Lorex Technology MC2110 RF MODULE DIGITAL INTERFACE User Manual Module Rev 1
Lorex Technology Inc. RF MODULE DIGITAL INTERFACE Module Rev 1
Contents
- 1. Users Manual
- 2. Revised Users Manual
Users Manual
DOC NO:Preliminary 1.0 User Manual CUSTOMER PRODUCT 2.4GHz Wireless Digital Transceiver Module MODEL NO. DRF-TR001( LW2110, LW2110PK2B) DATE Nov. 2007 義聯科技股份有限公司 ELANsat Technologies Inc. 5F, No.12, Innovation Road Ⅰ, Science-Based Industrial Park, Hsin-chu, Taiwan, R.O.C. TEL:+886-3-563-5105 FAX:+886-3-563-5107 http://www.elansat.com E-mail:sales@elansat.com DRF-TR001( LW2110, LW2110PK2B) Wireless Digital Transceiver ELANsat Features Auto ACK & retransmit On the air max. data rate 2Mpbs Digital interface (SPI) speed 0~8 Mbps Software selectable channel form 2402MHz to 2478MHz (77 Selectable channels) Short switching time enable frequency hopping Power supply range: 3 V to 3.6 V Minimum number of external component Low power consumption: 3.3V, 30mA Transmission distance: 100 m (Line of sight) Outline: 23.2 x 20.8 x 4.3 mm 47 CFR Part 15 Subpart A Section 15.21 Applications Keyless Entry Wireless data communication Alarm and security systems – Wireless home security, Video Door Bell, Video door phone Home automation Surveillance – Wireless P-CAM, Video Baby Monitor Automotive – Wireless Vision-Based Robotic System, Automotive Accessory Telemetry Intelligent sports equipment, Video Rockie-Talkie Industrial sensors Toys – Camera Radio Controlled Toy Wireless Photo Frame Benefits Ready for production Reduce time to market Remove complicity of RF design No RF experience require No expensive RF equipment require Plug and play No fuse on turning and trimming No need for expensive external antenna 2007.12.06 Version: 1.0 Page 1 of 7 www.elansat.com DRF-TR001( LW2110, LW2110PK2B) Wireless Digital Transceiver ELANsat Specification Parameter Limits Unit MIN TYP MAX Supply Voltage 3.3 3.6 Supply Current in Tx mode 23 30 33 mA Supply Current in Rx mode 17 18 19 mA Power Section Digital Input Section High level input voltage 2.1 2.25 Vpp Low level input voltage 1.08 Vpp High level output voltage 2.7 3.6 Vpp Low level output voltage 0.3 Vpp 2525 MHz MHz 16 dBm Digital Output Section RF Section Frequency Range 2400 Channel Bandwidth 1.8 TX Power 12 RX Sensitivity 14 -81 dBm Operation Operating Temperature 2007.12.06 Version: 1.0 -10 +60 Page 2 of 7 ℃ www.elansat.com DRF-TR001( LW2110, LW2110PK2B) Wireless Digital Transceiver ELANsat Pin Configuration and Mechanical Information 2007.12.06 Version: 1.0 Page 3 of 7 www.elansat.com DRF-TR001( LW2110, LW2110PK2B) Wireless Digital Transceiver ELANsat Pin Description No. Symbol VCC Power Supply GND Ground IRQ Maskable interrupt pin MISO Master Input, Slave Output (output from slave) MOSI Master Output, Slave Input (output from master) SCK Serial Clock (output from master) CSN Chip Select CE 10 GND 2007.12.06 Version: 1.0 Function Chip Enable Activates RX or TX mode Ground Page 4 of 7 www.elansat.com DRF-TR001( LW2110, LW2110PK2B) Wireless Digital Transceiver ELANsat PCB layout guideline Any metal (including PCB track and holding screw) around the antenna will result in changing impedance and radiation pattern of the antenna. These two parameters are the most important for antenna performance. Reserve space around the antenna as much as possible. Connect all parts as close as possible to the pins of module and reduce the length of routing traces, to help on good audio performance, proper antenna pattern and EMC. When designing the receiver module in wireless speakers and headphones, the important design considerations are as follows: 1. Keep metal objects away from the antenna by 3 cm distance at least to avoid degradation on the antenna. For example, speaker unit, transformer, adaptor, wire, cable and other big metal object beside antenna will degrade the antenna performance. 