Luxul Wireless XAP1410 High Power AC1200 Dual-Band Wireless AP User Manual 1223

Luxul Wireless High Power AC1200 Dual-Band Wireless AP 1223

Contents

User Manual (Statements) rev 2.pdf

REGULATORY COMPLIANCE AND SAFETY NOTIFICATION
This documentation contains regulatory compliance and safety information for both wireless and non-wireless hardware. Not all the information contained in
this document applies to every product.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
Regulatory Compliance
The device complies with internationally recognized standards covering human exposure to electromagnetic elds from radio devices. This equipment also
complies with FCC radiation exposure set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency
exposure limits, human proximity to the antenna shall not be less than 24cm (9.4 in) during normal operation.
Unauthorized antennas, modications, or attachments could cause damage and may violate regulatory approvals. Any changes or modications not
expressly approved by the party responsible for compliance could void the authority to operate the equipment.
Luxul equipment marketed in the U.S. is restricted to usage of channels 1-11 only for 2.4GHz and channels 36-48/149-165 for 5GHz.
FCC Statement—Wireless FCC 2.4GHz & 5GHz 802.11b/g/n/ac
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with part 15 of the FCC Rules.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrol led environment. This equipment should be installed and operated with
minimum distance 24cm (9.4in) between the radiator & your body.
Warnings and Safety Information
* Verify that the electrical circuits have appropriate grounding and overload protection.
* Attach only approved power cords to the device.
* Verify there is adequate ventilation around the device, and that ambient temperatures meet equipment operation specifications.
* DO NOT install in or near hot or humid places, such as a kitchen or bathroom. Take care to minimize exposure to excessive heat or moisture.
* Small parts and plastic bags used for packaging may be harmful to small children. KEEP ALL ACCESSORIES OUT OF THE REACH OF CHILDREN!
* This product may become hot when in use for extended time periods. This is normal and is not a malfunction. DO NOT install where it will be exposed to
paper, cloth or other flammable materials.
* For operation within 5.15-5.25GHz GHZ frequency range, it is restricted to indoor environment
Health and Safety Recommendations
Warnings for the use of Wireless Devices: Please observe all warning notices with regard to the usage of wireless devices
Potentially Hazardous Atmospheres: You are reminded of the need to observe restrictions on the use of radio devices in fuel depots, chemical plants, and
other similar areas where the air contains chemicals or particles (such as grain, dust, or metal powders).
Safety in Hospitals: Wireless devices transmit radio frequency energy and may affect medical electrical equipment. When installed adjacent to other
equipment, it is advised to verify that the adjacent equipment is not adversely affected.
RF Exposure Guidelines
Safety Information: The device complies with internationally recognized standards covering human exposure to electromagnetic fields from radio devices.
Warning: Exposure to Radio Frequency (RF) Radiation :
The radiated output of this device is below the FCC radio frequency exposure limits. Nevertheless, the device should be used in such a manner that the
potential for human contact during normal operation is minimized.
* The end user must avoid any extended human RF exposure directly in front of the device, up to a distance of 24cm (9.4in), when unit is on.
* When servicing the equipment and selecting a location for the antennas, it is important to note that a minimum distance of 24cm (9.4in) is required
between personnel and the device or antenna to comply with the radio frequency exposure limit.
* The antenna used for this transmitter must be installed to provide a separation distance of at least 24cm (9.4in) from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.
The following safety precautions should be observed:
* Do not touch or move the antenna while the unit is transmitting or receiving.
* Do not hold any component containing the radio such that the antenna is very close or touching any exposed parts of the body, especially the face or
eyes, while transmitting.
* Do not operate the radio or attempt to transmit data unless the antenna is connected; this behavior may cause damage to the radio.
Industry Canada (RSS-Gen Issue 4)
This device complies with Industry Canada licence-exempt RSS-247 standard(s). Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2)this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR-247 d’Industrie Canada applicables aux appareilsradio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1)l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain
Canadian information on RF exposure and compliance.
Le dispositif rencontre l’exemption des limites courantes d’évaluation dans la section 2.5 de RSS 102 et la conformité à l’expo-si tion de RSS-102 rf,
utilisateurs peut obtenir l’information canadienne sur l’exposition et la conformité de rf.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated
with a minimum distance of 30 centimeters between the radiator and your body.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu’aucune autre antenne ou émetteur. Cet équipement devrait être installé et
actionné avec une distance minimum de 30 centimètres entre le radiateur et votre corps.
Caution :
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite
systems;
(ii) the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be such that the equipment still complies with the e.i.r.p. limits
specified for point-to-point and non-point-to-point operation as appropriate; and
Avertissement:
(i) les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont réservés uniquement pour une utilisation à l’intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux;
(ii) le gain maximal d’antenne permis (pour les dispositifs utilisant la bande de 5725 à 5 850 MHz) doit être conforme à la limite de la p.i.r.e. spécifiée pour
l’exploitation point à point et l’exploitation non point à point, selon le cas;
CAN ICES-3(B)/NMB-3(B)

Navigation menu