User manual
Ankle band
Moov
Wristband
Charging pad
Charging cable
Here’s what’s in the box:
Securing moov in its mount
Charging moov
Hold moov rmly–
We've locked it in tight so it doesn't go ying o on its own mid-workout.
Use your ngernail to get between moov and its mount.
No need to be timid, moov is sturdy.
Detaching moov
Moov hates dying. It'll blink red
when the battery is low and it
wants to be charged.
A green light should glow
while charging.
Lights o? Battery's full!
1
1
2
2
Line up the charging pad's metal pins with moov's pinholes.
Snap moov into place.
1
2
Tilt moov into the mount, matching the grooves on the side.
Snap moov into place with a satisfying click.
1
2
1
1
2
2
Contact us
support@moov.cc
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil nedoit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
This Class【B】 digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Caution
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Battery: 60mAh
Charaging voltage: 5v
FCC ID: 2ACIE-M1507, IC: 12046A-M1507, Model: M1507
© 2014 Moov Inc.
says hello!
www.moov.cc/start
moov | packaging | instruction | rev. 008 | 06092014