MD Consumer Electric MC-RH15W33 induction cooker User Manual 4

Guangdong MD Consumer Electric Manufacturing Co., Ltd induction cooker 4

User Manual

C15-RH15W33P0000000894443 ২֢愨ࣥ׻Mୢ࣍঻'͹ޏ࣍ߎԥ਩ԭӳՅவԭӳ^SSՊ޾ઓڣ澝םӊ؁࠾؁௤ЉشйȕSS!澝شӊ؁࠾؁௤ЉشйȕSS!澝Ȕ/3658:'4:9',+-;'8*9ȕͫȔ9'<+:.+9+/49:8;):/549ȕঈટͫҿ؁௤ЉشйSS澞澝Ȕ*'4-+8ȕͫȔ='84/4-ȕ۪ͫȔ)';:/54ȕঝѷԥટځࡁҿѕ߶જ୉ऩ澝ॳӟ
C15-RH15W33
CONTENTSIMPORTANT SAFETYGUARDS 1-3USING YOUR APPLIANCE 6-8PRODUCT INTRODUCTION 3-6WARRANTY 10SPECIAL DECLARATION 10CLEANING AND MAINTENANCE 8-9
1 When using electrical appliances, basic safety precautions should always be followed including the following: 2. Do not touch hot surfaces.Use handles or knobs.3. To protect against electrical shock do not immerse cord, plugs, or in water or other liquid.4. Close supervision is necessary when any appliance is used by or near children.5. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts.6. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair , or adjustment.7. The use of accessory attachments not recommended by the appliance manufacture may cause injuries.8. Do not use outdoors .household use only.9. Do not let cord hang over edge of table or counter, or touch surfaces. 10. Do not place on or near a hot gas or electric burner, or in a heated oven.11. Extreme caution must be used when moving an appliance containing hot oil or other hot liquids.12. $OZD\VDWWDFKSOXJWRDSSOLDQFH¿UVWWKHQSOXJFRUGLQWR the wall outlet. To disconnect, turn any control to “offf”, then remove plug from wall outlet.13. Do not use appliance for other than intended use.14. If cook-top should break, cleaning solutions and spillovers may penetrate the broken cook-top and create a risk of electric shock.15. If a wet sponge or cloth is used to wipe spills on a hot cooking area, be careful to avoid steam burn, some cleaners can produce noxious fumes if applied to a hot 1. Read all instructions.IMPORTANT SAFETYGUARDS
219. Do Not Cook on Broken Cook-T op – If cook-top should break, cleaning solutions and spillovers may penetrate the broken cook-top and create a risk of electric shock.20. Clean Cook-T op with Caution – If a wet sponge or cloth is used to wipe spills on a hot cooking area, be careful to avoid steam burn, some cleaners can produce noxious hfumes if applied to a ot surface.18. Do not open lid when in use. surface.16. Do not place metallic objects such as knives, forks, spoons and lids on the Table Stove since they can get hot.17. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way.This device complies with Part 18 of the FCC Rules.FCC STATEMENT;NOTE: 1.This equipment has been tested and found to comply with the limits for a Consumer ISM equipment, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in 3. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.2.Please note that changes or modifications of this product is not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
3a) Technical dataSAVE THESE INSTRUCTIONS.-- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experien for help. ced radio/TV technicianI.PRODUCT INTRODUCTIONModel Appliedvoltage/Frequency Ratedpower Netweight Dimensions 120V~ 60HzC15-RH15W331500W 3.2Kg H64.5xL296xP380mm
4b) Induction cooker descriptionControl panel :1. Soup5. Boil 6. Steam3. Vegetable7. On/Standby4. Keep Warm 8. Power regulating9. Slider 10Timer2. Meat 1 2 3 4 5 698 71 0
5c) Before the first use-When unpacking your unit, make sure that you carefully remove all of the packagingmaterials.-Before using the appliance for the first time, be sure that it is placed horizontally at least10 cm away from all sides of the wall, curtains, etc.-Use an individual socket with more than 15A capacity. Never use a universal socket orshare a socket with other appliances. If the use of a multiple socket is indispensableassure that those elements respect the limit power. The appliance must be place on aflat, firm and dry surface. Never move the appliance when it is in process.-When using the appliance you can hear a noise due to high frequency electromagneticwave. This is normal and non dangerous.d) Suitable and unsuitable pots and containersIt’s necessary to use suitable pots and containers. Pan test with a magnet: if the magnet "sticks"to the base of the pan, then it is suitable for use with induction cooking. You can also refer tothe following description:Hot Pot Stainless steal potRequirement for pot materials: containing magnetic induction materials. All the test andauthentication of thus product is based on the hot pot (bottom diameter 230mm).The other cookware can not guarantee the best results and performance.Shape requirement: if you do not use the distribut hot pot, you'd better use the pots with adiameter from 14.5~21cm for the better cooking effect.e) Safety pack-Control Lock (10). This pad allows locking all the control panel to simplify the cleaningbut also to preserve and safe children from all risks.Enamel cookingustensilEnamel stainlesssteal kettle-Over current or voltage abnormality protection. When voltage is abnormal orcurrent changes abruptly, the induction cooker will stop. Once the issues are solved, theinduction cooker will work again normally.-Container detection system. If a pot is moved during process, the unit will stopheating immediately. The appliance will emit a sound and a few seconds later(no more than 10 seconds) it will automatically return to standby mode.-Automatic shutdown protection . When the time selected is reached, the inductioncooker will shut off automatically until the user triggers the timer again.
