Long Range Solutions TX3B25A Short range push for service transceiver User Manual Layout 1

Long Range Systems, LLC Short range push for service transceiver Layout 1

Users Manual

To Assemble the Table Genie1. Remove Table Genie from packaging.2. Contents will include:• 1 Table Genie• 1 Table Plate• 1 Double-side foam tape• 1 AA Battery3. Pull the release tab back, then lift and removethe battery cover.4. Insert the AA battery.5. Reassemble the Table GenieTo Mount the Table Genie To the Table:1. Choose to either use Double sided Foam Tape or3 screws to hold the Table Plate to the Table.2. Secure Table Plate to the Table.3. Slide the Table Genie onto the Table Plate.Push For Service Monitor 1. Press ENTER.2. Press EXIT.Long Range Systems 1Table Genie Quick GuideTable GenieSystem Interface TransmitterQUICK SETUP & OPERATION Release Tab of Battery Cover Pull in Direction of ArrowsBatteryPush For Servicewww.pager.net
Associating Table Genie1. From the Setup menu select SYSTEM TOOLS.2. Select WPAN.3. Select Associate (the unit will stay in associate for 5 minutes and then associatewill have to be restarted.)4. Install a battery in the Table Genie and press all 3 buttons after the unit begins toflash. Then:• The buttons will light back and forth.• The buttons will flicker rapidly.• The buttons will go out.• The popup will ask for the entry of a table number.5. Repeat steps 3 and 4 until all units are associated.6. To exit, press EXIT on T7502.Note: If unit fails to join, remove battery, put unit aside, and repeat process after allother units are joined.Operation1. When a button is pressed on the Table Genie, a table number will be displayedand timer will start on the monitor.2. The last pressed button on the Table Genie will blink until cleared.3. To clear a unit, use the user defined cancel sequence (see user manual to change.)4. When cleared, the button will stop flashing and the monitor will clear.5. If the table monitor is not cleared• Within a preset time, the color for that table will change to yellow. • If the table is still not cleared after another preset time, the monitor for that tablewill turn red and the manager will be paged.• The manager will periodically be re-paged until the table is cleared. Setup for Table Genie OperationFrom the Setup menu select GLOBAL SETTINGS.1. Select OPERATION MODE then Push For Service Monitor 2. Press ENTER.3. Press EXIT.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received,including interference that may cause harmful interference.Warning: Changes or modifications not expressly approved by Long Range Systems could void the user'sauthority to operate the equipment. Long Range Systems 2Table Genie Quick GuideXU-0058 091114

Navigation menu