Long Range Solutions TR7400 Short range paging system transmitter User Manual Layout 1

Long Range Systems, LLC Short range paging system transmitter Layout 1

Users Manual

TR-7400 DescriptionThe TR-7400 is designed to booster a transmitter’s signal and “retransmit” the same signal.The unit comes with the following items:• The main unit• 1 right angle antenna• 12-Volt power supplyConnecting the AntennaThe 3” right angle antenna should be placed on the silver barrel on the side of the main unit,twisted and locked into place (see picture)Long Range Systems 1TR-7400 Quick GuideTR-7400 Transmitter- ReceiverPaging Transmitter Repeater SystemQUICK SETUP & OPERATIONTransmitPower9VAC800.437.4996www.pager.netCONDOR CLASS 2 TRANSFORMER(408)745-7141INPUT: AC 12OV 60Hz 19wOUTPUT: AC 9V 1800mAP/N: A91A8RoHSUULLLISTEDCMODEL: 48A -9- 1800EIA 363 0635 SMADE IN CHINAAC Power Outlet10V Power AdapterAntennaMain Unit
Positioning and Installing the BoosterNote: The best place to mount your Booster is on a ceiling or wall that is very high. Theidea is to get the signal as high as possible so it “umbrellas” the guest and thus allpagers can receive it.The booster operates at its best when installed at the “fringe” of your area. This means youshould get it as far from the transmitter as possible but still be able to receive the transmitter’ssignal.1. Locate a 110V outlet near the selected installation location.2. Plug the power adapter into the outlet and into the power connector hole on theside of the unit.3. Ensure that when power is plugged in, the Red RECEIVE light will blink continu-ously to indicate power is on and the unit is operating.4. Place the paging transmitter in “Range Test Mode” (see transmitter’s operating in-structions).5. Ensure the Red TRANSMIT light periodically alternate flashes on about every 5seconds.• If the periodic TRANSMIT flash does not occur, move the booster unit closer tothe transmitter and try again.• Keep moving the booster toward the transmitter until the TRANSMIT flash oc-curs.• After establishing the correct distance, mount the booster as high as possibleNormal RangeTransmitterTR-7400Extended RangeSETUPMGR1MGR2STAFFCLEARENTER1234567890ABCDEFGHIJKLMNOPQRSTUVWXYZ[T7400ALong Range Systems800.437.4996F1F2F3F4TransmitPower9VAC800.437.4996www.pager.net : : Long Range Systems 2TR-7400 Quick Guide
System SpecificationRequired voltage: One 110V outlet for the pager keypad.Operating Frequency: 467.75 MHzRadiated Power <120mWOperating Range: Dependent upon pagers used and topography and environment.Long Range Systems, LLC reserves the right to make changes without further notice to any products herein.Long Range Systems, LLC makes no warranty, representation or guarantee regarding the suitability of its prod-ucts for any particular purpose, nor does Long Range Systems, LLC assume any liability arising out of the appli-cation or use of any product or circuit, and specifically disclaims any and all liability, including without limitationconsequential or incidental damages. “Typical” parameters that may be provided in Long Range Systems, LLCdata sheets and/or specifications can and do vary in different applications and actual performance may varyover time. All operating parameters, including “Typicals”, must be validated for each customer application bycustomer’s technical experts. Long Range Systems, LLC products are not designed, intended, or authorized foruse as components in systems intended to support or sustain life, or for any other application in which the failureof the Long Range Systems, LLC product could create a situation where personal injury or death may occur.Should Buyer purchase or use Long Range Systems, LLC products for any such unintended or unauthorized ap-plication, Buyer shall indemnify and hold Long Range Systems, LLC and its officers, employees, subsidiaries, af-filiates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorneyfees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended orunauthorized use, even if such claim alleges that Long Range Systems, LLC was negligent regarding the designor manufacture of the part, device or system.1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference.(2) This device must accept any interference received, including interference that may cause undesired opera-tion.2. Changes or modifications not expressly approved by the party responsible for compliance could void theuser's authority to operate the equipment.RF warning statement:The device has been evaluated to meet general RF exposure requirement of a mobile device. It is designed to operate and should be placed in an area with a minimum separation distance to nearby persons ofat least 20 Centimeters. Long Range Systems, LLC4550 Excel Parkway, Suite 200, Addison, TX 75001www.pager.net •214.553.5308Long Range Systems 3TR-7400 Quick GuideXU-0055 061014

Navigation menu