Lantronix Device Server Mss 485 Users Manual NET485 User

2015-02-09

• NET485 Overview
  • Overview
  • Overview of RS422 / RS485
    • The RS485 Enable Signal
    • NET485 Wiring
  • RS422 / RS485 Network connections
    • RS422 Networks
    • RS485 Networks
• Introduction
  • Protocol Support
  • Serial RS422/485 Interface
  • Power Supply
  • Ethernet Interface
  • Product CD
  • Additional Documentation
  • Technical Specifications
• Device Installer
  • Microsoft NET Framework
    • RUN Device Installer
    • Device Found
    • Assign IP
    • Assignment
  • Using Device Installer
    • Viewing the Current Configuration
  • Configuration Using Web Manager
    • Accessing XPort Using Device Installer
  • Network Configuration
    • Automatic IP Address Configuration
    • Static IP Address Configuration
    • Ethernet Configuration
  • Server Configuration
  • Host List Configuration
  • Channel 1 Configuration
    • Connection Settings - TCP
    • Connection Settings - UDP
  • Email Settings
    • Trigger Configuration
  • Configurable Pin Settings
  • Apply Settings
  • Apply Factory Defaults
  • Configuration Using Telnet
    • Telnet Connection
    • Telnet Messages
  • Server Configuration (Option 0 Network Configuration)
    • IP Address
    • Set Gateway IP Address
    • Netmask: Number of Bits for Host Part
    • Change Telnet configuration password
    • DHCP Naming
  • Channel 1 Configuration (Serial Port Parameters)
    • Baudrate
    • I/F (Interface) Mode
    • Flow
    • Port Number
    • Connect Mode
    • Send the Escape Sequence (+++) in Modem Mode
    • Auto Increment Source Port
    • Remote IP Address
    • Remote Port
    • DisConnMode
    • Flush Mode (Buffer Flushing)
    • Pack Control
    • DisConnTime (Inactivity Timeout)
    • Send Characters
    • Telnet Terminal Type
    • Channel (Port) Password
  • E-mail Settings
    • E-mail Setup
    • Trigger Setup
  • Expert Settings
    • TCP Keepalive time in seconds
    • ARP Cache timeout in seconds
    • Enable High Performance
    • Disable Monitor Mode at Bootup
    • RS-485 TX Enable Active Level
    • HTTP Port Number
    • SMTP Port Number
    • MTU Size
    • Enable Alternate MAC
    • Ethernet Connection Type
  • Security Settings
    • Disable SNMP
    • SNMP Community Name
    • Disable Telnet Setup
    • Disable TFTP Firmware Upgrade
    • Disable Port 77FE (Hex)
    • Disable Web Server
    • Disable Web Setup
    • Disable ECHO Ports
    • Enable Encryption
    • Enable Enhanced Password
    • Disable Port 77F0 (Hex)
  • Defaults
  • Exit Configuration Mode
• Monitoring the Network
  • Entering Monitor Mode via the Network Port
    • Monitor Mode Commands
• Updating Firmware
  • Obtaining Firmware
    • Reloading Firmware
    • Via Device Installer
• Troubleshooting
  • Problems and Error Messages
• Binary to Hex Conversion
  • Conversion Table
    • Scientific Calculator