MTMS B1005R24G 2.4GHz Wireless RC Vehicle - TX Portion User Manual Users manual

Download:
Mirror Download [FCC.gov]
Document ID	3335665
Application ID	WQkiZ6cX6waflLoJwAtIgw==
Document Description	Users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	155.26kB (1940772 bits)
Date Submitted	2017-03-28 00:00:00
Date Available	2017-03-28 00:00:00
Creation Date	2017-03-27 21:11:02
Producing Software	Foxit Reader PDF Printer Version 7.1.0.112
Document Lastmod	2017-03-27 21:11:09
Document Title	Users manual

TROUBLESHOOTING
Problems Reasons Solutions
The batteries inside the radio controller
are too weak
Replace with new Alkaline batteries.
There is a weak or low reception to the
Running Problems _
radio controls.
The batteries inside the vehicle are Replace with new batteries inside
too weak. the vehicle.
Turn the Onioti Swlwh ol the vehicle
Chisels ohm-ml "is movement 0' the in ‘0FF' position Remove obstructions
wheels. by using tweezers and caretuily pullout
Operating Problems tangles.
The momrfi/cle was driven on rough
terrain and something get caught in the
wheels.
it is recommended to run the vehicle
on a tlat and hard suriacc cr pavement.
The ”We “095 "0‘ Veswnd '0 “‘9 Try running it on another location
radio control
other .
Some other equipment using the same
The radio conlml‘s Itsqusncv Is disrupted radio wave could disrupt transmission.
by something around the enwmnmem- Either run the vehicle in another location
or turn on the other equipment.
PLEASE NOTE:
This equipment has been tested and round to comply with the limits tor a Class a digital device. pursuant to pants
01 the FCC Rules. These Ilmlls are deslgned to provide reasonable prolecuon agnlnst harmlul Imenerenoe In a
residential inetsiietion. This equipment generates. uses and can rs are radio frsquancy energy and. it not installed
and used in accordance with th siructions. may cause harmiui interrerence to radio communications. However,
there is no guarantee tnaI interierence will not occur in a particular installation. II this equipmentdoes cause narmrui
interterenoe to radio or television reception. which can be determined by turning the quipmenl oti and on. the user
is encouraged to try to correct the intertcrcnce by one or more oi the Ioiiowing measures:
- Reorient or relocate the receiving antenna.
. increase Ihe separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit d rent Irom that to which the receiver is needed.
- consult the dealer or an experienced radio/TV tecnni an Ior neip.
MADE IN CHINA
ITEM NO. B1005
5+
MADE IN CHINA
MOTOCROSS BIKE
Radio Control
INSTRUCTION MRNUFIL
IF MOTORCYCLE DOES NOT RESPOND PROPERLY, PLEASE REPLACE
*IMPORTANT: THE BA1TERIES iN VEHICLE (It-AA NOT INCLUDED) AND CONTROLLER
(2-AA NOT INCLUDED).
” NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED EV UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD
VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible ior compliance could void the
user's authority to operate the equipment.
This device complies with Part 15 or the Eco Rules. Operation is subicct to the Ioiiowing two conditions:
i. This device may not cause harmful interterence. and
2. This device must accept any intericrence received. including intcricrence that may cause undesired operation.
Do NOT MIX ALKALINE.
STANDARD (CARBON-ZINC),
olt HECHMGEABLE BATTERIES. “mum“ 4 M“ BAHER'ES
IN VEHICLE AND 2 AA BATTERIES
no not Mix OLD AND um I" CONTROLLER-
BATTEHIES- COLORS AND DECORATIONS MAY
VARY KEEP CONTENT DETAILS
Do NOT DISPDSE 0F DAITEiiles
IN FIRE, BATTERIES MAV FOR FUTURE REFERENCE,
EXPLDDE on LEAK.
EmTENT LIST
To prevent damage. the contents
oi the package listed are properly
packed and may be out at plain
sight Please remove all coniehis
in packaging.
A CAUTION:
DO NOT MODIFY TOY
IN ANY WAV. ADULT
SUPERVISION IS
ADVISED!
CONTROLLER
SETTING TO KNOW YOUR MOTOCROSS BIKE
MOTOCROSS BIKE
Fully Deiailed Rider
LED Power
Indicator
Forward/Brake
Control
Front Wheel
Steering Spokes Rear Wheel
Suspension Len/Right
Control
Bane
