Lemobile Information Technology LEX522 Mobile Phone User Manual X2 20160411

Lemobile Information Technology (Beijing) Co., Ltd Mobile Phone X2 20160411

Contents

TempConfidential_2AFWMLEX522_User manual R3

X2 北美版说明书V1.0武蓉潘林 韩光明王成森吴常春王少维2016.04.11X2说明书-裕同206200002751Size: 254*127.5mm，成品尺寸： 63.5*127.5mm Material: 80g 哑面铜版纸 Craft: 牙刀 圆角模切，折页，压线 Color mark: 4c+4cLe Max2Le X522 Quick Start GuideSIM card slotFront cameraInfrared sensorNotification LEDVolumePowerHomeBackMenuUSB type-C port(Charging, headset interface)Insert the pin into the pinholeInsert SIM card trayEject SIM card traySIM Card InstallationEject SIM card trayInsert SIM card eject pinInstall SIM card(s) Insert SIM card trayUse SIM card eject pin to remove the card tray. Only standard Nano SIM is supported. Inserting a modified card may damage the card slot.Dual SIM Dual Standby：While one SIM c a rd is using 4G/3G/2G services, the other uses 2G(GSM) voice call only.Place the SIM card on the card tray with the m etal s ide facing downwards. Insert the card tray back into the slot until it is locked in place.before ejecting the card tray to avoid possible damages to your device. Account ActivationLeEco, you need to register or log in to a LeEco account.Register a LeEco Account:Navigate to My LeEco > Log in to LeEco account > Register to create a new LeEco account and set the password. Once activated, you can sign in with the account.Log in to Your LeEco Account:Navigate to My LeEco > Log in to LeEco account > Login, and then enter your account name and pass-word to log in.3This mobile phone meets the government’ s requirements for exposure to radio waves.This phone is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Govern-ment. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for SAR are conducted using standard operating positions accepted by the FCC with the phone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the poser required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output.The highest SAR value for the model phone as reported to the FCC when tested for use at the ear is 1.19/kg and when worn on the body, as described in this user guide, is 1.10 /kgdepending upon available accessories and FCC requirements.)various phones and at various positions, they all meet the government requirement.-The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after search ing on FCC ID: 2AFWMLEX522.For body worn operation, this phone has been tested and meets the FCC RF exposure guidelines for use with an accessory that contains no metal and the positions the handset a minimum of 1 cm from the body. Use of other accessories may not ensure compliance with FCC RF exposure guidelines. If you do no t use a body-worn accessory and are not holding the phone at the ear, position the handset a minimum of 1 cm from your body when the phone is switched on.4RF Exposure Information (SAR)Charger safety Charger should be used near the device and shall be easily accessible. Users have to use the connection to USB interfaces with USB 2.0 version or higher. Battery safetyCaution: Risk of explosion if battery replaced by an incorrect type. Dispose of used batteries as instructed. Operating environmentPlease make sure the environment temperature for charger and device will not be higher than 35℃Safety InformationI'm not just a phone,but an integrated Internet ecosystemFCC 1g SAR Limit（1.6 W/kg） Head：1.19/kg（1g）Body ：1.10/kg（1g）HAC: M4/T321Le 2 Quick Start GuideThis mobile phone complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.This mobile phone has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa-tion. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interfer-ence will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, the user is encouraged to try to correct the interference by one or more of the following measures:-Reorient or relocate the receiving antenna.-Increase the separation between the equipment and receiver.that to which the receiver is connected.-Consult the dealer or an experienced radio/TV technician for help.FCC Caution:Any Changes or modifications not expressly approved by the party responsible for compliance could void the user ‘s authority to operate the equipment.The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmit-ter.Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.The declaration of conformity may be consult at：Manufacture Name：Lemobile Information Technology (Beijing) Co., LtdManufacture Address：WENHUAYING NORTH (No.1, LINKONG 2nd St)， GAOLIYING， SHUNYI DISTRICT，BEIJING5FCC Regulations6Hearing Aid Compatibility (HAC) regulations for Mobile phonesISED NoticeThis device complies with Innovation, Science and Economic Development Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux CNR Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'enThis Class B digital apparatus complies with Canadian ICES-003 Issue 6.Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.IC: 21242-LEX522ISED Radiation Exposure StatementThis EUT is compliance with SAR for general population/uncontrolled exposurelimits in IC RSS-102 Issue 5 and had been tested in accordance with the measurementmethods and procedures specified in IEEE 1528:2013 and IEC 62209-2:2010. This equipmentshould be installed and operated with minimum distance 1.0 cm between theradiator and your body. This device and its antenna(s) must not be co-located oroperating in conjunction with any other antenna or transmitter.Cet appareil est conforme aux limites d'exposition DAS incontrôlée pour la populationgénérale de la norme CNR-102 Issue 5d'Industrie Canada et a été testé en conformité avecles méthodes de mesure et procédures spécifiées dans IEEE 1528:2013 et IEC 62209-2:2010.Cet appareil doit être installé et utilisé avec une distance minimale de 1.0 cm entrel’émetteur et votre corps. Cet appareil et sa ou ses antennes ne doivent pas êtreco-localisés ou fonctionner en conjonction avec tout autre antenne ou transmetteur.The device is going on be operated in 5150MHz-5250MHz frequency range. It is restricted indoor environment only.e dispositif va être exploité dans 5150mhz-5250mhz fréquence.c'est limitée environnement intérieur seulement.In 2003, the FCC adopted rules to make digital wireless telephones compatible with hearing aids and cochlear implants. Although analog wireless phones do not usually cause interference with hearing aids or cochlear implants, digital wireless phones sometimes do because of electromagnetic energy emitted by the phone's antenna, backlight, or other components. Your phone is compliant with FCC HAC regulations (ANSI C63.19- 2011). While some wireless phones are used near some hearing devices (hearing aids and cochlear implants), users may detect a buzzing, humming, or whining noise. Some hearing devices are more immune than others to this interference noise and phones also vary in the amount of interference they generate. The wireless telephone industry has developed a rating system for wireless phones to assist hearing device users in finding phones that may be compatible with their hearing devices. Not all phones have been rated. Phones that are rated have the rating on their box or a label located on the box. The ratings are not guarantees. Results will vary depending on the user's hearing device and hearing loss. If your hearing device happens to be vulnerable to interference, you may not be able to use a rated phone successfully. Trying out the phone with your hearing device is the best way to evaluate it for your personal needs.This phone has been tested and rated for use with hearing aids for some of the wireless technologies that it uses. However, there may be some newer wireless technologies used in this phone that have not been tested yet for use with hearing aids. It is important to try the dierent features of this phone thoroughly and in dierent locations, using your hearing aid or cochlear implant, to determine if you hear any interfering noise. Consult your service provider or the manufacturer of this phone for information on hearing aid compatibility. If you have questions about return or exchange policies, consult your service provider or phone retailer.M-Ratings: Phones rated M3 or M4 meet FCC requirements and are likely to generate less interference to hearing devices than phones that are not labeled. M4 is the better/higher of the two ratings. T-Ratings: Phones rated T3 or T4 meet FCC requirements and are likely to be more usable with a hearing device’s telecoil (“T Switch” or “Telephone Switch”) than unrated phones. T4 is the better/ higher of the two ratings. (Note that not all hearing devices have telecoils in them.) Your phone meets the M4/T3 level rating.Hearing devices may also be rated. Your hearing device manufacturer or hearing health professional may help you find this rating. For more information about FCC Hearing Aid Compatibility, please go to http://www.f-cc.gov/cgb/dro.FCC ID: 2AFWMLEX522 IC: 21242-LEX522

Navigation menu