LogicMark CS41920 Caretaker Sentry Emergency Wall Communicator User Manual manual

LogicMark, LLC Caretaker Sentry Emergency Wall Communicator manual

manual

v3.3Guardian AlertEnglish SET UP INSTRUCTIONSEmergency Wall Communicator Model #41920 This accessory is to be used with the LogicMark’s CaretakerSentry product line.  Up to a total of 9 pendants and Emergency Wall Communicators (EWC)  can be learned to one LogicMark “DECT” (1.9 Ghz) base unit.CONTENTS:Emergency Wall Communicator(EWC)AAA Alkaline Batteries4 piecesDouble Stick Velcro2 Screws
 2                       Emergency Wall Communicator                                             v3.2 TABLE OF CONTENTSInstalling the Batteries ..............................................................................3Learning the EWC to the Base of Your PERS System ..........................3Battery Check ............................................................................................ 4System Check ............................................................................................5FCC Information.......................................................................................6Warranty ....................................................................................................8Product Specications ..............................................................................9NOTE: Before programming this Emergency Wall Communicator (EWC) to work with your LogicMark DECT base unit, you must acknowledge that all of the Warnings, Limitations of Liability, Disclaimers, FCC information and Testing Instructions written in the LogicMark Personal Emergency Response System (PERS) instruction manuals pertain to the use of this EWC as well when used with these products.  By programming this EWC to your LogicMark PERS product, you acknowledge that you have a copy of these instructions and have read them.  If you do not have a copy, you can always download one off of our website or by calling our company and requesting one.
 v3.2                        Emergency Wall Communicator                    3Installing the BatterySlide the battery cover to the left to unlatch the coverInstall the 4 AAA alkaline batteries - noting the polarity on the inside of the battery cover.  The spring contacts are meant to touch the negative side of the batteries.  Close the battery cover and latch to lock cover.Learning the EWC to the Base unit of Your PERS System.  Note:  Throughout this manual, EWC will refer to the Emergency Wall Communicator; Pendant will refer to a hand-held pendant used by the Personal Emergency Response System (PERS) and Base will refer to the base unit of the PERS system.On the Base Unit:1. Push  and  release the RED Code Learn button on the back of the Base unit.  (Use the tip of the screwdriver or a ball-point pen to reach through the case). You will hear a voice prompt “Pendant Learning”On the EWC:2. PUSH the RED Help button and then the  GRAY Test button  simul-taneously –HOLD both buttons for a few seconds until you hear “Pendant Learning” from the EWC - then release both buttons.• If“BaseandPendantoutofRange”isheardfromtheEWC,stop- wait 30 seconds and start at step #1 again.3. When Pendant learning has been successful you will hear “Pendant Code Learned” and then it will announce the mode of the Base unit.
 4                       Emergency Wall Communicator                                             v3.2 Notes:• Youhaveupto45secondsafterpushingtheREDCodeLearnbuttonon the Base unit to get the EWC to enter “Pendant Learning”.• Learning additional Pendants or EWCs does not erase previouslylearned Pendants or EWCs.• TheBaseunitwillautomaticallyexitthePendantlearningmodeafterseveral seconds or if Pendant learning failed.• Onlyacombinedtotalof9PendantsandEWCscanbelearnedtoaBase unit.  If a Pendant has been lost or replaced, erase all the Pendants andrelearnallcurrentPendantsandEWCs.(Seenextparagraph).At a later point in time, you might want to erase your previously learned pendants.  You can erase all previously learned Pendants and/or EWCs by simply holding down the red Code Learn button at the back of the Base unitfor8-10seconds.Youwillheartheconrmationof“PreviousPendantCodes Erased” from the Base unit.  After that, you can program a new Pendant to the Base unit following the steps above as desired.Mounting the Product.You have two choices to mount the product to the wall.  You can use the two  screws provided - or you can use the special Velcro style fastener provided.  If using the screws - Attach the mounting plate to the wall.  If using the Velcro - make sure the surfaces are clean and dry before mounting.  Battery Check:The 4 AAA alkaline batteries should power the unit for over one year in standby mode.  When the EWC is used - there are several hours of talk time on fresh batteries.  We recommend replacement of the batteries every 6 months, just like a smoke detector.  TheEWChasabuilt-inbatterytestertoallowyoueasyconrmationofthestatus of the batteries.  When you press the small Gray button on the EWC, a voice announcement will inform you of the condition of the battery.  One of the following messages will be heard:
