LINKSYS HGA5S-1 Wireless-G Ethernet Bridge User Manual scan 1

LINKSYS LLC Wireless-G Ethernet Bridge scan 1

user manual

Federal Communication Commission Interference StatementThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference toradio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment doescause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouragedto try to correct the interference by one of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from thatto which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not causeharmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authorityto operate this equipment.IMPORTANT NOTE:FCC Radiation Exposure Statement:This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installedand operated with minimum distance 20cm between the radiator & your body.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.Linksys declared that WET54G V2 is limited in CH1~11 by specified firmware controlled in USA.INDUSTRY CANADA (CANADA)Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,including interference that may cause undesired operation of the device.This device has been designed to operate with an antenna having a maximum gain of [3] dB. Antenna having a higher gain is strictly prohibitedper regulations of Industry Canada. The required antenna impedance is [ 50] ohms.To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiatedpower (EIRP) is not more than that required for successful communication.To prevent radio interference to the licensed service, this device is intended to be operated indoors and away from windows to provide maximumshielding. Equipment (or its transmit antenna) that is installed outdoors issubject to licensing.

Navigation menu