15_M11 UserMan
Wireless charger M11
This wireless charger will allow you to charge any wirless charging
compatible smartphone or device without the need for a charging cable by
simply placking it on the charging plate
Connents:
1.
Wireless charger
2. Micro USB Charge Cable
3.User Manual
Specifications: 1.Output: 5W/5V/1A
2.Input:5V/2A
How to Use
1. Open and build the stand based on the way you want to place the device
horizontally or vertically like below
2.
3. Use included USB cable and inserts the micro connector into wirless
charger, Then use USB connector to plug into an AC or DC USB charger.
4. When the power turned on. The bottom indicator light turns green to
show wireless charger is ready to use
5. Set your device into charging surface. Your device is under charging when
indicator light turn to streaming green
Indicator Lights
Power on: Bottom indicator lights turn green Charging
mode: Streaming green lights FOD: All indicator lights
flashing green
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
FCC ID: 2APOP-M11