2. Use regulated DC-power-supply to the modules, and separate the DC-power-supply of module with the other circuits. Antenna 1. Wire Antenna: A 27~31mm plastic-covered wire can be used as antenna. In principle, 31mm length is for a wire without any cover or very thin cover. The thicker of the cover, the shorter of the antenna length. Try various length for a certain wire to optimize the transmission distance. 2. Antenna Soldering: standrd equipment The module is the only antenna that may be used TYPE:C1073-510001-A(SSR-80521) 2007.12.06 Version: 1.0 Page 5 of 7 www.elansat.com DRF-TR001( LW2110, LW2110PK2B) Wireless Digital Transceiver ELANsat Operation Block Diagram of DRF-TR001 The SPI data then is fed to SOIC for encoding, FSK-modulation, frequency conversion, and amplification. RF signal between SOIC and antenna is separated to two paths: transmission and receiving (by two RF switches). Transmitted RF Signal from SOIC is following by a power amplifier to increase output power and transmission distance. RF signal between SOIC and antenna is separated to two paths: transmission and receiving (by two RF switches). Transmitted RF Signal from SOIC is following by a power amplifier to increase output power and transmission distance. FCC Transmitter Notice: This equipment has been certified and found to comply with the limits regulated by the FCC 47 CFR part15, subpart A Section 15.21. You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user's authority to operate the equipment. 2007.12.06 Version: 1.0 Page 6 of 7 www.elansat.com (LW2110, LW2110PK2B) UCZM2110 15.247 8:2010 8575A-LW2110 UCZM2110 8575A-LW2110 Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. This radio transmitter (identify the device by certification number, or model number if Category II) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No XMP Toolkit : 3.1-701 About : uuid:26db0675-75b9-436c-af04-d92b468b917c Producer : Adobe PDF library 9.00 Company : elansat Source Modified : D:20071206100630 Creator Tool : Adobe Illustrator CS4 Modify Date : 2011:06:24 16:53:09+08:00 Create Date : 2011:06:10 12:19:42+09:00 Metadata Date : 2011:06:24 16:53:09+08:00 Thumbnail Format : JPEG Thumbnail Width : 184 Thumbnail Height : 256 Thumbnail Image : (Binary data 14862 bytes, use -b option to extract) Document ID : xmp.did:160766521893E011A429D27381C2CFC6 Instance ID : uuid:0f5e2fe5-8abb-4d45-99b0-4ed07ab602f6 Original Document ID : uuid:789539bb-d1be-49e5-bf36-c97fcbfd8998 Rendition Class : proof:pdf Version ID : 3 Derived From Instance ID : uuid:87302482-d5f4-45f4-a996-a3d24ee3f4e2 Derived From Document ID : uuid:789539bb-d1be-49e5-bf36-c97fcbfd8998 Derived From Original Document ID: uuid:789539bb-d1be-49e5-bf36-c97fcbfd8998 Derived From Version ID : History Action : saved History Instance ID : xmp.iid:160766521893E011A429D27381C2CFC6 History When : 2011:06:10 12:19:41+08:00 History Software Agent : Adobe Illustrator CS4 History Changed : / N Pages : 1 Has Visible Transparency : False Has Visible Overprint : False Max Page Size W : 209.980465 Max Page Size H : 297.039061 Max Page Size Unit : Millimeters Font Name : CenturyGothic, ArialMT, TimesNewRomanPS-BoldMT, Tahoma, PMingLiU, MingLiU, DFKaiShu-SB-Estd-BF Font Family : Century Gothic, Arial, Times New Roman, Tahoma, 新細明體, 細明體, DFKaiShu SB-Estd-BF Font Face : Regular, Regular, Bold, Regular, Regular, Regular, SB-Estd-BF Font Type : Open Type, Open Type, Open Type, Open Type, TrueType, TrueType, Unknown Font Version : Version 2.35, Version 3.00, Version 3.00, Version 3.15, Version 3.21, Version 3.21, Version 3.21 Font Composite : False, False, False, False, False, False, False Font File Name : GOTHIC.TTF, ARIAL.TTF, TIMESBD.TTF, TAHOMA.TTF, mingliu.ttc, mingliu.ttc, mingliu.ttc Plate Names : Cyan, Magenta, Yellow, Black Swatch Group Name : 預設色票群組 Swatch Group Type : 0 Format : application/pdf Title : Module User Manual(Rev-1 Creator : alex Subject : Headline : Has XFA : No Page Count : 8 For : opcom, Bounding Box : 54 82 563 790 Container Version : 9 Creator Version : 11 Author : alex Image Height : 708 Image Width : 509 Image Size : 509x708 Megapixels : 0.360EXIF Metadata provided by EXIF.tools