MSA Innovation 10154953 G1 RFID Board User Manual

Mine Safety Appliances Company G1 RFID Board G1 SCBA CBRN NFPA

a href="https://usermanual.wiki/MSA-Innovation" itemprop="url"> MSA Innovation >

Contents

G1 Manual v02-3_reduced_part 1

64Cleaning and DisinfectionG1US11 Cleaning and DisinfectionDepending on the cleaning policy adopted, either a designated person or the user should clean each device after each use. ANSI standards suggest that users should be trained in the cleaning procedure. Confidence Plus® Cleaning Solution (P/N 10009971) from MSA is recommended. It cleans and disin-fects in one operation. It retains its germicidal efficiency in hard water to inhibit the growth of bacteria. It will not deteriorate rubber, plastic, glass, or metal parts. Refer to the label for user instructions. If the SCBA is soiled (i.e. heavy smoke residue or dirt accumulation) use a sponge damp with mild soap solution or use a soft/medium bristle brush to remove deposits that may interfere with normal operation of: -Harness (straps and buckles) -Carrier (band and latch assembly) -Cylinder (handwheel, gauge, outlet connection) -Pressure reducer (bell and coupling nut connection) -Control module/power module/battery module/speaker moduleInspect the entire SCBA as it is reassembled. Follow the Inspection Instructions.Preparing SolutionFollow the instructions with the Confidence Plus® Cleaning Solution. If the Confidence Plus Cleaning Solution is not used, wash in a mild cleaning solution, rinse thor-oughly, and submerge in a germicide solution for the manufacturer's recommended time. WARNING-DO NOT use any cleaning substances that can or might attack any part of the SCBA. -DO NOT use alcohol because it may deteriorate rubber parts. -If not rinsed thoroughly, cleaning agent residue may irritate the wearer's skin. Failure to follow these warnings can result in serious injury or death.
65Cleaning and DisinfectionG1US11.1 Cleaning and Disinfection FacepieceIn general, only the facepiece requires cleaning and disinfecting after each use.WARNING-Do not use cleaning products containing hydrocarbons or solvents [e.g. nitro-thinner].-Cleaned parts must not be dried in radiant heat [sun, radiators]. -When using a drying cabinet, the temperature must not exceed 140 °F (+60 °C).-Perform a tightness test after every cleaning, disinfection and maintenance or after every exchange of parts. Failure to follow these warnings can result in serious injury or death.(1) Remove the facepiece mounted regulator from the face-piece. The power supply for the HUD is not part of the G1 facepiece and is therefore not damaged during cleaning of the facepiece.
Download:
Mirror Download [FCC.gov]
Document ID2808696
Application IDq94JMWupXqV5VT5yWwFPeQ==
Document DescriptionG1 Manual v02-3_reduced_part 1
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize270.75kB (3384317 bits)
Date Submitted2015-11-10 00:00:00
Date Available2015-11-10 00:00:00
Creation Date2015-10-28 12:00:51
Producing SoftwareAcrobat Distiller 10.1.10 (Windows)
Document Lastmod2015-10-28 12:00:51
Document TitleG1 SCBA CBRN NFPA
Document CreatorFrameMaker 7.2
Document Author: MSAsafety.com
FCC ID Filing: P9R-10154953

Navigation menu