Lionda Technology Co M42001 900 Mhz Analog Modulation Cordless Phone User Manual FCC Information

Lionda Technology Co Ltd 900 Mhz Analog Modulation Cordless Phone FCC Information

Contents

FCC Information

Download: Lionda Technology Co M42001 900 Mhz Analog Modulation Cordless Phone User Manual FCC Information
Mirror Download [FCC.gov]Lionda Technology Co M42001 900 Mhz Analog Modulation Cordless Phone User Manual FCC Information
Document ID131036
Application IDXOXEyHl3x3pYqqfsyPRlAg==
Document DescriptionFCC Information
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize18.39kB (229921 bits)
Date Submitted2000-12-29 00:00:00
Date Available2000-12-29 00:00:00
Creation Date2000-12-06 18:07:39
Producing SoftwareAcrobat 4.0 Scan Plug-in for Windows
Document Lastmod2000-12-06 18:08:57
Document TitleFCC Information
Document CreatorAcrobat 4.0 Scan Plug-in for Windows

Technical Information
This cordless telephone uses radio frequencies to allow mobility. There are certain
normal, the following could affect the operation of your system.
Noise
Electrical pulse noise is present in most homes at one time or another. This noise is
most intense during‘electricai storms. Certain kinds of electrical equipment such as
light dimmers, fluorescent bulbs, motors, and fans also generate noise pulses.
Because radio frequencies are susceptible to these noise pulses, you may
occasionally hear them in your HANDSET. Generally they are a minor annoyance and
should not be interpreted as a defect in your system.
Range
Because radio frequency is used. the location of the BASE UNlT can affeotthe operating
range. Try several locations In your home or office and pick the one that gives you the
clearest signal to the HANDSET.
Interference
Electronic circuits activate a relay to connect the cordless telephone to your telephone
line. These electronic circuits operate In the radio frequency spectrum While several
protedion circuits are used to prevent unwanted signals. there may be periods when
these unwanted signals enter the BASE UNIT. You may hear clicks or hear the relay
activate while you are not using the HANDSET. lfthe interference occurs frequently, it can
be minimized or eliminatedhy lowering the height of your BASE UNIT ANTENNA or inf
relocating the BASE UNn'. You an oheckfor interference before selecting the final EASE
UNIT location by plugging in the telephone.
NOTICE:
This cordless telephone uses radio communication between the HANDSET and the
BASE UNlT and may not ensure privacy of communication. Other devices, including
other cordless telephones, may interfere with the operation of this cordless telephone
or cause noise during operation. Units not containing coded access may be accessed
by other radio communication systems. Cordless telephones must not cause
interference to any licensed radio sen/Ice.
IM PO RTANT
When you hear interference, press the
button to change the operating channel.
difficulties in using radio frequencies with a cordless telephone. While these are '
Federal Communications Commission Requirements
This equipment complies with Part 68 of the FCC Rules. A label on the BASE UNlT of
this equipment contains, among other Intomtation, the FCC Registration Number and
the Ringer Equivalence Number (REN) for this equipment. You must, upon request,
provide this information to your telephone company.
The REN is also useful in determining the quantity of devices that you may connect
to your telephone line and still allow these devices to ring when your telephone number
is called. In most areas, but not all, the sum of the RENs for all devices connected to one
line should not exceed five (5.0). To be certain of the number of devices that you may
connect to your line, you should contact your local telephone company.
If your equipment should cause harm to the telephone network, the telephone company
may temporarily disconnect your service. If possible, they will notify you in advance that
temporary discontinuance of service may be required. However, When advanced written
notice is not possible, the telephone company may temporarily discontinue service
without notice If such action is necessary under the circumstances. The telephone
company may make changes in Its communication facilities. equipment, operations, or
procedures where such action is reasonably required in the operation of its business
and is not inconsistent with the rules and regulations of the Federal Communications
Commission. Do not attempt to repair or modify this equipment.
WARNING: Changes or modifications not expressly approved by the party responsible
for Its compliance could void the user‘s authority to operate the equipment.
Some cordless telephones operate at frequencies that may cause interference to nearby,
TVs and VCRs. To minimize or prevent such interference, the BASE UNIT of» the cordless
telephone should not be placed on or near a TV or VCR. If interference is experienced.
moving the cordless telephone farther away from the TV or VCR will often reduce or
eliminate the interference.
This equipment should not be used on coin telephone lines. Connection to party line
service is subject to state tariffs. If trouble is experienced, disconnect this equipment
from the telephone line to determine If It Is causing the malfunction. If the equipment Is
determined to be malfunctioning, its use should be disconnected until the problem has
been corrected.
IMPORTANT
FM!
Warranty
Federal Communications Commission Requirements (conflnuew
NOTE: This equipment has been tested and found to comply with the limits for a class
B digital device. pursuant to Part 15 of the FCC Rules. These Iimlts are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and. if not
' ins’mlled and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is’ no guarantee that interference will not occur in a particular
Installation. if this equipment does cause harmful Interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures.
1. Reorlent or relocate the receiving ANTENNA.
2. Increase the distance between the equipment and the receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
55s?» , m __
, Wm
Warranty Information
Bellsouth Products , l
One—Year Limited Warranty
This limited warranty sets forth all BellSouth Products responsibilities regarding your
produm. There are no other expressed or implied warranties from BeIISouth Products.
Warranty Service Provided
if you purchased the telephone new from a retail vendor, BeIISouth Products warrants
the telephone against defects in material and workmanship for a period of one (1) year
from the original date of purchase. This warranty Is In lieu of all other expressed
warranties. This warranty begins when you purchase the telephone and continues for
one (1) year unless you sell or rent the telephone, In which case the warranty stops.
BellSouth Products disclaims any implied warranty, including the warranty of
merchantability and the warranty of illness tor a particular purposehes of the date of 90
days from your original purchase of the telephone. BellSouth Products assumes no
responsibility for any special, Incidental, or consequential damages.
This wananly gives you specific legal rights and you may have other rights which vary
from state to state. Some states do not allow the exclusion or limitations ol special.
incidental or consequential damages, or limitations on how long a warranty lasts, so
the above exclusion and limitation may not apply to you.
Warranty Service Not Provided
This warranty does not cover damage resulting from accident. misuse. abuse.
improper installation or operation. lack of reasonable care, unauthorized modification,
the affixing of any attachment not provided by BellSouth Products with the telephone
and/or loss of parts. This warranty is voided in the event any unauthorized person
opens, alters or repairs the telephone. All Bellsouth equipment being returned for
repair must be suitably packaged. Telephone companies use different types of
equipment and offer various types of services to customers. BeIISouth Products does
not warrant that this telephone is compatible with the type of equipment of any particular
telephone company or the services provided by it

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Modify Date                     : 2000:12:06 18:08:57+08:00
Create Date                     : 2000:12:06 18:07:39+08:00
Creator                         : Acrobat 4.0 Scan Plug-in for Windows
Producer                        : Acrobat 4.0 Scan Plug-in for Windows
Page Count                      : 2
EXIF Metadata provided by EXIF.tools
FCC ID Filing: O63M42001

Navigation menu