Mattel Asia Pacific Sourcing X7273-12A4R RC CARS 2 EZ DRIVER MATER REFRESH User Manual 1

Mattel asia Pacific Sourcing Ltd. RC CARS 2 EZ DRIVER MATER REFRESH Users Manual 1

Contents

Users Manual 1

Download: Mattel Asia Pacific Sourcing X7273-12A4R RC CARS 2 EZ DRIVER MATER REFRESH User Manual 1
Mirror Download [FCC.gov]Mattel Asia Pacific Sourcing X7273-12A4R RC CARS 2 EZ DRIVER MATER REFRESH User Manual 1
Document ID1638528
Application IDs3xeuDIf77NSbAoY/Onm3w==
Document DescriptionUsers Manual 1
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize61.44kB (767943 bits)
Date Submitted2012-02-16 00:00:00
Date Available2012-02-16 00:00:00
Creation Date2011-12-20 15:28:33
Producing SoftwareAdobe PDF Library 9.9
Document Lastmod2011-12-20 15:28:40
Document TitleUsers Manual 1
Document CreatorAdobe InDesign CS5 (7.0.2)

3+
Keep these instructions for future reference as they contain
important information. IMPORTANT: Please read all
“Consumer Information” before operating your vehicle.
®
Asst. X7271
X7272/ X7273/ X7276-0920
C AUTION: Surfaces may become hot and cause
CAUTION: To prevent entanglement, keep all hair
burns if electronics get wet. Do not operate vehicle
through water or snow.
away from the wheels.
I. CONTENTS/ FEATURES
This set includes: 1 vehicle, 1 transmitter
1 Steering wheel
2 Forward
3 Reverse
4 Battery cover
5 ON (I) / OFF (0)
6 S
 teering adjuster - Turn with screwdriver (not included)
to keep vehicle running straight. 
X7276 FINN McMISSILE
X7272 LIGHTNING McQUEEN
X7273 MATER
II. BATTERY INSTALLATION
(Transmitter & Vehicle)
Requires 3 AA alkaline batteries for the vehicle and 2 AA
alkaline batteries for the transmitter. Batteries not included.
Vehicle
1. Unscrew the battery cover with a Phillips head
screwdriver (not included).
2. Your vehicle requires 3 AA alkaline batteries. Install with
polarity (+/-) as shown inside the battery compartment.
3. Replace battery cover and tighten screw.
3 X AA
Transmitter
1. Unscrew the battery cover with a Phillips head
screwdriver (not included).
2. Transmitter requires 2 AA alkaline batteries. Install with
polarity (+/-) as shown inside the battery compartment.
3. Replace battery cover and tighten screw.
NOTE: Once the batteries are installed the transmitter
will always be “ON” and will work automatically the
moment you use it.
3 X AA
2 X AA
3 X AA
III. OPERATION
FORWARD
REVERSE
TURN LEFT
TURN RIGHT
IV. QUICK TIPS
 hen your vehicle starts to lose power, it may lose
functionality or performance. It’s time for fresh
batteries. Your vehicle’s running time may change
depending on your driving style.
Radio interference can affect your vehicle's
performance. Interference can be caused by other
R/C vehicles running on the same frequency,
electrical wires, large buildings or CB radios. Try to
stay away from these!
Point your transmitter up - not down toward your
vehicle. If your vehicle gets too far away, it won’t
work properly.
Don't drive your vehicle in sand or through water
or snow. If your vehicle does get wet, wipe it with a
towel and allow to dry completely overnight.
Don’t store your vehicle near heat or in direct
sunlight. Always turn switches OFF and remove all
batteries for storage.
If the vehicle malfunctions, please turn the power
OFF and ON again. This should reset your vehicle
and let you resume normal operation.
V. BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that
can cause a chemical burn injury or ruin your product.
To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the
product before being charged.
• Rechargeable batteries are only to be charged under
adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the
product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries
inside may explode or leak.
Battery Performance Note:
For best performance use regular or high-performance
alkaline batteries (where disposable batteries are called
for). If your vehicle is supplied with standard (carbonzinc) batteries for initial use and/or demonstration
purposes, we recommend replacing them with alkaline
batteries when necessary. Battery life may vary
depending on battery brand.
VI. CONSUMER INFORMATION
Note to Adults: To ensure that the child’s play is both
safe and fun, please review all operating instructions
and safety rules with your child.
Safety Tips
• NEVER drive your vehicle on streets!
