Laerdal Medical AS 120-60750 QCPR Sensor with Bluetooth User Manual

Laerdal Medical AS QCPR Sensor with Bluetooth

User manual

Download: Laerdal Medical AS 120-60750 QCPR Sensor with Bluetooth User Manual
Mirror Download [FCC.gov]Laerdal Medical AS 120-60750 QCPR Sensor with Bluetooth User Manual
Document ID2787255
Application IDi0k02TxsWZhwBOjiMNPpjg==
Document DescriptionUser manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize30.97kB (387186 bits)
Date Submitted2015-10-20 00:00:00
Date Available2015-10-20 00:00:00
Creation Date2015-09-14 09:44:37
Producing SoftwareAdobe PDF Library 15.0
Document Lastmod2015-10-07 11:38:49
Document TitleUser manual
Document CreatorAdobe InDesign CC 2015 (Windows)

EN
Little Anne
QCPR Sensor
Important Product Information
English
Little Anne QCPR Sensor
Federal Communications Commission
Statement and Industry Canada Statements
Warnings and Cautions
A Warning states a condition, hazard, or unsafe practice
that can result in serious personal injury or death.
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
A Caution states a condition, hazard, or unsafe practice
that can result in minor personal injury or damage to
the manikin.
1. This device may not cause harmful interference
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Care, Maintenance and Cleaning
Clean with a dry cloth only.
Caution
Changes or modifications not expressly approved by
Laerdal Medical could void the user’s authority to operate
the equipment.
Caution
During use and assembly, do not touch the uncovered
section of circuit board.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
Battery
Consumer grade, non-rechargeable, carbon zinc or
alkaline batteries, LR6 1.5V AA only to be used.
Battery must be replaced with correct type.
Caution
Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to the
instructions.
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
technician for help.
Contains FCC ID: QHQ-120-60750
IC: 20263-12060750
Industry Canada ICES-003 Compliance:
CAN ICES-3 (B)/NMB-3(B)
Korea Certification:
MSIP-CMM-Lm1-120-60750
English
Little Anne QCPR Sensor
Symbol Glossary
Waste Handling
The Little Anne QCPR Sensor contains electronic
components. Dispose of it at the applicable recycling
facility in accordance with local regulations.
The manikin is CE marked in
accordance with Council Directive
1999/5/EC relating to Radio and
Telecommunications Terminal
Equipment (R&TTE), and Council
Directive 2011/65/EU on Restriction on
the use of certain hazardous substance
(RoHS).
European directive 2012/19/EU (WEEE)
WEEE: this appliance is marked according to the
European directive 2012/19/EU on Waste Electrical
and Electronic Equipment (WEEE). By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the environment
and human health, which could otherwise be caused
by inappropriate waste handling of this product.
Australian Radiocommunications and
EMC Compliance Mark
Manufacturer
The symbol on the product, or on the documents
accompanying the product, indicates that this appliance
may not be treated as household waste. Instead it shall
be handed over to the applicable collection point for
the recycling of electrial and electronic equipment.
Disposal must be carried out in accordance with local
environmental regulations for waste disposal. For more
detailed information about treatment, recovery and
recycling of this product, please contact your local
city office, your household waste disposal service or
the Laerdal representative where you purchased the
product.
Dispose of in accordance with your
country’s recommendations
Reference Order Number
LOT Number
FCC Declaration of Conformity label
KC (Korea Certification)
certification mark
Warranty
Refer to the Laerdal Global Warranty for terms and
conditions. For more information visit www.laerdal.com
Do not touch
Specifications
Operating
temperature
15°C to 30°C
(59 °F to 86 °F)
Storage
temperature
-10 °C to 50 °C
(14 °F to 122 °F)
Humidity
5% - 95% relative humidity
Weight
200 g (0.44 lbs)
Dimensions
165 x 220 x 55 mm
(6.5 x 8.7 x 2.2 in)
Manufactured in China for:
Laerdal Medical AS
P.O. Box 377
Tanke Svilandsgate 30, 4002 Stavanger, Norway
T: (+47) 51 51 17 00
Printed in China
www.laerdal.com
20-08939 Rev C
© 2015 Laerdal Medical AS. All rights reserved.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Create Date                     : 2015:09:14 09:44:37+02:00
Creator                         : Adobe InDesign CC 2015 (Windows)
Modify Date                     : 2015:10:07 11:38:49+02:00
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03
Metadata Date                   : 2015:10:07 11:38:49+02:00
Creator Tool                    : Adobe InDesign CC 2015 (Windows)
Instance ID                     : uuid:fda37797-e300-45ea-911e-9b32f2448eb0
Original Document ID            : xmp.did:07e72b36-ece6-854d-aab4-4ae2825af4c5
Document ID                     : xmp.id:73b640d9-82fe-504f-b7e1-6fd16d82eb37
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:c7fdd1a1-7d01-1a48-9e45-d9f346b1c20f
Derived From Document ID        : xmp.did:c8264dc9-5567-784b-b30f-bf19c54e8fe2
Derived From Original Document ID: xmp.did:07e72b36-ece6-854d-aab4-4ae2825af4c5
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CC 2015 (Windows)
History Changed                 : /
History When                    : 2015:09:14 09:44:37+02:00
Format                          : application/pdf
Producer                        : Adobe PDF Library 15.0
Trapped                         : False
Page Count                      : 4
EXIF Metadata provided by EXIF.tools
FCC ID Filing: QHQ-120-60750

Navigation menu