Matsunichi Communication R and D DM186 MATSUNICHI MOBILE HARD DISK ENCRYPTION User Manual 186
Matsunichi Communication Holdings R&D; (Shenzhen) Co., Ltd. MATSUNICHI MOBILE HARD DISK ENCRYPTION 186
Users Manual
Matsunichi Mobile hard disk encryption User Manual
DM186
Note:
1, In the course of the preparation of this statement has sought
to correct and complete, but does not guarantee that there
are no errors in this statement or loss.
2, Matsunichi only problems on the machine itself has a
warranty and maintenance responsibility for the software due
to misoperation, product maintenance or other unforeseen
circumstances, such as personal data caused by deletions or
loss of any responsibility, nor on the other resulting in
responsible for indirect losses.
3, The product software and hardware manuals or any changes
without notice, such as pine on the final power of
interpretation of digital.
Contents
1 Introduction ......................................... 1
2 Product Features ..................................... 2
3 System
Requirements ........................................ 3
4 Instructions ........................................ 4
1 Introduction
Thank you for you on the use of Matsunichi removable storage
device encryption.
Matsunichi encrypted 1.8-inch mobile hard disk is encrypted
portable external storage systems. Its main characteristic
is that hard drives can write data encryption, hard disk data
protection.
2 Product Features
2.1 The use of RFID encryption technology to ensure data
security and effective
2.2 Metal casing, shock absorber design, to ensure the
physical security of storage devices
2.3 High-speed USB2.0 interface, transfer rate up to 480Mbps
No need to drive more than 2.4windows98 system, plug and play
2.5 Low-power design, no external power can drive high-speed
storage devices
2.6 Cache-type large-capacity cache 2M, 4200 switch to
high-speed hard drives to ensure high-speed data transmission
and stability
2.7 Full Service:1 year quality guarantee, life-long
maintenance
3 System Requirements
3.1 Hardware System:
USB interface with the IBM PC or compatible desktop computers,
notebook computers, as well as with USB interface, such as
Apple Computer.
3.2 Software System
Windows 98/ME/2000/XP/Vista/Mac OS 9.x or above the operating
system:
No driver, restart the computer after connecting a good mobile
hard disk, the computer will be prompted to find and
automatically install new hardware drivers, USB devices will
appear in the letter of the computer desktop.
4 Instructions
4.1 Corresponds to the machine with a computer connected to
the USB line, the power LED (blue).
4.2 Will be the key corresponding to the machines near the
induction coil region of about 2 seconds, when the buzzer will
"DiDi" called twice, and two-color light green light changes
that unlock the success of equipment normally used.
4.3 To disconnect the equipment, then only the key to the region
near the induction coil about buzzer will "DiDi" called twice,
when disconnected with the computer equipment connected
eliminate light green color. (You can also stop the computer).
4.4 hard drive when the PC box with the data in each other
when the key near the induction area, the connection will not
be interrupted, when the buzzer will be issued "Di" A to show
the system is busy.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for
help.
FCC NOTE:
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:(1)this device may
not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this
equipment. Such modifications could void the user's authority
to operate the equipment