They’re for real cars!
• DO NOT pick up the vehicle while in motion.
• Keep fingers, hair and loose clothing away from
the tires and the wheel hubs while the vehicle is
switched ON.
• Adult supervision is recommended when this vehicle
is being operated.
• To avoid accidental operation, remove all batteries
when not in use.
Protect the environment by not disposing
of this product with household waste
(2002/96/EC). Check your local authority
for recycling advice and facilities.
©2011 Mattel. All Rights Reserved.
Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052, U.S.A.
Consumer Relations 1-888-557-8926. • Mattel U.K. Ltd., Vanwall
Business Park, Maidenhead SL6 4UB. Helpline 01628 500303. • Mattel
Australia Pty., Ltd., Richmond, Victoria. 3121.Consumer Advisory
Service - 1300 135 312. • Mattel East Asia Ltd., Room 1106, South
Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
• Diimport & Diedarkan Oleh: Mattel SEA Ptd Ltd.(993532-P) Lot 13.5,
13th Floor, Menara Lien Hoe, Persiaran Tropicana Golf Country Resort,
47410 PJ. Tel:03-78803817, Fax:03-78803867. service.mattel.com
© Disney/Pixar
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
• This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly approved
by the manufacturer responsible for compliance could
void the user’s authority to operate the equipment.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.0-c060 61.134777, 2010/02/12-17:32:00
Instance ID                     : uuid:9552c866-588a-e14b-b7bb-a99b16ac64bc
Document ID                     : adobe:docid:indd:118d2cf2-d9d9-11df-8803-d3f7e26fa360
Original Document ID            : adobe:docid:indd:118d2cf2-d9d9-11df-8803-d3f7e26fa360
Rendition Class                 : proof:pdf
Derived From Instance ID        : 118d2cf1-d9d9-11df-8803-d3f7e26fa360
Derived From Document ID        : adobe:docid:indd:80e8d1b4-d60f-11df-b678-eb7c6a07227d
History Action                  : saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved
History Instance ID             : xmp.iid:76C867CB422068118A6DABA83A336BEB, xmp.iid:77C867CB422068118A6DABA83A336BEB, xmp.iid:7C8B1D74072068118A6DC7C77FDED760, xmp.iid:2E776B85072068118A6DC7C77FDED760, xmp.iid:FC072174072068118A6DF89DF928791B, xmp.iid:FD072174072068118A6DF89DF928791B, xmp.iid:CC102074072068118C1489343BD45CED, xmp.iid:CD102074072068118C1489343BD45CED, xmp.iid:D0E31B74072068118A6DB9AF2D02BD58, xmp.iid:DA098C3E122068118A6DB9AF2D02BD58, xmp.iid:DB098C3E122068118A6DB9AF2D02BD58, xmp.iid:8CA803EF082068118A6DC58F1B82BE93, xmp.iid:101952DA092068118A6DC58F1B82BE93, xmp.iid:942432350A2068118A6DC58F1B82BE93, xmp.iid:1AA5A36E0A2068118A6DC58F1B82BE93, xmp.iid:0E0CE7A40A2068118A6DC58F1B82BE93, xmp.iid:164094C70A2068118A6DC58F1B82BE93
History When                    : 2011:07:26 16:37:30+08:00, 2011:07:26 16:37:30+08:00, 2011:09:23 15:00:57+08:00, 2011:09:23 15:01:26+08:00, 2011:10:07 17:54:36+08:00, 2011:10:07 18:22:03+08:00, 2011:10:10 12:02:53+08:00, 2011:10:10 12:03:29+08:00, 2011:10:20 16:17:43+08:00, 2011:10:20 17:34:58+08:00, 2011:10:20 17:35:52+08:00, 2011:12:20 15:07:03+08:00, 2011:12:20 15:13:38+08:00, 2011:12:20 15:16:11+08:00, 2011:12:20 15:17:47+08:00, 2011:12:20 15:19:18+08:00, 2011:12:20 15:20:16+08:00
History Software Agent          : Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0
History Changed                 : /;/metadata, /metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata
Create Date                     : 2011:12:20 15:28:33+08:00
Modify Date                     : 2011:12:20 15:28:40+08:00
Metadata Date                   : 2011:12:20 15:28:40+08:00
Creator Tool                    : Adobe InDesign CS5 (7.0.2)
Page Image Page Number          : 1, 2
Page Image Format               : JPEG, JPEG
Page Image Width                : 256, 256
Page Image Height               : 256, 256
Page Image                      : (Binary data 10049 bytes, use -b option to extract), (Binary data 10447 bytes, use -b option to extract)
Doc Change Count                : 32
Format                          : application/pdf
Producer                        : Adobe PDF Library 9.9
Trapped                         : False
Page Count                      : 4
Creator                         : Adobe InDesign CS5 (7.0.2)
EXIF Metadata provided by EXIF.tools
FCC ID Filing: PIYX7273-12A4R

Navigation menu