Honeywell Handheld PID Monitors User's Guide Users
User Manual: Manual
Open the PDF directly: View PDF
Page Count: 106 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- 1. Standard Contents
- 2. General Information
- 3. Physical Description
- 4. Charging The Battery
- 5. User Interface
- 6. Display
- 7. Operating The Instrument
- 8. Operating Modes – MiniRAE 3000+ & ppbRAE 3000+
- 9. Operating Modes – UltraRAE 3000+
- 10. Compound-Specific Operation – UltraRAE 3000+
- 11. VOC Operation – UltraRAE 3000+
- 12. Alarm Signals
- 13. Accessories
- 14. Standard Kit & Accessories
- 15. Optional Accessories
- 16. Standard Two-Point Calibration (Zero & Span)
- 17. Three-Point Calibration
- 18. Bump Test
- 19. Programming Mode
- 20. Programming Mode Menus
- 20.1. Exiting Programming Mode
- 20.2. Navigating Programming Mode Menus
- 20.3. Reverse Direction – Menu Selection
- 20.4. Calibration
- 20.5. Measurement
- 20.6. Datalog
- 20.7. Monitor Setup
- 20.7.1. Op Mode
- 20.7.2. Site ID
- 20.7.3. User ID
- 20.7.4. User Mode
- 20.7.5. Date
- 20.7.6. Time
- 20.7.7.
- 20.7.8. Duty Cycle
- 20.7.9. Temperature Unit
- 20.7.10. Pump Speed
- 20.7.11. Language
- 20.7.12. Real Time Protocol
- 20.7.13. Power On Zero
- 20.7.14. Unit ID
- 20.7.15. LCD Contrast
- 20.7.16. Lamp ID
- 20.7.17. PAN ID
- 20.7.18. Mesh Channel
- 20.7.19. Mesh Interval
- 21. Hygiene Mode
- 22. Advanced User Level (Hygiene Mode Or Search Mode)
- 23. Diagnostic Mode
- 24. Transferring Data To & From A Computer
- 24.1. Downloading The Datalog To A PC
- 24.2. Uploading Firmware To The instrument From A PC
- 1. Connect the data cable to the PC and the cradle.
- 2. Place the instrument into its cradle. The charging LED should be illuminated.
- 3. Start ProRAE Studio II or Honeywell Safety Suite Device Configurator on your PC.
- 4. With ProRAE Studio II, click the “Firmware” icon on the left,side. Then click “Run programmer” to open RAEProgrammer 4000.
- 5. From RAEProgrammer 4000, select “Open” and select the firmware to upgrade
- 6. Select the COM port to establish a communication link between the PC and the instrument.
- 7. Click “Start” button
- 25. Maintenance
- Sensor Components – MiniRAE 3000+, ppbRAE 3000+, MiniRAE Lite+
- 26. Troubleshooting
- 27. Technical Support
- 28. Controlled Part Of Manual
- 29. Basic Operation
- 30. Alarm Signals
- Preset Alarm Limits & Calibration
- 31. Charging The Battery
- 32. Specifications