Marquardt MM1 Remote Control User Manual

Marquardt GmbH Remote Control 2016 12 07 MM1 ME1

a href="https://usermanual.wiki/Marquardt" itemprop="url"> Marquardt >

UserManual

MM1 / ME1 User Manual W:\CEQ_Bereich\Funkzulassungen\Projekte\John Deere_Azor_M209301\03 Allgemeine Produktbeschreibung\2016-12-07_MM1_ME1_User Manual.docx Seite 1 von 3 Introduction Azor is a wireless communications system that can be mounted on a vehicle. Azor allows remote operation of integrated components located on the same machinery. The system consists of 1 gateway ME1 and 2 fobs MM1. The gateway connects to the CAN bus on the machinery. It is advantageous if the machinery includes a user interface to program settings on the gateway. The fobs communicate to a Blue Tooth radio with integrated antenna inside the gateway. Individual buttons send uniquely numbered messages onto the CAN Bus. New fobs can be paired with the system in the field. Figure 1 Azor System Components MM1 ME1
MM1 / ME1 User Manual W:\CEQ_Bereich\Funkzulassungen\Projekte\John Deere_Azor_M209301\03 Allgemeine Produktbeschreibung\2016-12-07_MM1_ME1_User Manual.docx Seite 2 von 3 Installation Carefully remove the components from the box. Use M6 Button head screws to mount the gateway onto the machine. Connect the 8-pin Deutch connector to the gateway. Be sure that the lines are unpowered while making the connection. Pin 1 is top left and pin 8 is bottom left in Figure 2 Gateway Connector. Figure 2 Gateway Connector Figure 3 Deutch Connector Pin Designations Be sure to mount the gateway in a location that does not interfere with the Blue Tooth wireless communications. Metal should not be located between the internal antenna and locations where the operator will be pressing the fob buttons. (If the fob operator cannot see the gateway, the fob reception will be reduced.) Setup The gateway initially is accompanied by 2 fobs that are paired with the gateway. Power can be supplied to the gateway from the vehicle through either the ELX pin or the Vbat Pin, or both. There are multiple operating modes of the system, depending on the pins providing power and a few parameters. Conditions for Modes of Operation ELX Power When the gateway power source is through the ELX pin, without Vbat present, the entire module is configured to operate continuously in the normal mode. No software modifications are required.
Download:
Mirror Download [FCC.gov]
Document ID3221702
Application IDap+JkIDgvHk7oruL7/VLnQ==
Document DescriptionUserManual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize12.49kB (156110 bits)
Date Submitted2016-12-08 00:00:00
Date Available2016-12-08 00:00:00
Creation Date2016-12-07 14:02:26
Producing SoftwareGPL Ghostscript 9.06
Document Lastmod2016-12-07 14:02:26
Document Title2016-12-07_MM1_ME1_User Manual
Document CreatorPDFCreator Version 1.6.0
Document Author: SiegelG
FCC ID Filing: IYZ-MM1

Navigation menu