Marklyn Group 70122 PROSTROBE QUADSTROBZ DUAL User Manual
MARKLYN CO. INC. PROSTROBE QUADSTROBZ DUAL
User manual
PROSTROBE QUADSTROBZ DUAL
FCC ID: 2AMN5-70122
Model: 70122
Electronic specification
1. Operation Voltage： 3.0V
2. Voltage range：2.4V-3.6V
3. Operation current：<30mA
4. Standby current:：<10uA
5. Frequency: 2419-2474MHz
Main purpose: to replace the cable controller and to get rid of
short-range operational constraints.
Features: can arbitrarily control LED lighting products in any
direction through 360 degree remote. There are two kinds of light,
like yellow and white. As for the yellow one, it is easy to be vigilant
in the far area, warning do not get close. As for the white flashing, it
apply to proximity lighting, distinguish things clearly. Both have 9
kinds of use mode, in the unreal able conditions, you can choose
the mode you want.
Federal Communications Commission (FCC) Interference
Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generate, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following
measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for
help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void the
user’s authority to operate this equipment.
RF exposure warning
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment.
The equipment must not be co-located or operating in conjunction
with any other antenna or transmitter.