Mattel Toys A Division of Mattel 95086-00A4R Radio Control Toy Receiver User Manual 00007 1713 03
Mattel Toys A Division of Mattel Inc Radio Control Toy Receiver 00007 1713 03
User Manual
00007-1703 6.0V R/C Keep these instructions for future reference: they contain important information. IMPORTANT: Please read all “Consumer Information” (last page) before operating your vehicle. CONTENTS CAUTION: Surfaces may become hot and cause burns if electronics get wet. Do not operate vehicle through water or snow. CHASSIS Vehicle Transmitter Power Clip (if supplied) 6.0V Jet Turbo® Battery Pack (if supplied) 6.0V Jet Turbo® Charger (if supplied) Your vehicle’s chassis will look like 1 or 2 below, depending on the vehicle’s design. Refer to label on transmitter and vehicle for frequency. Do not race vehicles with the same frequency. CHASSIS 1 CHASSIS 2 steering adjuster steering adjuster battery latch battery latch ON/OFF switch ON/OFF switch VEHICLE OPERATION FORWARD REVERSE LEFT RIGHT POWER SYSTEMS If your vehicle was supplied with a battery pack and charger, please follow the specific instructions on the next page for detailed information regarding NiCd vehicle battery charging and safety. If your vehicle was not supplied with a battery pack and charger, please follow the specific instructions that came with your battery pack and charger. VEHICLE BATTERY INSTALLATION 1. Rotate battery latch to open position. 2. Insert battery pack into battery compartment and slide it away from latch. 3. Make sure battery pack snaps securely in place and rotate latch to locked position. 4. To remove battery pack: turn latch, slide battery pack toward latch and lift out. TRANSMITTER BATTERY INSTALLATION sound switch (if equipped) NOTE: Your transmitter is equipped with a special automatic ON battery-saving feature. Just turn your vehicle ON. Then push either transmitter stick and you will be able to run and control your vehicle. Some transmitters include a sound feature. The sound feature can be deactivated by turning the sound switch to the OFF position. power indicator light 1. To install transmitter battery, open battery door as shown. 2. Install one 9V battery with polarity (+/-) as shown inside battery compartment. 3. Swing battery door closed and snap shut. vehicle controls battery door battery compartment CONSUMER INFORMATION: (or equivalent). IMPORTANT: Please read before operating your vehicle. Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or SAFETY INFORMATION rechargeable (nickel-cadmium) batteries. Note to Adults: To ensure that the child’s Remove used-up batteries immediately. play is both safe and fun, please review all Remove batteries if vehicle will not be used operating instructions and safety rules with for a long period. your child. Do not recharge non-rechargeable batteries. Do not short-circuit terminals. Safety Tips Remove rechargeable batteries before • NEVER drive your vehicle on streets! recharging (if the batteries are designed to be They’re for real cars! removable). • DO NOT pick up vehicle while in motion. Recharge batteries only under adult supervi• Keep fingers, hair and loose clothing sion (if the batteries are designed to be away from the tires and the wheel hubs removable). while the vehicle is switched ON. • Adult supervision is recommended when Dispose of batteries safely. Do not dispose of batteries (or products containing non-replacethis vehicle is being operated. able batteries) in fire, as batteries may • To avoid accidental operation, remove all explode or leak. batteries when not in use. Battery Performance Note: For best performance use alkaline batteries BATTERY SAFETY INFORMATION (where disposable batteries are called for). If Insure that battery polarity is correct. your vehicle is supplied with standard (car Use only batteries of the type recommended bon-zinc) batteries for initial use and/or ❶ ❷ ❸ demonstration purposes, we recommend replacing them with alkaline batteries when necessary. Battery life may vary depending on battery brand. QUICK TIPS ❶ When your vehicle starts to lose power, it may lose functions or performance. It's time for fresh batteries (or a recharge). Your vehicle's running time may change depending on your driving style. ❷ Radio interference can make your vehicle run badly. Interference can be caused by other R/C vehicles running on the same frequency; electrical wires; large buildings; or CB radios. Try to stay away from these! ❸ Point your transmitter antenna up - not down toward your vehicle. If