Lenbrook PSBVS21 PSB Speakers Powered Sounbar User Manual Safety Pages

Lenbrook Industries Limited PSB Speakers Powered Sounbar Safety Pages

User Manual

Download: Lenbrook PSBVS21 PSB Speakers Powered Sounbar User Manual Safety Pages
Mirror Download [FCC.gov]Lenbrook PSBVS21 PSB Speakers Powered Sounbar User Manual Safety Pages
Document ID2427160
Application IDtFfbMGlvVAe58u52NWB0AA==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize100.92kB (1261519 bits)
Date Submitted2014-10-26 00:00:00
Date Available2014-10-27 00:00:00
Creation Date2014-09-18 10:56:57
Producing SoftwareCorel PDF Engine Version 16.4.1.1281
Document Lastmod2014-09-19 11:02:59
Document TitleSafety Pages.cdr
Document CreatorCorelDRAW X6
Document Author: Rob Nicholls

133 mm
267 mm
SEE OWNERS MANUAL FOR DETAILED WIRING OPTIONS
www.psbspeakers.com
Analog
Coaxial
INPUT
QSG Alpha VS21.
ISSUE 02, 11 September 2014
Material: 157g matte art paper
Comment:
Note: SIDE 2 (BACK)
Red: Pantone CMS 1945C
Optical
Service
SUB OUT
Safety Information
Information with regard to safety is required according to this standard. This information shall be given in a
separate booklet or sheet, or be located before any operating instructions in an instruction for installation or
use and supplied with the apparatus. This information shall be given in a language acceptable to the country
where the apparatus is intended to be used.
The important safety instruction shall be entitled “Import Safety Instruction”. The following safety instruction
shall be included where applicable, and when used, shall be verbatim as follows. Additional safety
information is not prohibited from being included by adding statements after the end of the following safety
instruction list. At the manufacturer's option, a picture or drawing that illustrates the intent of a specific safety
instruction is not prohibited from being placed immediately adjacent to that safety instruction.
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. The wide blade or the third prong are provided for your safety. If the provided plug does not
fit into your outlet, consult an electrician for replacement of the obsolete unit.
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the
cart/apparatus combination to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
15)
The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids,
such as vases, shall be placed on the apparatus.
16)
To reduce the risk of fire or electric shock, this apparatus should not be exposed to rain or moisture.
17)
The mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert
you to the presence of uninsulated “dangerous voltage” within the product's enclosure that
may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point with an equilateral triangle is intended to alert you to the presence of
important operating and maintenance (servicing) instructions in the literature accompanying
the product.
Notice of FCC Compliance
Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This product has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This product generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this product does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minimum distance 20cm between the radiator and
your body
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radioexempts de licence. L'exploitation est autorisée aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Cet appareil est conforme à la section 15 des réglementations de la FCC. Le
fonctionnement de l’appareil est sujetaux deux conditions suivantes :
(1) cet appareil ne doit pas provoquer d’interférences néfastes, et
(2) cet appareil doit tolérer les interférences reçues, y compris celles qui risquent de
provoquer un fonctionnement indésirable.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Format                          : application/pdf
Creator                         : Rob Nicholls
Title                           : Safety Pages.cdr
Create Date                     : 2014:09:18 10:56:57-04:00
Creator Tool                    : CorelDRAW X6
Modify Date                     : 2014:09:19 11:02:59+08:00
Metadata Date                   : 2014:09:19 11:02:59+08:00
Producer                        : Corel PDF Engine Version 16.4.1.1281
Document ID                     : uuid:7bc45b26-3bc9-47be-b022-6bd9680d7e7f
Instance ID                     : uuid:838277ab-0489-48f4-9852-a452a592b6e3
Page Count                      : 5
Profile CMM Type                : Lino
Profile Version                 : 2.1.0
Profile Class                   : Display Device Profile
Color Space Data                : RGB
Profile Connection Space        : XYZ
Profile Date Time               : 1998:02:09 06:49:00
Profile File Signature          : acsp
Primary Platform                : Microsoft Corporation
CMM Flags                       : Not Embedded, Independent
Device Manufacturer             : IEC
Device Model                    : sRGB
Device Attributes               : Reflective, Glossy, Positive, Color
Rendering Intent                : Perceptual
Connection Space Illuminant     : 0.9642 1 0.82491
Profile Creator                 : HP
Profile ID                      : 0
Profile Copyright               : Copyright (c) 1998 Hewlett-Packard Company
Profile Description             : sRGB IEC61966-2.1
Media White Point               : 0.95045 1 1.08905
Media Black Point               : 0 0 0
Red Matrix Column               : 0.43607 0.22249 0.01392
Green Matrix Column             : 0.38515 0.71687 0.09708
Blue Matrix Column              : 0.14307 0.06061 0.7141
Device Mfg Desc                 : IEC http://www.iec.ch
Device Model Desc               : IEC 61966-2.1 Default RGB colour space - sRGB
Viewing Cond Desc               : Reference Viewing Condition in IEC61966-2.1
Viewing Cond Illuminant         : 19.6445 20.3718 16.8089
Viewing Cond Surround           : 3.92889 4.07439 3.36179
Viewing Cond Illuminant Type    : D50
Luminance                       : 76.03647 80 87.12462
Measurement Observer            : CIE 1931
Measurement Backing             : 0 0 0
Measurement Geometry            : Unknown
Measurement Flare               : 0.999%
Measurement Illuminant          : D65
Technology                      : Cathode Ray Tube Display
Red Tone Reproduction Curve     : (Binary data 2060 bytes, use -b option to extract)
Green Tone Reproduction Curve   : (Binary data 2060 bytes, use -b option to extract)
Blue Tone Reproduction Curve    : (Binary data 2060 bytes, use -b option to extract)
Author                          : Rob Nicholls
EXIF Metadata provided by EXIF.tools
FCC ID Filing: SVC-PSBVS21

Navigation menu