6a) Use of the control panel-The sensitive pads work with a sense of touch. It is not necessary to put pressure on.-Use the base of your finger and not the tip as indicated on the images below-Slide your finger on the slider to increase or decrease the power.-You will hear a beep each time an action will be registered.-The control panel must be clean, dry and not be covered by an object or a cloth; even athin layer of water can create dysfunction.b) Starting your applianceAfter the power supply is connected, the buzzer sounds and the screen show "L" or "H" blinking, indicating that the hotplate is in a state of standby. So that the appliance isready to beprogrammed, press on On/standby (7) . After pressing this button, the inductioncooker enters standby mode. Then you can press the function button to enter the working mode.Never put an empty container on the ceramic plate after switching on the appliance.Note:Under the standby mode, if no function button is pressed for about a few seconds later(no more than 10 seconds), the inductioncooker will switch off automatically.Under the working mode, if there is no proper pot on the ceramic plate, the induction cooker willswitch off automatically a few seconds later(no more than 10 seconds).c) Power functionIn order to select the power intensity you can:--Or choose the function，press the slider, by swiping your finger from left to right on thebutton.To guide you, lights appear above each power level.II.USING YOUR APPLIANVEChoose the function，press the + (8) or – (9) buttons
d) Using the different functionsTimer7To use this mode, press on the Soup button. A lamp lights up. The default power level shall be level 10. Under this mode, the power can be adjusted, when press “+” or “-“or slider. And the appliance keeps heating at the adjusted power until the default time or the time set by the user.The default heating time is 60 mins, and the appliance counts.Soup modeVegetable modeTo use this mode, press on the Vegetable button. A lamp lights up. The default power level shall be level 9. Under this mode, the power can be adjusted, when press “+” or "-" or slider. And the appliance keeps heating at the adjusted power until the default time or the time set by the user. The default heating time is 180 min, and the appliance counts.Meat modeTo use this mode, press on the Meat button. A lamp lights up. The default power level shall be level 10. Under this mode, the power can be adjusted, when press “+” or "-" or slider. And the appliance keeps heating at the adjusted power until the default time or the time set by the user. The default heating time is 180 min, and the appliance counts.Boil modeNote: It is recommended to put water that occupies 30% to 80% of the pot capacity whenboiling water.Boil mode is for boiling water. To use it, press on the Boil button. A lamp lights up. The default power level shall be level 10. In this mode, the default working time is 40 minutes. The power cannot be adjusted. The user cannot set time by himself. When the water is boiled, press the On/Standby button to turn it off.Keep warm modeWhen the appliance is in operation, press on the Keep warm button if you want to keep warm your preparation. The appliance will set automatically on the lowest power and will stop after 120 minutes, and the appliance counts. Under this mode, the power cannot be adjusted.--Press the“Timer”button to enter the timer mode. When the timer indicator lights up and the numbers blink on the display, press the “+” or “-” button to adjust the time duration.--When the adjustment is finished, the number on the display will be shown after blinking for several seconds. The induction cooker starts counting down. When the counting down is over, the induction cooker automatically stops heating and switches off.--The induction cooker will shut down when the default timer is reached unless the user sets the timer himself.NOTE：The timer cannot be used under the Boil mode.
8e) Switch off the applianceAfter use, the electric hob is hot, the buzzer rings and the indicator « H » flashes on thescreen. To switch off the appliance, press on the On/Standby button (7), then unplug thesocket.Please, refer below table for wattage:a) Cleaning the induction cookerSwitch off and unplug the appliance. Let it cool down before cleaning.Regarding the glass-ceramic and the control panel:฀Light dirt: clean with a soft wet cloth.฀Oily dirt: clean with a soft wet cloth dipped with little toothpaste or neutraldetergent until the removal of residuals.Note: during the cleaning, never clean the surface of the induction cooker with arigid brush.Regarding the air entry and the air ventAfter a long time of use, some dust or other dirt may be accumulated at the air entry or airvent. Use a flexible brush or a detergent to clean it. The body of the appliance can becleaned with caution with a dry cloth.Note: never immerse the induction cooker in the water and do not maintain it witha steam cleaner.120 300 400 600 800 900 1000 1100 1300 1500III.CLEANING AND MAINTENANCESteam modeTo use this mode, press on the Steam button. A lamp lights up. The default power level shall be level 10. Under this mode, the power can be adjusted, when press “+” or “-“or slider. And the appliance keeps heating at the adjusted power until the default time or the time set by the user. The default heating time is 60 min, and the appliance counts down.
9b) TroubleshootingHere are the recommended inspections of common failures:kcehcotstnioPsmelborPAfter the plug in the socket, the indicator(1) and the screen do not light up.-Make sure that the plug is insertedtightly. - Make sure that the switch,socket, fuse and power line are in goodcondition.The button (1) lights up but heating doesnot start.-Make sure that the containers aresuitable for induction cooker.- Sent it to service facility to repairHeating stops suddenly during operation.-Let the appliance cool down- Let air entry and air ventfree - Set again the timing-Refer to failure codesE3, E6,EAAfter a moment, temperature inside thecooker returns to normal. The unit canrestore its work once the « on/off » buttonis pressed.E7, E8 After adjusting the voltage, the unitrestores its work.FailurecodesE1, E2, E4, E5, EB Send it to service facility to repair.
10

Navigation menu