Linak U S MAHB Remote control for Actuator and Massage system User Manual MAHB Operation Manual indd
Linak U.S. Inc Remote control for Actuator and Massage system MAHB Operation Manual indd
User Manual
Operating Guidelines for MAHB Series
Handheld Portable Transmitters
• Button Press LED –
Window should light
when a button is
pressed. If it does
not, you may need
new batteries.
• 3 AAA batteries are
required to operate
the device. See back
of remote.
• If range of transmission
decreases, replace
batteries.
• Changes or modifications
not expressly approved
by the party responsible
for compliance could
void the user’s authority
to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not in-stalled and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
» Reorient or relocate the receiving antenna.
» Increase the separation between the equipment and receiver.
» Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. —Consult the
dealer or an experienced radio/ TV technician for help.
This Class [[1]] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [1] est conforme à la norme
NMB-003 du Canada.
Copyright © LINAK 03.07 . MA M9-09-047-A . Chapter 9.13
LINAK U.S. Inc.
North and South American Headquarters
2200 Stanley Gault Parkway
Louisville, KY 40223
Phone: 502 253 5595 • Fax: 502 253 5596
www.linak-us.com
Specifications subject to change without prior notice.
It is the responsibility of the product user to determine the suitability
of LINAK A/S products for a specific application. LINAK will at point
of delivery replace/repair defective products covered by the warranty
if promptly returned to the factory. No liability is assumed beyond
such replacement/repair.