Marelli TSTU50 Keyless Entry System Receiver User Manual Users manual

Download:
Mirror Download [FCC.gov]
Document ID	280811
Application ID	9DSSTXdO6Q+wo5kwdUvlbg==
Document Description	Users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	9.05kB (113172 bits)
Date Submitted	2002-11-03 00:00:00
Date Available	2002-11-03 00:00:00
Creation Date	2002-10-10 17:15:48
Producing Software	Acrobat 5.0 Scan Plug-in for Windows
Document Lastmod	2002-10-10 17:16:14
Document Title	Users manual
Document Creator	Acrobat 5.0 Scan Plug-in for Windows

6. USER OPERATION INSTRUCTION (DRAFT)
MULTI—REMOTE CONTROL SYSTEM
It is possible to lock/unlock all doors and activate the panic alarm by using the remote controller
(transmitter) from outside the vehicle.
Before locking the doors, make sure the keys is not left in the vehicle.
The remote controller can operate at a distance of approximately 33 it (10 m) from the vehicle, (The
efl‘ectiVe distance depends upon the conditions around the vehicle.)
As many as four remote controllers can be used with one vehicle. For information concerning the
purchase and use of additional remote controllers, contact your NISSAN dealer.
The multi~remote controller will not fimction when;
—the battery is dead.
—the distance between the vehicle and the remote controller is over 33 ft (10 m).
The pnnic alarm will not activate when the key is in the ignition switch.
A CAUTION
The following conditions or occurrence will damage the remote controller.
-Do not allow the remote controller to become wet.
-Do not drop the remote controller.
-Do not strike the remote controller sharply against another object.
-Do not place the remote controller for an extended period in an area where temperature
exceed 140 degree F (60 degree C).
[fa multi—remote controller is lost or stolen, NISSAN recommends erasing the 1D code of that
controller. This will prevent the controller from unauthorized use to unlock the vehicle. For
information regarding the erasing procedure, please contact an authorized NISSAN dealer.
HOW TO USE MULTI-REMOTE CONTROL SYSTEM
Setting hazard and horn chirp mode
This vehicle is set in hazard and horn chirp mode when you first receive the vehicle.
In hazard and horn chirp mode, when the LOCK button is pushed, the hazard indicator flashes twice
horn chirps once. When the UNLOCK button is pushed hazard indicator flashes once.
If hazard and horn chirp mode is not necessary, you can switch to normal mode by following the
/ switching procedure
In normal mode, when the LOCK button is pushed, the hazard indicator flashes twice.
When the UNLOCK button is pushed, neither the hazard indicator nor the horn operates.
(Switching procedure) '
Push the LOCK and UNLOCK buttons on the multi-remote controller simultaneously for more than
2 seconds to switch from one mode to the other.
When pushing the buttons to set normal mode, the hazard indicator flashes 3 times.
When pushing the buttons to set hazard and horn chirp mode, the hazard indicator flashes once and
the horn chirp once.
Locking doors
1. Remove the ignition key.*1
2 Close all doors.*2
3. Push the LOCK button on the multi-remote controller
4. All door will lock.
All of the doors will luck when the LOCK button on the multi-remote controller is pushed
even though it door remains open and/or the ignition key is in the ON position,
5. The hazard indicator flashes twice and the horn chirp once
-When the LOCK button is pushed with all doors locked, the hazard indicator flashes twice and the
horn chirps once as a reminder that the doors are already locked.
*1: Doors lock with the remote controller while a key is in the ignition switch. However, the panic
alarm will not activate when the key is in the ignition switch.
*2: Doors lock with the remote controller while any door is open. However, hazard and horn chirp
mode will not fimction.
WNW
PUSH T0 LOCK
PUSH T0 UNLOCK—
PUS’H TO OPEN
THE TRUNK LID
PUSH TO OPAEATE THE
PANIC ALARM
Unlocking doors v
1, Push the UNLOCK button on the multi—remote controller once.
-Only the driver door unlocks
—The hazard indicator flashes once ifall doors are completely closed.
-’I‘ he interior light turns on and the light timer activates for 30 seconds when the interior light
switch ofthe vehicle is in the center position
2. Push the UNLOCK button on the multi—remote controller again within 5 seconds.
-All doors unlock.
~The hazard indicator flashes once ifall doors completely closed.
The interior light can be turned off without waiting for 30 seconds by turning the ignition switch to
the on position or by locking the doors with the multi~remote controller.
Releasing the trunk lid
1. Push the trunk lid button on the multi-remote controller for longer than 0.5 second with the key
removed from the key cylinder.
2. The trunk lid opens.
The trunk lid will not open when the trunk lid cancel lever is in the CANCEL position. It can be
opened only with the key.
See “Trunk lid” later in yhis section for cancel lever.
Using the panic alarm
If you are near your vehicle and feel threatened, you may activate the alarm to call attentions as
follows:
1. Push the PANIC button on the remote controller for longer than 0.5 seconds.
2. The thefi warning alarm and head lights will stay on for 30 seconds.
3. The panic alarm stops when;
-It has run for 30 seconds, or
-The LOCK or the UNLOCK button is pushed on the multi—remote controller for longer than 0.5
seconds.
BATTERY REPLACEMENT
Replace the battery as follows,
1, Open the lid using a suitable tool.
2. Replace the battery with a new one.
—Recommencled battery: CR2025 or equivalent.
~Make sure that the + side face the bottom case.
3. Close the lid securely.
4. Push the remote controller button two or three times to check its operation.
See your NISSAN dealer if you need any assistance for replacement.
If the battely is removed for any reason other than replacement, perform step 4>ahove.
—An improperly disposed battery can linrm the environment. Always confirm local
regulations for battery disposal.
SUITABLE TOOL
-The remote controller is water-proof, however, if it get wet, immediately wipe completely
dry.
-When changing batteries, do not let dust or oil get in the controller.
FCC Notice:
Changes or modifications not expressly approved by the manufacturer for compliance could
void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules and Regulation and the Standard
RSS~210 of Industry Canada. '
Operation is subject to the following two conditions : (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation of the device,

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Modify Date                     : 2002:10:10 17:16:14+09:00
Create Date                     : 2002:10:10 17:15:48+09:00
Creator                         : Acrobat 5.0 Scan Plug-in for Windows
Page Count                      : 4
Mod Date                        : 2002:10:10 17:16:14+09:00
Creation Date                   : 2002:10:10 17:15:48+09:00
Producer                        : Acrobat 5.0 Scan Plug-in for Windows
Metadata Date                   : 2002:10:10 17:16:14+09:00

EXIF Metadata provided by EXIF.tools