LITE ON TECHNOLOGY WB410C BT USB DONGLE User Manual WB410C
LITE-ON Technology Corp. BT USB DONGLE WB410C
Users Manual
WB410C user manual
System：vista 32
一、device install
1.
Insert BT dongle to PC USB port
2. XP and vista system will install driver automatically
二
、
Transfer and receive File
1: Connect with PC
① Plug in BT dongle to PC1 and PC2
② Open BTW program -> add a Bluetooth device
③ select “my device is set up and ready to be found”, click “next”
④ dongle will search BT device
⑤ select computer name of PC2, click “next”
⑥ select don’t use a passkey, click “next”
⑦ PC1 successfully connected with PC2
2: Transfer file to a another PC or device
① Right Bluetooth icon and click “receive a file” on PC2
② Right Bluetooth icon and click “Send a file” on PC1
③ click “browse”
④
select computer name of PC2, click “OK”
⑤ click “next”
⑥ click “browse” and select any file ,then click “open”
⑦ click”next”
⑧ being sent file to PC2
⑨ successfully sent file to PC2
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this device
could void the user's authority to operate the equipment.
RF exposure warning ·
The equipment complies with FCC RF exposure limits set forth for an uncontrolled
environment.
The equipment must not be co-located or operating in conjunction with any other
antenna or transmitter.
Section 15.19 Labelling requirements.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.