Martec Access 3BT-433MAR Swimming Pool Current Remote Control Transmitter User Manual Exh 08 Users Manual

Martec Access Products Inc Swimming Pool Current Remote Control Transmitter Exh 08 Users Manual

user manual

Remote Control:TransmitterThe remote control transmitter has three buttons . Press and hold the button to turn the swim current on. Press and hold the Up orDown button to addjust the current to the desired speed . Press andhold the button while the current is on to turn This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, includinginterference that may cause undesi red operation .MODEL: EP-1g - 230 VAC, 24 AMPS, 60 Hz.IP25 RATED RAINPROOF (TYPE 3R) ENCLOSURE SUITABLE FORINDOOR OR OUTDOOR USETHIS UNIT REQUIRES 30 AMP 230 VOLT AC, SINGLE PHASE WITHNEUTRAL, 60 Hz. (THREE COPPER WIRES PLUS GROUND)Hydraulic Power Unit5 HP 21 FLA Amps 230 VAC 60 Hz6 HP 23 FLA Amps 230 VAC 60 HzHEATER CONTROLLER (optional)24 Amps 230 VAC 60 HzControllerIMPORTANT SAFETY INSTRUCTIONS: Read and follow all instruc-tions. To reduce the risk of injury, do not permit child ren to use thisproduct unless supe rvised at all times. This control panel must beinstalled according to local electric code requi rements . A GFCI(Ground Fault Circuit Interrupter) or RCD (Residual Current Device)circuit breaker must be used in the service panel and tested beforeeach use in accordance with the manufactu rer's instructions . The line-inwire whip should be connected to a safety disconnect in sight of allequipment , but at least 5 feet away from the pool. This controller mustbe installed at least 5 feet away from the pool and all conductors mustnot sha re boxes, conduits or enclosu res with non GFCI or RCD pro-tected wiring . All wires must be coppe r. Box must be mounted withconduit down.9WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Navigation menu