MOBASE ELECTRONICS SYEC3TX1611 Remote Keyless Entry Transmitter User Manual
SEOYON ELECTRONICS CO., LTD. Remote Keyless Entry Transmitter
User Manual
Title : NO. Information Document Date SHT/SHTS : 2/11 0. GENERAL 0.1. Make SEOYON ELECTRONICS Co.,Ltd. 0.2. Model No. Transmitter : Remote Keyless Entry Transmitter SYEC3TX1611 - Receiver : Body Control Module 0.3. Name and address of manufacturer SEOYON ELECTRONICS Co.,Ltd. 424, Sinwon-ro, Danwon-gu, Ansan-si, Gyeonggi-do, Korea 0.4. Address of assembly plant SEOYON ELECTRONICS Co.,Ltd. 424, Sinwon-ro, Danwon-gu, Ansan-si, Gyeonggi-do, Korea Title : NO. Information Document Date SHT/SHTS : 3/11 2. PRODUCT SPECIFICATION 2.1 Scope of RKE, Body Control Module 2.1.1 Folding TX KEY : It has the RKE functions. Data is transmitted with radio frequency 2.1.2 BCM(RX) : ECU is control the whole BCM funtion with RKE 2.2 SPECIFICATIONS 2.2.1 Transmitter 2.2.2 ITEM SPECIFICATION Rated supply voltage DC 3V Operating voltage range DC 2.5 ~ 3.2V Operating temperature range - 10 ~ + 60℃ with Battery Storage temperature range - 40 ~ + 85℃ without Battery Modulation FSK Frequency 433.92MHz Code Rolling Code(Hopping Algorithm) Electric field strength 10mW (433.92MHz) Battery life 2 Year(10Times/Day)(Lithium 3V 1EA) Item Specification RECEIVER Rated Supply Voltage DC 12V Operating Voltage DC 9 ~ 16V Operating Temperature - 30 ~ + 80℃ Max Humidity 95% Standby Current Below than 5.5mA (in alarm setting condition) Title : NO. Information Document Date SHT/SHTS : 4/11 2.3 Operating summary -RKE ① TRANSMITTER's button is pushed. ② TRANSMITTER sends the code by radio frequency. ③ RECEIVER gets the code and decodes it. ④ RECEIVER judges the code whether it is right code or not. ⑤ RECEIVER checks door lock or unlock, trunk state. ⑥ RECEIVER drives the actuator. 2.3.1 LOCK & UNLOCK ① If LOCK or UNLOCK button is pushed for less than 1 sec, then TRANSMITTER sends the LOCK or UNLOCK DATA. ② If TRUNK button is pushed for more than 1 sec, then TRANSMITTER sends the TRUNK DATA. ③ If PANIC button is pushed for more than 1 sec, thed TRANSMITTER sends the PANIC DATA. 2.4 Caution ② Danger Replace of only with the same or equivalent type recommended by the manufacturer. ① explosion if battery is incorrectly replaced. ③ Dispose of used batteries according to the manufacturer's instructions. Title : NO. Information Document Date SHT/SHTS : 5/11 3. USER MANUAL 3.1 ITEM : Body Control Module - This system is BCM and inculdes RKE. - RKE in BCM system is intended for auto door lock or unlock or TRUNK in vehicle. - This BCM system is to be installde on motor vehicles as *OE item. *OE : Original Equipment. *BCM : Body Control Module *RKE : Remote Keyless Entry. 3.2 SYSTEM CONSTRUCTION 3.2.1 SYSTEM IN VEHICLE ANTENNA BATTERY Radio Frequency (433.92MHz) BCM 3.2.2 SYSTEM FOR TEST ANTENNA BATTERY Radio Frequency (433.92MHz) BCM ① if press button on the transmitter, RF signal is transmitted and turns on the LED * It shows the status of operation through the LED used. FCC Information This device complies with part 15 of the FCC Results. Operation is subject to the following two conditions : (1) This Device may not cause harmful interface, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for CLASS B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correct the interference by one or more of the following measures: 1.1. Reorient or relocate the receiving antenna. 1.2. Increase the separation between the equipment and receiver. 1.3. Connect the equipment into an outlet on a circuit different from that to which receiver is connected. 1.4. Consult the dealer or experienced radio/TV technician for help. WARNING Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. “CAUTION : Exposure to Radio Frequency Radiation. Antenna shall be mounted in such a manner to minimize the potential for human contact during normal operation. The antenna should not be contacted during operation to avoid the possibility of exceeding the FCC radio frequency exposure limit.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Author : hs Create Date : 2016:06:08 18:55:33+09:00 Modify Date : 2016:07:13 09:54:20+09:00 XMP Toolkit : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03 Producer : NesPDF Creator Tool : YB_TX_인증_제품_매뉴얼(영문)_160603.xls Metadata Date : 2016:07:13 09:54:20+09:00 Format : application/pdf Title : YB_TX_인증_제품_매뉴얼(영문)_160603.xls Creator : hs Document ID : uuid:90fd4ca6-4e8f-45c2-bee9-2d4f2ba0bd70 Instance ID : uuid:f1351f9d-6981-4e21-84d1-193170da9540 Page Mode : UseNone Page Count : 5EXIF Metadata provided by EXIF.tools