MOBIWIRE MOBILES F1035 3G feature phone User Manual English
MOBIWIRE MOBILES (NINGBO) CO.,LTD 3G feature phone English
User manual
Contents
1. Charging the battery
2. Audio player
3. Lock and unlock the keypad
4. Change to meeting profile
5.Camera
6.FM radio
7.How to control volume
8.Restore factory setting
1. Charging the battery:
Unplug the charger from the
outlet and the phone when not in
use. Do not leave a fully-charged
handset connected to a charger
because overcharging may
shorten the lifetime of the battery.
If unused, a fully-charged battery
will lose its charge over time.
If the battery is completely
discharged, the charging may not
start immediately when you plug
in the connector. Wait 10 to 15
minutes for the phone to begin
charging.
Use the battery only for its
intended purpose. Never use any
charger or battery that is
damaged.
Use only Entel Charger &
Battery.
Note: The actual operation time
of a battery varies based on the
operation mode, network
strength in different places and
talk time.
2. Audio player:
The songs you store in the
memory card will appear in the
audio player. Please check if you
have stored the songs in “My
Music” folder. You should also
check whether default storage is
memory card.
3. Lock and unlock the
keypad:
Press * then“left soft key”to lock
the keypad.
Press“left soft key” then * to
unlock the keypad.
4. Change to meeting
profile in idle:
Long press # to change the
profile into meeting mode and
long press # again to change the
profile into normal mode.
5. Camera:
Press the OK key to take photos
and the photos will be stored in
the phone.
Press the left navigation key to
Video recorder and press the
right navigation key to camera
again.
6. FM radio:
Radio FM
Press the OK key to open/close
the FM radio.
Press the up and down
navigation key to move
forword/backword 0.1MHz.
Press the left and right
navigation key to switch channel
accroding to the channel list..
It will be exit FM radio interface
when pressing the right soft key
or the red key.And the FM will
be run in the background.
7. How to control volume:
When you call any number you
can control your volume, press
the up&down navigation key to
adjust call volume. You can
control the volume by pressing
the * and # when you listening to
the music ,FM radio or watching
the videos.
8. Restore factory settings:
Reset the phone to default values
(factory settings).
The phone password is required,
which is "0000" by default
La contraseña del teléfono se
requiere, que es "0000" por
defecto.
FCC Caution.
§ 15.19 Labelling requirements.
This device complies with part
15 of the FCC Rules. Operation
is subject to the condition that
this device does not cause
harmful interference.
§ 15.21 Information to user.
Any Changes or modifications
not expressly approved by the
party responsible for compliance
could void the user's authority to
operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been
tested and found to comply with
the limits for a Class B digital
device, pursuant to part 15 of the
FCC Rules. These limits are
designed to provide reasonable
protection against harmful
interference in a residential
installation. This equipment
generates uses and can radiate
radio frequency energy and, if
not installed and used in
accordance with the instructions,
may cause harmful interference
to radio communications.
However, there is no guarantee
that interference will not occur in
a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be
determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of
the following measures:
-Reorient or relocate the
receiving antenna.
-Increase the separation between
the equipment and receiver.
-Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
-Consult the dealer or an
experienced radio/TV technician
for help.
Body-worn Operation
This device was tested for typical
body-worn operations. To
comply with RF exposure
requirements, a minimum
separation distance of 1.5 cm
must be maintained between the
user’s body and the handset,
including the antenna.
Third-party belt-clips, holsters,
and similar accessories used by
this device should not contain
any metallic components.
Body-worn accessories that do
not meet these requirements may
not comply with RF exposure
requirements and should be
avoided. Use only the supplied or
an approved antenna.