Marelli Europe S p A EN2 Bluetooth Module User Manual Declaration Warning Statements 15c 15b EN2
Magneti Marelli S.p.A. Bluetooth Module Declaration Warning Statements 15c 15b EN2
Contents
- 1. User manual_Declaration_Warning_Statements_15c_15b
- 2. User manual
User manual_Declaration_Warning_Statements_15c_15b
To Whom It May Concern:
FCC ID: RX2EN2
IC: 4983A-EN2
The Bluetooth Module “EN2” is for OEM installation only.
When integrating the Module into the end product, the final user manual of the end
product will include the following statements for FCC approval:
The end product has to be labeled as follows:
CONTAINS FCC ID: RX2EN2
FCC § 15.19 Labelling requirements
This device complies with part 15 of the FCC Rules and Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC § 15.21 Information to user
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
RF Exposure Requirements
To comply with FCC RF exposure compliance requirements, the device must be installed to
provide a separation distance of at least 20 cm from all persons.
The Bluetooth Module “EN2” is for OEM installation only.
When integrating the Module in the in the end product, the end product and the final
user manual of the end product will include the following statements for Industry
Canada approval:
The end product has to be labeled as follows:
CONTAINS IC: 4983A-EN2
INDUSTRY CANADA Statements
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
RF Exposure Requirements
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.
Déclaration d’exposition aux radiations:
Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de
20 cm de distance entre la source de rayonnement et votre corps.
i.A.
Signature
Abdellah Ahakki on behalf of Magneti Marelli S.p.A.
7Layers AG Viale C. Emanuele II, 150
Borsigstr.11 10078 Venaria
40880 Ratingen ITALY
Germany