 v3.2                        Emergency Wall Communicator                    5“Battery is ok.”  Check the battery condition monthly.“Battery is low.” Thebatteriesshouldbereplacedwithinthenextweeks.“Replace battery now.”  The 4 AAA batteries should be replaced now with 4 new AAA alkaline batteries.Please note: If there is no response after pressing the button for one second or more, the batteries are dead and must be replaced immediately.The battery should be tested at least monthly along with the System Check outlined below. System Check:The gray button on the top left side of the EWC which is used to perform the BATTERY CHECK, will also used to perform a SYSTEM CHECK.  Press and hold this button for more than four (4) seconds.  One of the fol-lowing announcements will be made.“All systems are ok.” Thisconrmsthefollowing:    Battery status.    The EWC is working.    The Base unit is working.    The Base unit is connected to a working phone line.    The EWC is within range of the Base unit.
 6                       Emergency Wall Communicator                                             v3.2 “System cannot detect dial tone.”    The Base unit is not connected to the phone line or can not get a dial tone for some reason.“Base and Pendant out of range.” Thisconrmsoneormoreofthefollowing:    The EWC has malfunctioned.    The Base has malfunctioned.    The EWC and Base unit are not communicating with each other or are out or range.Caution - To ensure proper operation, this equipment must be installed according to the these instructions.  We highly recommend that you perform this System Check after installation and at least monthly to conrm that your system is working properly  It is also recommended to perform this system check after a lightning storm that could damage the Base unit which is plugged into the phone line. Water Resistance:  This EWC is designed to be mounted on a bathroom wall if desired. However,itshouldneverbesubmergedorexposedtowatercontinuously.If your EWC is not working, call our tech support at 1-888-283-6516.Information The FCC Wants You To Know:Caretaker Sentry Emergency Wall Communicator – Model 41920FCC ID: TYD-CS41920IC: 8471A-CS41920 Changesormodicationsnotexpresslyapprovedbythepartyresponsiblefor compliance could void the user’s authority to operate the equipment.
 v3.2                        Emergency Wall Communicator                    7ThisdevicecomplieswithPart15oftheFCCRules.Operationissubjectto the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for a ClassBdigitaldevice,pursuanttoPart15oftheFCCRules.Theselimitsare designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.-Consultthedealeroranexperiencedradio/TVtechnicianforhelp.ThisportabletransmitterwithitsantennacomplieswithFCC/ICRFexpo-surelimitsforgeneralpopulation/uncontrolledexposure.This Device complies with Industry Canada License-exempt RSSstandard(s). Operation is subject to the following two conditions: 1) this device may not cause interference, and 2) this device must accept any interference, including interference that may cause undesired operation of the device.CetappareilestconformeàIndustrieCanadaexemptesdelicenceRSSoulesnormes.Opérationestsujetteauxdeuxconditionssuivantes:1)cetappa-reil ne doit pas brouillage et 2) cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant entraîner un fonctionnement indésirable du dispositif.
 8                       Emergency Wall Communicator                                             v3.2 ONE YEAR LIMITED WARRANTYLogicMark, LLC warrants to the original consumer/purchaser that this product shall be free of defects in material and workmanship under normal use and circumstances for a period of one (1) year from the date of original purchase for use. When the original consumer/purchaser returns the prod-uct pre-paid to LogicMark, LLC; 10106 Bluegrass Pkwy; Louisville KY, 40299, USA within the warranty period, and if the product is defective, LogicMark, LLC will at its option repair or replace such.This warranty shall constitute the sole liability of LogicMark, LLC concern-ingtheproduct.LogicMark,LLCexpresslydisclaimsallotherwarrantiesINCLUDING, WITHOUT LIMITATION, THE WARRANTIES OF MER-CHANT ABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  NO PERSON, FIRM, OR CORPORATION IS AUTHORIZED TO ASSUME FOR LogicMark, LLC. ANY OTHER LIABILITY IN CONNECTION WITH THE SALE AND USE OF THE PRODUCT. LogicMark, LLC and agents and distributors will bear no liability whatsoever for incidental or consequential damages or charges of any kind.Somestatesdonotallowtheexclusionorlimitationofincidentalorcon-sequential damages, so the above disclaimer regarding incidental or con-sequential damages may not apply to you.This warranty is void if the product has been damaged or tampered with or if the product or any such parts have been opened. In all cases of damage duringshipment,aclaimmustbeledwiththeshippingcarrierandnotwith LogicMark, LLC.Thiswarrantygivesyouspeciclegalrights;youmayalsohaveotherrightswhich vary from state to state.OUT OF WARRANTY REPAIRSIfthewarrantyperiodhasexpiredorifyouarenottheoriginalowneroftheproduct, LogicMark, LLC will at its option either (1) replace this product with a functionally similar (but not necessarily identical) refurbished prod-uct or (2) repair the original product and return it to the original consumer/purchaser after payment of repair/replacement charges has been received.
 v3.2                        Emergency Wall Communicator                    910106 Bluegrass PkwyLouisville KY, 40299Tel:1-502-410-0402TollFree:1-888-283-6516Fax:1-703-934-7935www.LogicMark.com©2013 LogicMark, LLCProduct Specications:RF Characteristics:    1.9 Ghz DECT Communication TechnologyOperating Range    Should cover your typical American house         - but needs to be tested after installation.Batteries      4  AAA Alkaline.  Replace every 6 monthsWater-resistance  WaterSprayStandardIPX5(showeronly).Number of Products/Base Unit  Up to a total of 9 Pendants and Emergency Wall Communicators can be programmed to one Base unit.OperatingTemperature  32˚to120˚F.(0˚to49˚C).

Navigation menu