LITE ON TECHNOLOGY MS27RF001 RF 27MHz MOUSE User Manual users manual
Lite-on Technology Corp. RF 27MHz MOUSE users manual
USERS MANUAL
User Manual
Battery Installation
Installs two AA batteries to transmitter and connected the
receiver with PC system, it’s ready for connection procedure.
Connection (ID Pairing) procedure
Procedure by steps
Step-1:Pressing channel button on the transmitter one time first ,
Step-2: Right away to press the channel button on the receiver at
second and they
Should be in connection between,
Step-3: Then go to the normal operate.
Note: preset in the production line as default setting before
delivery
ID change :
Same as the the procedure of “connection procedure”.
Channel and ID numbers
Channel: mouse (27.045mHz)
ID: There has a randomly 256 ID from for selection.
Note: The ID indication is to prevent from interfering each
other.
FEDERAL COMMUNICATIONS COMMISSION
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:(1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC Note.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection. This equipment generates, uses and can radiated
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The manufacturer is not responsible for any radio or TV Interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user's authority to operate the equipment.
The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.