33:2;an Onlott SWIICI’I Compartment
BFITTERY INSTRLLFITION
Diagram 2
I) Make sure the motorcycle is in FF" position.
2) Using a crosshcad screwdriver. unscrew the battery oompanment
cover located at the bohom
3) Insen 4 AAA batteries (not included) lrIID the motorcycle. according
to the correct polarities (as shown),
4) Replace the battery cover. 'hghten screw
Do NOT Mix ALKALINE. STANDARD (CARBONVZINCI. OR
RECHARGEABLE BATTERIES.
Do NOT Mix OLD AND NEw aATTERlEs.
DO NOT DISPOSE or aATTERlEs IN ElRE.
BATTERIES MAY EXPLODE 0R LEAK
it Make sure the controller is in “OFF" position
at Push and slide down the battery companment cover located in the back. fl
3) lnaen 2 AA batteries that included) into the controller, according to the
correct polarities (as shown).
4) Replace the battery cover
PLEAsE NDTE: iq “
A) Make sure the batteries are inserted correctly [4 or -l into the controller. ‘ . i
B) It the vehicle does not respond roperly. please replace the Alkaline
batteries in the controller or rec aige balleries.
t. Make sure you nlwnys use new ortuiiy charged batteries I. Nari-rechargenble batteries are not to be recharged.
i the Dnmlllr. z Rechargeable bait-rise are ontyto be charged under adult
2. Do not (warm the motorcycle it it becomes damaged in supervision.
any way. 1 Rechargeable batteries are to be removed lrom the toy
:I. chock triattito innarod elonai Item the carnrciisr Is making better. being charged.
a connection witntne vehicle betore operating. 4. Dnrerent types or batteries or new and used batteries are
4. Try notto crash the motorcycle as itmay cause damage. not to be ed.
5. Check that in. area to clear or my obstacles boloro you s Darts s an to be inserted with the comet polarity.
operate. a Exhausted batteries are to be removed tic the toy.
5. Adult supervision is always recommended.
1. Never operate near animals. Keep mDIqutzle away trom
youriingers. hair. eyes and other body parts. stay away
trorn ohmcles nnd electrical hazards.
7b The supply terminals are not to be short-ctrcuiledu
LISINEI YOUR MOTOCROSS BIKE
Diagram A
Using the Motorcycle:
ll Turn the Oniolt switch on the motorcycle
lo the “ON' position,
at Turn the On/oli switch on the controller to
the ~0N~ position
3i Place the motorcycle on the ground and use
the controller to maneuver.
Al ii the motorcycle does not respond. turn both
motorcycle and controller switch to ‘OFF‘. then
repeat above steps I and 2.
5i When done operating. return both motorcycle
and controller to the OFF“ position
5i When not being used Ior an extended amount
ol time. remove the batteries trom both the
motorcyle and controller.
DANGERI
NEVER TOUCH THE WHEELS WHEN THEYAHE TURNING.
NEVER lNSERTANy SHARP OBJECTS, PINS OR SCREWS
INTO THE VEHICLE AS Tl-tlS MAV PUNCTURE THE MOTOR
OR THE EA‘I‘TERVI
‘ i ' Len/Right
Turn
NOTE:
Opelalmg mulIlple ROS WlIh the same Irequency In cIDse proximity wlII cause IHISVIBISHCB and poor periormance.
Works best away Iiom electrical hazards and large obsiactes
Do not put obyccis or lingers near the lront or rear oi the wheels while it is turning
Vehicle may not run property on rough terrain. Make sure obieols do not gel obstrucled in the wheels
Avoid hard crashes
Never give the vehicle or controller to any child under the age cl 3. as it contains small pans.
When not in use. remove batteries lrom oompanments tmotorcycic and controller).
Normal working distance is about an leet (24 meters)

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : No
Page Count                      : 1
Has XFA                         : No
Title                           : 
Description                     : 
Subject                         : 
Creator Tool                    : 
Producer                        : Foxit Reader PDF Printer Version 7.1.0.112
Keywords                        : 
Create Date                     : 2017:03:27 21:11:02+08:00
Modify Date                     : 2017:03:27 21:11:09+08:00
Author                          : 
Creator                         : 

EXIF Metadata provided by EXIF.tools