Mattel Asia Pacific Sourcing H6918-05A4T REBOUND SUPER BIKE User Manual

Mattel asia Pacific Sourcing Ltd. REBOUND SUPER BIKE

USER MANUAL

Download: Mattel Asia Pacific Sourcing H6918-05A4T REBOUND SUPER BIKE User Manual
Mirror Download [FCC.gov]Mattel Asia Pacific Sourcing H6918-05A4T REBOUND SUPER BIKE User Manual
Document ID557074
Application ID2C7hIS50e2pKb9FFnov/LQ==
Document DescriptionUSER MANUAL
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize32.88kB (411031 bits)
Date Submitted2005-06-29 00:00:00
Date Available2005-06-28 00:00:00
Creation Date2005-06-27 15:33:12
Document Lastmod0000-00-00 00:00:00
Document TitleUSER MANUAL

“00° RIC SUPPQRT ’
flux-“inns - Incl-Inns with yum mam?
DON'T RETURN IT To THE STORE!
Just an us in h-lp.
us mmmm,m..wmmam-mam."
1 888 557-1700 (8926)
tycore.eom
SWISS—DMD
G3455»Sl
ACAU-"ON. Surfaces may become hot
and cause burns if electronics get wet. Do not
operate vehicle through water or snow.
Keep these instructions for future reference: they
contain important information. IMPORTANT: Please
read all “Consumer information" helore operating
your vehicle.
Transmitter
Air pump needle
Vehicle
0 UN(I)/OFF(O) switch
6 Inflatable tire inlet
6 Air pump needle
0 Battery door
{71 Your Rebound SuperbikeTM comes with both tires
7 ° deflateu. Attach the supplied air pump needle to a
hand air pump (not inleuded) then lnsertthe needle
into the hole as shown and pump up the tire!
Transmitter
0 Antenna
0 LED indicator
0 "Turbo" button
0 Trigger: forward I idle / brake control
9 "fire: left! right control
0 DNlIl/OFFlolswitch
0 Battery door
y"; Justturn your vehicle ON. Then pullthe trigger and
7 ' you will be able to run and control your vehicle.
to familiarize you
your motorcycle's features and controls, Vlfith practice,
you'll be a “pro" driver before you know it.
- Trigger: left = forward, center = idle, right: brake
'T|re motion: turns lettand right (no reverse)
- “Turbo" button: causes rapid acceleration
(see section "B" below)
1??? Your bike is an ultra high performance high-speed
’ “ vehicle. For your safety and those around you,
ALWAYS operate your bike in large open spaces, like
e park or playground. NEVER drive your bike toward
people, animals, orfragile objects!
)?J‘;< Your bike is a racing—style RIC motorcycle engi-
’ neered to operate on dirt, sand and grass. as well as
pavement or asphalt. However, you will get the best
performance on smooth, hard surfaces
Braking system
Your vehicle is engineered with an advanced braking
system for maximum performance:
When you release the transmitter's trigger while driving,
thevehicle will coastto a gradual stop.
11. Pump up tires!
NOTE: Your bike's Turbo tire may not be fully inflated
when you take it out of the box. Use the included air pump
needle to inflate it.
Jae Use only a hand pump (not included) to inflate the
7.“ tires.
J? For easier insertion, wet the tire needle before
7 “ inserting into thetire.
we The tire is fully inflated when there's about 1/4"
7?” {ii-7mm) of clearance between the tire and the bike
body. Also there are two white mark lines on both
of bike fenders, it's better for you reference the
standard inflated tire. DON'T OVERINFLATE IT! If you
overinflate the tire, it will rub against the bike body,
preventing it from turning freely. if this happens,
simply use the supplied air pump needle to let air
out of the tire until it returns to its proper size.
$61 Be sure to keep the air pump needle, so you can
7 P reintlate the tire when necessary.
B. Healislie leaning action!
The small wheel on the rider’s knee will keep the bike
stable when the bike leans into turns.
E. Driving tip
For tighter turns and fewer wipeouts: pulse the trigger to
slow down the bike as you're heading into a turn.
II. “Turbo" boost - stunt action!
When you press the trigger and theturbo button atthe
same tune, the vehicle will accelerate very rapidly. Use
this feature to get the extra burst of speed you need right
before attempting a lump stunt!
wrnn muk line
“ab"
Yourvehrcle requires a 7.2V TMH® FlexPak® battery pack
for the vehicle and 4AA alkaline btteries for the transmitter.
Vehicle
1. Use a screwdriver (not included) to unscrew power clip
cover screw, remove the battery cover.
2. lnsertthe charged TMH® FlexFak® battery packlnpt
included), with polarity l+/-l as shown inside the battery
compartment.
3. Replace the battery door.
[ansmitter
1. To install transmitter batteries, remove the battery cover
as shown.
2. lnstall 4 AA batterieslnot included), With polarity (+/-l as
shown inside battery compartment.
3. Replace the battery cover.
K7? If the transmitters LED indicator does not light when
73 the transmitter is switched UN, it’s time to replace the
transmitter batteries. Simply install fresh batteries as
described above.
iieefia
1. When your vehicle starts to lose power, it may lose
functions or performance. It's time for a recharge
For best stunt performance, always start with a lully—
charged battery.
2. Yourvehicle's running time may change depending on
your driving styles
3. Radio interference can make your vehicle run poorly.
interference can be caused by other RIC vehicles running
on the same frequency; electrical wires; large buildings;
CB radios; or other wireless gear. Try to stay away from
thesel
4. Point your transmitter antenna up — not down toward
your vehicle. If your vehicle gets too far away, it won't
work properly.
5. Don't drive your vehicle through water or snow. lf your
vehicle does getwet, wipe with a towel and allow to dry
completely.
6. Don’t store yourvehicle near heator in direct sunlight.
Always turn switches OFF and remove all batteries for
storage.
f (The tires on your bike should always be firm. It’s a
7 W good idea to periodically check them to see if any
air's escaped (if you can push in the tire its time for a
little more air). Use the supplied air pump needle (with
an air pump) to add more air.
f<7L
Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Create Date                     : 2005:06:27 15:33:12
Page Count                      : 4
EXIF Metadata provided by EXIF.tools
FCC ID Filing: PIYH6918-05A4T

Navigation menu