User Manual
On-the-Go Bluetooth Speaker
User’s Guide for Model ISB19 v2128-01
Protect for Today
Sustain for Tomorrow
Made
Green
Specications are subject to change without notice.
Copyright © 2019 Digital Products International (DPI, Inc.)
All other trademarks appearing herein are the property
of their respective owners.
Contact Information
Website: www.iLiveElectronics.com
Email Support: prodinfo@dpiinc.com
Email Parts: partsinfo@dpiinc.com
Phone Support: 1-888-999-4215
Warranty
For Warranty Information and the most
up-to-date version of this User’s Guide, go to:
www.iLiveElectronics.com.
FCC WARNINGS
WARNING: Changes or modications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure
condition without restriction.
ADDITIONAL WARNINGS
• WARNING: To prevent re or shock hazards, do not expose
this unit to rain or moisture.
• WARNING : Where the mains plug or appliance coupler is
used as the disconnect device, such disconnect device shall
remain readily operable.
• Lithium batteries, like all rechargeable batteries, are
recyclable and should be recycled or disposed of according to
state and local guidelines. They should never be disposed of in
normal household waste and they should never be incinerated,
as they might explode. Contact your local government for
disposal or recycling practices in your area.
WARNING : This product can expose you to
chemicals including lead, which is known to the State
of California to cause cancer and birth defects or other
reproductive harm. For more information go to www.
P65Warnings.ca.gov. This product meets and complies
with all Federal regulations.
Previously Connected Devices
• It is not necessary to perform the Bluetooth
Connection every time, just press and hold the
power button until the unit powers on.
• The speaker can remember multiple Bluetooth
devices and will always try to re-connect to the
last device used.
• To re-connect to a dierent device, turn o
Bluetooth on unwanted devices, then access the
Bluetooth settings menu on the device you wish
to use and select ISB19.
• If the speaker should become unpaired or will
not connect normally, follow these steps in your
device’s Bluetooth Settings Menu.
» Delete the speaker (“Forget This Device”).
» Turn Bluetooth OFF then ON again, and
repeat the Initial Bluetooth Connection.
ISB19-v2128-01-IB.indd 1-5 30/05/2018 9:46:06 AM
DC IN
Features
• Bluetooth wireless range: 60 ft.
• Voice prompts announce speaker functions
• Durable rubberized coating
• Built-in rechargeable battery: approx. 2.5 hrs
playtime at 100% volume
Includes
• USB charging cable
• User’s Guide
Overview
Power Status Indicator Light
Low Battery Flashing red light
Charging Solid Red light
Finished Charging Light OFF
Charging the Battery
Initial charge time is approximately 2 hours. For best
performance, charge fully before use.
• Use a Micro-USB to USB cable (included), to
connect to the charging port on the speaker to the
USB port of a powered on computer or USB power
adapter (not included).
Initial Bluetooth Connection
1. Power on and begin pairing by holding the Power
button for 9 seconds, until a voice announces
“Bluetooth is connecting” and the indicator begins
quickly ashing blue. When pairing, remain within
3 feet of the unit.
2. Using the controls on your Bluetooth device,
select ISB19 in the Bluetooth Settings to pair.
If need be, refer to the user’s manual for your specic
device for more information.
3. When successfully paired, a voice will announce
“Bluetooth is connected” and the LED indicator
will turn solid blue. Audio from the connected
Bluetooth device will now play on the speaker.
4. Use the controls on the connected Bluetooth
device to select and play audio.
Micro-USB Charging Port
DC IN
Power / Pair Bluetooth
Press and hold for 9 seconds to power ON and pair Bluetooth.
Press and hold to power ON or OFF.
Volume
Press to adjust volume.
Status Indicator Light
ISB19-v2128-01-IB.indd 6-10 30/05/2018 9:46:07 AM