Masimo RAD7CPL Radical 7R User Manual LAB6394A indd

Download:
Mirror Download [FCC.gov]
Document ID	1304695
Application ID	xVtWN/wTlCmgl3c4NS5uMA==
Document Description	User Manual 1
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	8.52kB (106464 bits)
Date Submitted	2010-07-01 00:00:00
Date Available	2010-07-01 00:00:00
Creation Date	2010-05-21 09:45:16
Producing Software	Acrobat Distiller 9.0.0 (Windows)
Document Lastmod	2010-05-21 09:45:16
Document Title	LAB6394A.indd
Document Creator	PScript5.dll Version 5.2.2
Document Author:	GLindmeier

Pulse CO-Oximeter
Operator’s Manual
Wireless Radio Addendum
Radical-7 Operator’s Manual Wireless Radio Addendum
This addendum describes wireless radio licensing and specification information for the
Radical-7 Pulse CO-Oximeter. This addendum is used in conjunction with the Radical-7
Operator’s Manual, part number 33975.
PAGE i
Wireless Radio
FCC ID: VKF-RAD7CPL
IC: 7362A-RAD7CPL
Bluetooth
FCC ID: PVH0925
IC: 5325A-0925
SAFETY INFORMATION, WARNINGS, CAUTIONS AND NOTES
■ Do not place the Pulse CO-Oximeter or accessories in any position that might cause it to
fall on the patient. Pulse CO-Oximeter must be placed greater than 20cm from the patient’s
head or torso.
■
This equipment has been tested and found to comply with the limits for medical devices to
the EN 60601-1-2, Medical Device Directive 93/42/EEC and Part 15, FCC Rules/USA.
■
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
■
The Bluetooth component in this device has been qualified according to the Bluetooth specification 2.1+EDR
■
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to other devices in the vicinity. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to other devices, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
■ Reorient or relocate the receiving device.
■ Increase the separation between the equipment.
■ Connect the equipment into an outlet on a circuit different from that to which the
other device(s) are connected.
■ Consult the manufacturer for help.
■
In order to connect wirelessly to a compatible interface system like Patient
SafetyNet, the Radical-7 should be placed in an environment free from RF shielding,
which could hinder wireless reception.
■
To minimize radio interference, other electrical equipment that emits RF transmissions
should not be in close proximity to the Radical-7
12
■
Changes or modifications to the wireless radio feature whether intentional or
unintentional are prohibited without written approval from Masimo Corporation.
SAFETY INFORMATION, WARNINGS, CAUTIONS AND NOTES (CONTINUED)
■ The Radical-7 (device with optional radio) wirelessly transmits real-time sensor connectivity
status, indicating a connect and/or disconnect state. If the device is in a failure mode then
the radio power is disabled and an error message is indicated on the device display. The
device does not have a powered state where no information is transmitted.
■ In accordance with FCC requirements, the Radical-7 (device with optional radio)
must be placed greater then 20 cm from the patient’s head or torso.
■ In accordance with FCC requirements, radio accessories on the Radical-7 (device
with optional radio) cannot be attached directly to the patient using any accessory
containing metal components.
■ In accordance with international telecommunication requirements, the frequency
band of 5,150 MHz to 5,250 MHz is only for indoor usage to reduce potential for
harmful interference to co-channel mobile satellite systems.
SECTION 7: SPECIFICATIONS
Wireless Radio Specifications (if installed)
8802.11 a/b/g
Radio Modes
Encryption
Authentication
64/128-bit WEP, Dynamic WEP, WPA-TKIP, WPA2-AES
Open System, Shared Key, Pre-Shared Key (PSK),
802.1X: LEAP, PEAP, TTLS, TLS, EAP-FAST
Compliance
USA
FCC ID: VKF-RAD7CPL
FCC parts 15.207, 15.209, 15.247 and 15.407
Canada
IC: 7362A-RAD7CPL
RSS-210
Europe
EN 300 328
EN 301 893
EN 301 489-17
Bluetooth Specifications (if installed)
RF output power (conducted
- excluding antenna gain)
Output frequency
Referenced QDIDs
Modulation
Class 2 , max 4dBm (2.5mW)
2.402 - 2.480 GHz, ISM band
B016013 combined with B015102
FHSS (Frequency hopping)
Compliance
USA
FCC ID: PVH0925
Canada
IC: 5325A-0925
Europe
EN 300 328
EN 301 489-1
EN 301 489-17
EN 61000-6-2
EU Authorized Representative for Masimo
Corporation:
EC
Masimo Corporation
40 Parker
Irvine, CA 92618
USA
www.masimo.com
© 2008 Masimo Corporation.
REP
MDSS GmbH
Schiffgraben 41
30175 Hannover, Germany
34168/6394A - 0510
Manufacturer:

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Author                          : GLindmeier
Create Date                     : 2010:05:21 09:45:16-07:00
Modify Date                     : 2010:05:21 09:45:16-07:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Creator Tool                    : PScript5.dll Version 5.2.2
Producer                        : Acrobat Distiller 9.0.0 (Windows)
Format                          : application/pdf
Title                           : LAB6394A.indd
Creator                         : GLindmeier
Document ID                     : uuid:26878f0d-a3df-4205-9f0d-e2f24c07bae6
Instance ID                     : uuid:f82c3a1c-d9eb-4ce6-8ed9-a40d36bab3b3
Page Count                      : 4

EXIF Metadata provided by EXIF.tools