The document is subject to revision without further notice. All brand names and product names mentioned in this document are trademarks or registered trademarks of their respective owners. 1.1. Feature Caution To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm (8 inches) between the equipment and the body must be maintained. M4 < UE> < User> At least 20 cm (8 inches) 1.1 Feature About This Document Revision History Version Date 0.1 2009-04-07 References Comment I nitial Draft Author Sang Ha Park 1.1. Feature Contents General Description .........................................................................................6 1.1 Mechanical description ................................................................................10 2.1 Feature ................................................................................................................................................7 Dimension .........................................................................................................................................11 Functional description ..................................................................................12 3.1 External connector description ......................................................................................................13 3.2 External RF connector description ................................................................................................14 3.3 Antenna description ........................................................................................................................15 3.4 External Power description .............................................................................................................16 3.5 Battery description ..........................................................................................................................17 1.1 Feature General Description 1.1. Feature 1.1 Feature This document describes briefly the board level operations, key features and the environment of the M17 Platform. The purpose of this platform is the verif ication of LG LTE ASI C, namely ‘L1000’, and the evaluation of LG UE system performance. The further details about the characteristics and functions of L1000 are available on other documents. < Table 1. M17 Device Feature> Specification L TE only Remark SW Date HW General Interface Spec. LTE External port USB 2.0 High Speed Micro USB 1 Port Standard(SW ver.) LTE 3GPP Rel. 8 (Dec. 2008) Band support LTE 3GPP Band 17 Main chipset LTE L1000 (by LGE) Max. Data rate LTE DL 50Mbps / UL 25Mbps (Category2) GPS Not Support Battery Support Transmitter Tx Diversity LTE Not support Max. Tx Power LTE 23 dBm Band Width LTE 10MHz UE Antenna Selection will not be supported At antenna port 1.1 Feature Receiver Modulation Method LTE Up to 16QAM Rx Diversity LTE Support MIMO L SW Interface System selection TE Band width LTE 10MHz Modulation Method LTE Up to 64QAM Interface protocol LTE USB USB Driver LTE Adaptive switching between downlink Transmit Diversity and SU MI MO Ethernet 3 Ports (Data, DM, Control) Downloading Tool Support Downloading tool for f ield upgrade through USB port DM (Diagnostic Monitor) Support LGE tool for LTE Prefered system selection Support 'LTE only' mode Support System LTE only PRL/PLMN List Authentication User Identity Module (IMSI) Identity Authentication LTE Support IPv4/6 dual IP stack DHCP L PLMN LTE Device LTE Not Numbering & Identities IP support 2x2 MIMO Support NAI based upon the IMSI 1 1digit MDN LTE Support for IPv4/6 (need to test with Network) TE N/A LTE Proxy mobile IPv4/6 1.1. Feature QoS LTE Support Active handoff QoS Idle handoff IRAT handoff N/A Non optimized handover N/A Non optimized handover IRAT measurement N/A Dimensions (W xD xH) 185 x 133.9 x 22.8 mm Weight 420g Mechani cal Mechanical Antenna Internal Antenna (MIMO) 2 Mechanical description 2.1. Dimension 2.1 Dimension M17 Mechanical dimension is 133.9 x 185 x 22.8mm. 2.1 Dimension Functional description 3.1. External connector description 3.1 External connector description LTE device has several external connectors. DC input jack connector: External Power source, 5V TA USB connector: USB Connect to Host (PC) SI M socket: for LTE Authentif ication 24Pin connector: For debug LTE Sub board HW Reset key DC input Jack USB cap SIM socket cap 24Pin connector for LTE Sub board debugging Earphone jack connector 3.2 External RF connector description 3.2 External RF connector description LTE MIMO ANT mobile SW LTE Main ANT mobile SW LTE device has 2 external RF connectors in order to measure wired RF performance characteristic. I t is conf igured that LTE RF front-end part is two external RF port; LTE main RF port and LTE MI MO RF port. I f you want to test wired LTE RF performance, you can use this external RF port(mobile switch). 3.3. Antenna description 3.3 Antenna description M4 Device LTE Antenna: MI MO Antenna Type: Carrier & PI FA Directive: Omni-directional LTE Band 7 Support: UL; 704~ 716(MHz), DL;734~ 746(MHz) Max power: 2W(Maximum) Primary Ant. : 1TX and 1RX Secondary Ant.: 1RX 3D Primary Antenna Gain: -2.00dBi(Average) 3D Secondary Antenna Gain: -2.40dBi(Average) 3.4 External Power description 3.4 External Pow er description To operate and charge the battery, plug the AC Adapter into a standard wall outlet and connect it to the LTE trial device via the DC input jack Connector. External power supply is DC input jack or TA. This power supply specif ication is below. Input Voltage & Current Output Voltage & Current 3.5. Battery description 3.5 Battery description Our LTE Trial device has a battery is used for operating LTE modem part. Battery Capacity for used in LTE is 2400mAh. I f the battery’s charge is completely run down, it takes 6 to 7 hours to fully recharge. But this battery capacity is not enough to operate LTE capability; you should external power supply, which is TA (Travel Adaptor). The mandatory power supply of the LTE UE is supplied by TA which is distributed by the LGE.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Encryption : Standard V4.4 (128-bit) User Access : Print, Print high-res Author : ddilboy Create Date : 2009:11:09 06:40:41Z Modify Date : 2010:01:05 08:25:33-05:00 XMP Toolkit : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04 Creator Tool : PScript5.dll Version 5.2 Metadata Date : 2010:01:05 08:25:33-05:00 Format : application/pdf Title : Microsoft Word - M17 User Manual.doc Creator : ddilboy Producer : Acrobat Distiller 8.1.0 (Windows) Document ID : uuid:e5ddf905-227d-4e43-a998-3db015e1e569 Instance ID : uuid:1b43914b-18b0-4e14-a24c-50222473139d Page Count : 19EXIF Metadata provided by EXIF.tools