MTN ELECTRONICS MTO-WA718N Wireless AP User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2110732
Application ID	y6DCp8iXfx6/73VJiMvOVQ==
Document Description	User manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	36.6kB (457460 bits)
Date Submitted	2013-11-04 00:00:00
Date Available	2013-11-04 00:00:00
Creation Date	2013-09-28 00:51:56
Producing Software	Microsoft® Office Word 2007
Document Lastmod	2013-10-25 19:31:20
Document Title	User manual
Document Creator	Microsoft® Office Word 2007
Document Author:	微软用户

MTO-WA718N-A1 AP
Quick Installation Guide
VER ： 1.0
1． Module Interface Description:
①
②
③
Antenna
Power (Power Input DC5V to 12V)
V3.3V、RX、 GND、TX（The order from top to bottom）
④
⑤
⑥
LAN
Reset
Indicator(WPS、Wi-Fi、SYS、LAN、PWR)（The order from top to bottom）
After the connection is complete, Check that the LED is correctly:
LED
LED State
Description
POWER
Light
Power status normal
SYS
Light
Start when the system power-on light
LAN
Light
Wired network connectivity
WLAN
Light
Wireless network boot
WPS
Light
One-click encryption started
If the LED is not lit or not properly, check that the connection is correct.
2. AP management interface
a. Set your computer's IP 192.168.0.X network segment; (X is 1-253 integer
between and not 60)
b. With a network cable to connect the computer's Ethernet port and network
interface module;
c. Then the computer's command prompt window, enter ping command; has the
following screen is connected properly;
d. In the computer's browser address bar enter 192.168.0.60; enters the AP
management interface;
Note: It is a user-specified functions of the software; The AP default mode is
Bridge, Wireless mode is Client; User name and password is admin;
e. In this position, the IP address of the LAN can be modified;
f.
In this position you can modify parameters related to wireless;
g. In this position, you can set the wireless encryption;
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment. (Example- use
only shielded interface cables when connecting to computer or peripheral devices)
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment should be installed and operated with minimum distance 20cm between the radiator
and your body.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Tagged PDF                      : No
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Create Date                     : 2013:09:28 00:51:56Z
Creator Tool                    : Microsoft® Office Word 2007
Modify Date                     : 2013:10:25 19:31:20+08:00
Metadata Date                   : 2013:10:25 19:31:20+08:00
Format                          : application/pdf
Creator                         : 微软用户
Producer                        : Microsoft® Office Word 2007
Document ID                     : uuid:df7bfa71-0d62-48a4-936c-660a9d821fbc
Instance ID                     : uuid:79dff7d2-b83b-4eec-8e10-7878b70deb4c
Has XFA                         : No
Page Count                      : 6
Language                        : zh-CN
Author                          : 微软用户

EXIF Metadata provided by EXIF.tools