Lexmark LEXM04001 Lexmark 802.11 Wireless Module User Manual goatcheese wireless notices

Lexmark International Inc Lexmark 802.11 Wireless Module goatcheese wireless notices

User Manual

Electronic Emission Notices Addendum

Federal Communications Commission (FCC) compliance information statement

The Internal Solutions Port has been tested has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that

may cause undesired operation. Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this equipment not expressly approved by the manufacturer may cause

harmful interference and void your authority to operate this equipment. Use of supplied data cable is required to comply with the Class B limits of Part 15 of the FCC Rules. This

product does not contain any user serviceable components and is to be used with the supplied antenna only.

The FCC Class B limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult your point of purchase or service representative for additional suggestions.

The manufacturer is not responsible for any radio or television interference caused by using other than recommended cables or by unauthorized changes or modifications to this

equipment. Unauthorized changes or modifications could void the user's authority to operate this equipment.

Note: To assure compliance with FCC regulations on electromagnetic interference for a Class B computing device, use a properly shielded

and grounded cable such as Lexmark part number 1021231 for parallel attach or 1021294 for USB attach. Use of a substitute cable

not properly shielded and grounded may result in a violation of FCC regulations.

Any questions regarding this compliance information statement should be directed to:

Director of Lexmark Technology & Services

Lexmark International, Inc.

740 West New Circle Road

Lexington, KY 40550

(859) 232-3000

Industry Canada compliance statement

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Standard ICES-003.

Avis de conformité aux normes de l’industrie du Canada

Cet appareil numérique de classe B est conforme aux exigences de la norme canadienne relative aux équipements pouvant causer des interférences NMB-003.

European Community (EC) directives conformity

This product is in conformity with the protection requirements of EC Council directives 2004/108/EC, 2006/95/EC, and 1999/5/EC on the approximation and harmonization of the

laws of the Member States relating to electromagnetic compatibility, safety of electrical equipment designed for use within certain voltage limits and on radio equipment and

telecommunications terminal equipment.

Compliance is indicated by the CE marking.

A declaration of conformity with the requirements of the directives is available from the Director of Manufacturing and Technical Support, Lexmark International, S. A., Boigny,

France. This product satisfies the limits of EN 55022; safety requirements of EN 60950; radio spectrum requirements of ETSI EN 300 328; and the EMC requirements of EN

55024, ETSI EN 301 489-1 and ETSI EN 301 489-17..

English Hereby, Lexmark International Inc., declares that this product is in compliance with the essential

requirements and other relevant provisions of Directive 1999/5/EC.

Suomi

Valmistaja Lexmark International Inc. vakuuttaa täten, että tämän tuotteen tyyppinen laite on

direktiivin 1999/5/EY oleellisten vaatimusten ja sitä koskevien direktiivin muiden ehtojen

mukainen.

Nederlands

Hierbij verklaart Lexmark International Inc. dat dit product in overeenstemming is met de

essentiële eisen en de andere relevante bepalingen van richtlijn 1999/5/EG.

Bij deze verklaart Lexmark International Inc. dat dit product voldoet aan de essentiële eisen en

aan de overige relevante bepalingen van richtlijn 1999/5/EG.

Français

Par la présente Lexmark International Inc. déclare que le produit est conforme aux exigences

essentielles et aux autres dispositions pertinentes de la directive 1999/5/CE

Par la présente, Lexmark International Inc. déclare que ce produit est conforme aux exigences

essentielles et aux autres dispositions de la directive 1999/5/CE qui lui sont applicables

Svenska

Härmed intygar Lexmark International Inc. att denna produkt står i överensstämmelse med de

väsentliga egenskapskrav och övriga relevanta bestämmelser som framgår av direktiv 1999/5/

EG.

Dansk Undertegnede Lexmark International Inc. erklærer herved, at følgende produkt overholder de

væsentlige krav og øvrige relevante krav i direktiv 1999/5/EF

P/N 14F0142

E.C. 5E0032

*14F0142*

Japanese VCCI notice.

Korean MIC statement.

Waste from Electrical and Electronic Equipment (WEEE) directive

The WEEE logo signifies specific recycling programs and procedures for electronic products in countries of the European Union. We encourage the recycling of our products. For

contact information regarding the Waste from Electrical and Electronic Equipment (WEEE) directive, refer to the Notices section of the online User’s Guide that shipped with your

printer.

German

Hiermit erklärt Lexmark International Inc., dass sich dieses Produkt in Übereinstimmung mit den

grundlegenden Anforderungen und den anderen relevanten Vorschriften der Richtlinie 1999/5/

EG befindet. (BMWi)

Hiermit erklärt Lexmark International Inc. die Übereinstimmung des Produkts mit den

grundlegenden Anforderungen und den anderen relevanten Festlegungen der Richtlinie 1999/5/

EG. (Wien)

ÅëëçíéêÜ Ìå ôçí ðáñïýóá Lexmark International Inc. äçëþíåé üôé ôï ðáñüí ðñïúüí óõììïñöþíåôáé ðñïò ôéò

ïõóéþäåéò áðáéôÞóåéò êáé ôéò ëïéðÝò ó÷åôéêÝò äéáôÜîåéò ôçò ïäçãßáò 1999/5/EK.

