Mascot Electric UT-16 Wireless Microphone User Manual

Mascot Electric Co., Ltd. Wireless Microphone Users Manual

User Manual

Download: Mascot Electric UT-16 Wireless Microphone User Manual
Mirror Download [FCC.gov]Mascot Electric UT-16 Wireless Microphone User Manual
Document ID114086
Application IDrqUfKshJZvDAWEUHlHp14Q==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize8.66kB (108192 bits)
Date Submitted2000-08-19 00:00:00
Date Available2000-09-21 00:00:00
Creation Date2000-08-19 10:41:10
Producing SoftwareAcrobat PDFWriter 4.0 for Windows
Document Lastmod2000-08-19 11:34:03
Document TitleUsers Manual
Document Creator穨全能影像經理 - Inbox
Document Author: 穨ivy

EXHIBIT C
User Manual
WIRELESS MICROPHONE FEATURE 8. SPECIFICATION
FEATURE
High sensitivity cardioid capsule.
Special noise absorption parts inside the barrels, which eliminate switch shock noise and handling noise,
Frequency with PLL synthesized control,
Easy-opening battery compartment for quick battery replacement.
Lmv battery LED indicator.
The Lavalier microphone is very light and easy for using clip on the belt. It can be used with headset mic w/345mm screw t;
plug easily.
Queenie
SPECIFICATION
" Carrier Frequency Range : UHF band 790~806MH1
' RF Power Output : 2mW (max)
' Spurious Emission : More than 45dB below carrier frequency
' Frequency Stability : Within iDtGUS‘Vu with PLL synthesized controlled
‘AF Reponse 240I~iz to 15KHz (weds)
' Maximum Deviation : tit] ‘KHz within limiting compressor.
' Signal to Noise Ratio : sadism-Weighted).
' Microphone Capsule : Uni-directional dynamic microphone
' Operating voltage : 0615sz (UM-3 type)
' Current consumption ‘ About 65mA (max)
' LED indicator : Power On-Oii and low battery
OPERATION
1.Push to open the battery cover.
2.Insert1,5Vx2 batteries into the battery holder according to polarlty (+) and (-) indication marked on the battery housing
3. Fit battery cover back.
4.Afler setting the chosen frequency same as the receiver. push the power switch to “ON“, the LED indicator will flash to Indicate
the carrier frequency is sending out.
5 Push the power button to "OFF" when mic is not used. and remove the battery in microphone if not used for a long time. This w
prevent from the damage that a defective "leaking" battery may cause.
6.5witch the power "ON". the LED indicator flashing means that power supply is normal. it the LED indicator on light means the
the battery is in need of replacement. If no flashing, there is no battery or battery is not properly inserted.
MR—S U9
WIRELESS MICROPHONE NAME OF COMPONENT
HANDHELD MICROPHONE
4 1. Screen Head
2. LOW Battery LED Indicator
3, ONIOFF Switch
4 Mic Housing
5. Channel Selector
6 Battery Housing
7. Antenna
& Battery Cover
NOTE
THE WIRELESS HANDHELD OR LAVALIER MICROPHONE. TWO OR ABOVE WIRELESS MICROPHONES WHlC
TRANSMIT AT THE SAME FREQUENCY CAN NOT BE USED AT THE SAME TIME 8: AREA.
TROUBLE SHOOTING: .
Please take tlrne to read this manual before askmg after sale service. and check following points tf it also has unusual things,
please contact with purchasing store We are sincerely to serve for you,
{Before connecting and operating the unit. check the voltage setting contorrns to the voltage available in your area.
2." the LED indlcator on light means that power supply is in need of replacement. Please replace 1.5Vx2 batteries and be sure tl
polarity (+)(v) of battery |s connected property
3.Sigr|al dropouts and noise may be suddenly encountered by interruption from oumide‘ too long distance between microphone an
reqeiver or battery in low power. in such a case. adjust recall/er antenna or change new battery.
4.00 not drop the microphone on a hard concrete floor. nor strike the microphone head front with a list or fingers, nor blow a breatl
strongly into the microphone head from.
' 5,Remove the battery in microphone it not used for a long time, This will prevent from the damage that a defective "leaking" batts
rpay cause.
. MR-SU9
DESIGN AND SPECIFICATIONS SUBJECT TO BE CHANGED WITHOUT NOTICE.
flflflfl ”25:5: ‘
. . u . .
7, .
EH “draw—EN
neknwazx»
unvzugf
umhmozxn
n woubumz-fi
cob uuzzn
Ehmmzxu
v .
LICENSING REQUIREMENTS
This equipment complies with Part 74 of the FCC Rules.
A license is required for operation subjective device will be issued only to
the following:
(1)
(2)
(3)
(4)
(5)
(6)
A licensed of an AM, FM, TV, or international broadcast station or
low power TV station. Low power auxiliary stations will be licensed
for used with a specific broadcast or low power TV station or
combination of stations licensed to the same licensee within the
same community.
A broadcast network entity,
A cable television system operator who operates a cable system that
produces program material for origination or access cablecasting as
defined in §76.5(r)
Motion picture producers as defined in §74.801.
Television program producers as defined in §74.801.
Licensees an conditional licensees of stations in the Multipoint
Distribution service and Multichannel Multipoint Distribution
Service as defined in §21.2 of this chapter, or entities that hold an
executed lease agreement with an MDS or MNIDS licensee or
conditional licensee or with an Instructional Television Fixed service
licensee or permittee.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Creator                         : .穨.全能影像經理 - Inbox
Create Date                     : 2000:08:19 10:41:10
Title                           : .穨.未命名標題
Author                          : .穨.ivy
Producer                        : Acrobat PDFWriter 4.0 for Windows
Modify Date                     : 2000:08:19 11:34:03+08:00
Page Count                      : 5
EXIF Metadata provided by EXIF.tools
FCC ID Filing: JEBUT-16

Navigation menu