Light Wave Technology 1151 TRANSMITTER User Manual
Light Wave Technology TRANSMITTER
User Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 2203859 |
| Application ID | JX0D/0jonCUx0BYCEFC4ng== |
| Document Description | User Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 8.62kB (107799 bits) |
| Date Submitted | 2014-02-28 00:00:00 |
| Date Available | 2014-02-28 00:00:00 |
| Creation Date | 2014-01-30 10:39:35 |
| Producing Software | Acrobat Distiller 10.1.9 (Windows) |
| Document Lastmod | 2014-01-30 10:39:35 |
| Document Title | Microsoft Word - PKE-AL(PS)-UNI Owners Manual DRAFT - Booklet REV.1.0.docx |
| Document Creator | PScript5.dll Version 5.2.2 |
| Document Author: | Mike |
Passive Keyless Entry System Passive or Active Keyless entry system User Guide OWNERS MANUAL Lightwave Technology PKE-AL(PS)-UNI 400 Wright Street Montreal, QC, Canada, H4N1M6 Website: www.lightwavetechnology.com WARNING! It is the responsibility of the vehicle operator to ensure that their vehicle is parked in a safe and responsible manner. A note concerning the battery inside the transmitter: Depending on your usage of the transmitter, the battery can last anywhere between 2 to 3 years. Although we recommend to replace the battery inside the transmitter every year to get the best performances from your system. INDUSTRY CANADA USER NOTICE: Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that required for successful communication. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment. Doc#140109 Rev: 1.0 ©2014 -1W-AM-2BTN-PKE-A- Canada Passive or Active Keyless entry system Passive or Active Keyless entry system User Guide User Guide Table of Contents Diagnostics - Parking lights Flash Table Government regulations…………………………………………………………………….…… Using the transmitter and ADB………………………………………………………….…… Parking Lights Flashes Doorlock Access Chart……………………………………………………………………….…… 1 Flash Door Lock Trunk / Hatch Release……………………………………………………………………….…… 2 Flashes Door Unlock Valet Mode………………………………………………………………………………….…………… 3 Flashes Valet Mode Parking Light Flash Table………………………………………………………………………… 5 Flashes Please see your retailer 6 Flashes Please see your retailer Door Locking command using ADB while RFID transmitter is inside vehicle (Active Mode Only) Please see your retailer 7 Flashes 8 Flashes Description Passive or Active Keyless entry system Passive or Active Keyless entry system User Guide User Guide Government regulations Trunk/Hatch Release or Motorized liftgate With RFID transmitter Press & Release Button 1 & 2 on RFDI transmitter Parking lights will blink 2 times Trunk will pop open or Motorized hatch will open or Close This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Valet Mode Enabled/Disabled Use factory key in ignition cylinder Cycle Key in ignition cylinder 5x On/Off Valet On = Parking lights will blink 3 times Valet Off = Parking lights will blink 2 times This device complies with the Industry Canada Radio Standards Specification RSS 210. Its use is authorized only on a no-interference, noprotection basis; in other words, this device must not be used if it is determined that it causes harmful interferences to services authorized by IC. In addition, the user of this device must accept any radio interface that may be received, even if this interfere-ence could affect the operation of the device. Warning! Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device. Passive or Active Keyless entry system Passive or Active Keyless entry system User Guide User Guide Using the Transmitter and ADB Doorlock Access Chart The Doorlock mode is configured by your installer at the time of installation. There are three (3) different doorlock mode. Passive mode does not require any action from user and is the default method to use. Active mode requires a physical action from user in order to Lock / Unlock the doors. The ADB (Part#: XXXXXXX) is required for Active mode and is sold separately. Hybrid mode requires to use the ADB in active mode but will lock the doors automatically after 90 seconds if doors are left unlocked inadvertently and RFID transmitter is not in range. Your Passive Keyless system is equipped with a 2 button RFDI remote control. This transmitter is capable of allowing access to your vehicle without pressing any button on it. LOCK Locks the doors and arms the Starter Kill (if installed) With Passive Doorlocking UNLOCK With RFID transmitter Walk away from the vehicle Vehicle doorlocks will Lock / Arm Parking lights will blink 1 time Horn will honk 1 times (if connected) Vehicle doorlocks will Unlock / Disarm Parking lights will blink 2 time Horn will honk 2 times (if connected) (more than 10 feet) Unlocks the doors and disarms the Starter Kill (if installed) TRUNK With RFID transmitter Walk close to the vehicle Opens the Trunk, Hatch or Power liftgate (if option installed) With RFID transmitter in range (within 10 (within 10 feet) With Active Doorlocking (ADB) The Active Doorlock Button (ADB) is an optional part installed at the entry doors and can control the Locking and Unlocking of the doors simply by pressing on it. feet of the vehicle) Press & Release ADB button With RFID transmitter in range (within 10 feet of the vehicle) NOTE: The RFID transmitter must be present for the doorlocks to react to the ADB. With Hybrid Doorlocking (ADB) + Passive mode Press & Release ADB button With RFID transmitter Walk away from the vehicle (more than 10 feet) With RFID transmitter in range (within 10 feet of the vehicle) Press & Release ADB button With RFID transmitter in range (within 10 feet of the vehicle) Press & Release ADB button Vehicle doorlocks will Lock / Arm Parking lights will blink 1 time Horn will honk 1 times (if connected) Vehicle doorlocks will Unlock / Disarm Parking lights will blink 2 time Horn will honk 2 times (if connected) After 90 seconds, Vehicle doorlocks will Lock / Arm Parking lights will blink 1 time Horn will honk 1 times (if connected) Vehicle doorlocks will Unlock / Disarm Parking lights will blink 2 time Horn will honk 2 times (if connected) Vehicle doorlocks will Lock / Arm Parking lights will blink 1 time Horn will honk 1 times (if connected)
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes Author : Mike Create Date : 2014:01:30 10:39:35-05:00 Modify Date : 2014:01:30 10:39:35-05:00 XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Format : application/pdf Creator : Mike Title : Microsoft Word - PKE-AL(PS)-UNI Owners Manual DRAFT - Booklet REV.1.0.docx Creator Tool : PScript5.dll Version 5.2.2 Producer : Acrobat Distiller 10.1.9 (Windows) Document ID : uuid:6a312def-5a37-4610-9a57-35767caec1d9 Instance ID : uuid:8f447701-2ce3-4589-818c-0109ee420100 Page Count : 4EXIF Metadata provided by EXIF.tools