Italiano Con la presente Lexmark International Inc. dichiara che questo prodotto è conforme ai requisiti

essenziali e alle altre disposizioni pertinenti stabilite dalla direttiva 1999/5/CE.

Español

Por medio de la presente Lexmark International Inc. declara que este producto cumple con los

requisitos esenciales y cualesquiera otras disposiciones aplicables o exigibles de la Directiva

1999/5/CE

Português A Lexmark International Inc. declara que este produto está em conformidade com os requisitos

essenciais e outras provisões da Directiva 1999/5/CE.

Èesky Spoleènost Lexmark International Inc. tímto prohlašuje, že tento výrobek vyhovuje základním

požadavkùm a dalším ustanovením smìrnice 1999/5/EC, které se na tento výrobek vztahují.

Malti

Magyar

A Lexmark International Inc. ezennel kijelenti, hogy ez a termék megfelel az 1999/5/EC direktíva

alapvetõ követelményeinek és más vonatkozó rendelkezéseinek.

Eesti

Käesolevaga kinnitab Lexmark International Inc. selle seadme vastavust direktiivi 1999/5/EÜ

põhinõuetele ja nimetatud direktiivist tulenevatele teistele asjakohastele sätetele.

Latviski Ar ðo Lexmark International Inc. deklarç, ka ðis produkts atbilst Direktîvas 1999/5/EK bûtiskajâm

prasîbâm un citiem ar to saistîtajiem noteikumiem.

Lithuanian Lexmark International Inc. deklaruoja, kad šis gaminys tenkina 1999/5/EB Direktyvos esminius

reikalavimus ir kitas šios direktyvos nuostatas.

Polski Firma Lexmark International Inc. deklaruje z pe³n¹ odpowiedzialnoœci¹, ¿e ten produkt spe³nia

podstawowe wymagania i odpowiada warunkom zawartym w dyrektywie 1999/5/WE.

Slovak

Lexmark International Inc. týmto vyhlasuje, že tento výrobok vyhovuje technickým požiadavkám

a ïalším ustanoveniam smernice 1999/5/ES, ktoré sa na tento výrobok vzt’ahujú.

Slovenšèina

Družba Lexmark International Inc. s tem izjavlja, da je ta naprava skladna z bistvenimi zahtevami

in drugimi ustreznimi doloèili direktive 1999/5/EC.

Wireless device notice

In some environments, the use of wireless devices may be restricted. Such restrictions may apply aboard airplanes, in hospitals, near explosives, in hazardous locations, and so

on. If you are uncertain of the policy that applies to the use of this device, ask for authorization to use it prior to turning it on.

Exposure to radio frequency radiation

The radiated output power of this device is far below the FCC radio frequency exposure limits. A minimum separation of 20 cm (8 inches) must be maintained between the antenna

and any persons for this device to satisfy the RF exposure requirements of the FCC.

Industry Canada compliance statement

This device complies with Industry Canada specification RSS-210. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this

device must accept any interference received, including interference that may cause undesired operation of the device.

To prevent radio interference to the licensed service, this device is intended to be operated indoors and away from windows to provide maximum shielding. Equipment (or its

transmit antenna) that is installed outdoors is subject to licensing.

The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF fields in excess of Health Canada limits for the general

population; consult Safety Code 6, obtainable from Health Canada’s Web site www.hc-sc.gc.ca/rpb.

Avis de conformité aux normes de l’industrie du Canada

Cet appareil est conforme à la spécification RSS-210 d'Industry Canada. Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne peut engendrer

aucune interférence et (2) il doit accepter toute interférence qu'il reçoit, y compris celles qui peuvent altérer son fonctionnement.

Pour éviter toute interférence radio au service sous licence, cet appareil est conçu pour être utilisé à l'intérieur et loin des fenêtres afin de garantir une protection optimale.

L'équipement (ou son antenne émettrice) est soumis à l'obtention d'une licence s'il est installé à l'extérieur.

L'installateur de cet équipement radio doit veiller à ce que l'antenne soit implantée et dirigée de manière à n'émettre aucun champ HF dépassant les limites fixées pour l'ensemble

de la population par Santé Canada. Reportez-vous au Code de sécurité 6 que vous pouvez consulter sur le site Web de Santé Canada www.hc-sc.gc.ca/rpb.

(chinese placeholder below-remove this statement after translation)

Part name

Toxic and hazardous substances or elements

Lead

(Pb) Mercury

(Hg) Cadmium (Cd)

Hexavalent

Chromium (Cr

VI) Polybrominated

biphenyl (PBB) Polybrominated

diphenylether (PBDE)

Circuit boards X O O O O O

Connectors X O O O O O

O: Indicates that the content of the toxic and hazardous substance in all the homogenous materials of the part is below the concentration limit

requirement as described in SJ/T11363-2006.

X: Indicates that the content of the toxic and hazardous substance in at least one homogenous material of the part exceeds the concentration

limit requirement as described in SJ/T11363-2006.

This product is compliant with the European Union Directive 2002/95/EC concerning the restriction of use of certain hazardous substances.