your vehicle gets too far away, it won't work properly. ❹ Don’t drive your vehicle in sand or through water or snow. ❺ Don’t store your vehicle near heat or in direct sunlight. Always turn switches OFF and remove all batteries for storage. ❹ ❺ TROUBLESHOOTING - PROBLEM? - SOLUTIONS SYMPTOM • PROBABLE CAUSE • CORRECTION Vehicle runs slowly or will not run. • Loose battery connection or vehicle switch not ON. • Weak or uncharged rechargeable NiCd battery (if applicable). • Weak AA batteries (Power Clip) or transmitter battery. • Check battery connector and vehicle switch. • Charge battery or replace. Power indicator light on transmitter does not light. • Transmitter battery weak or not connected. • Check connections and replace battery if required. Erratic operation or only short range possible. • Radio interference likely. • Recharge vehicle battery. Vehicle doesn’t work after going through water or snow. • Water in the electronics area. • Vehicle will take several hours to dry. Allow to dry thoroughly overnight before trying again. • Avoid driving in water or snow. • Replace with fresh alkaline battery. 90-DAY LIMITED WARRANTY – TYCO® R/C PRODUCTS Mattel, Inc. warrants to the original consumer purchaser that this product will be free of defects in material and workmanship for ninety (90) days (unless specified in alternate warranties) from the date of purchase. Mattel will repair or replace the product, at our sole option, in the event of such a defect within the warranty period. In the event of a defect covered under this warranty, first call the toll-free number listed below. Many problems can be solved in this manner. If necessary, you will be instructed to return the product, postage prepaid and insured, to the address below. Enclose your name, address, dated sales receipt, and a brief explanation of the defect. Repair or replacement, and return shipment, will be free of charge. Please return only the defective part or unit, packed securely. This warranty does not cover damage resulting from unauthorized modification, accident, misuse or abuse. If the product is returned without a dated sales receipt the product may be excluded from coverage under this warranty. Mattel’s liability for defects in material and workmanship under this warranty shall be limited to repair or replacement, at our sole option, and in no event shall we be responsible for incidental, consequential, or contingent damages (except in those states that do not allow this exclusion or limitation). This warranty is exclusive, and is made in lieu of any express or implied warranty. Valid only in U.S.A. This warranty gives you specific legal rights and you may have other rights, which vary from state to state. Some states do not allow the exclusion of incidental or consequential damages, so the above exclusions or limitations may not apply to you. TOLL-FREE NUMBER: 1-888-557-TYCO (8926) (valid only in U.S.A.) Hours: 8:00 A.M. - 6:00 P.M. Eastern Time; Monday - Friday. Expect some delay in January following the holiday season. Please be patient and keep trying the toll-free number. ADDRESS FOR RETURNS: CONSUMER RELATIONS, 636 GIRARD AVENUE, EAST AURORA, NY 14052 © 2000 Mattel, Inc., Mt. Laurel, NJ 08054 U.S.A. PRINTED IN CHINA. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. Retain this address for future reference: Mattel U.K., Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Mattel Australia Pty., Ltd., Richmond, Victoria 3121 - Consumer Advisory Service: 1800 800 812 (valid only in Australia). Mattel East Asia Limited, 930 Ocean Centre, Harbour City, HK, China. COMPLIANCE WITH FCC REGULATIONS THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION OF THIS DEVICE IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE. (2) THIS DEVICE MUST ACCEPT ANY HARMFUL INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. This device generates and uses radio frequency energy and if not used properly may cause interference to radio and television reception. It has been tested and found to comply with the limits set by the FCC, which are designed to provide reasonable protection against such interference. CAUTION: FCC Regulations state that changes or modifications to this product not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.2 Linearized : No Create Date : 2001:03:13 14:09:47 Producer : Acrobat Distiller 4.0 for Macintosh Author : PDG19 Title : 00007-1713-03 Creator : QuarkXPress(tm) 4.1 Modify Date : 2001:04:05 16:25:44 Page Count : 3EXIF Metadata provided by EXIF.tools