Maxon CIC SP1402 UHF LMR User Manual Service Info

Maxon CIC Corp. UHF LMR Service Info

Contents

Users Manual II

Synthesized Scanning Radio
FCC RF EXPOSURE COMPLIANCE REQUIREMENTS FOR
OCCUPATIONAL USEONLY
The Federal Communications Commission (FCC), with its action in General Docket 93-62,
November 7,1997, has adopted a safety standard for human exposure to Radio Frequency (RF)
electromagnetic energy emitted by FCC regulated equipment. Maxon subscribes to the same
safety standard for the use of its products. Proper operation of this radio will result in user
exposure far below the Occupational Safety and Health Act (OSHA) and Federal
Communications Commission limits.
DO NOT transmit for more than 50% of total radio use time (50% duty cycle). Transmitting
more than50% of the time can cause FCC RF exposure compliance requirements to be
exceeded.
This radio is NOT approved for use by the general population in an uncontrolled environment.
This radio is restricted to occupational use, work related operations only where radio operator
must have the knowledge to control the user’s exposure conditions for satisfying the higher
exposure limit allowed for occupational use.
When transmitting, hold the radio in a vertical position with its microphone 2 inches (5 cm) away
from your mouth. The radio is transmitting when the red LED on the front of the radio is
illuminated. You can cause the radio to transmit by pressing the PTT bar on the radio.
These are required operating configurations for meeting FCC RF exposure compliance. Failure
to observe these restrictions mean violation.
Safety Information
The Federal Communications Commission (FCC), with its action in General Docket 93-62,
March 13, 1997, has adopted a safety standard for human exposure to Radio Frequency (RF)
electromagnetic energy emitted by FCC regulated equipment. Maxon subscribes to the same
safety standard for the use of its products. Proper operation of this radio will result in user
exposure far below the Occupational Safety and Health Act and Federal Communications
Commission limits.
WARNING - DO NOT hold the radio in such a manner that the antenna is next to, or
touching, exposed parts of the body, especially the face or eyes, while transmitting.
WARNING - DO NOT allow children to operate transmitter - equipped radio equipment.
CAUTION - DO NOT operate the radio near unshielded electrical blasting caps or in an
explosive atmosphere unless it is a type especially designed and qualified for such use.
CAUTION - DO NOT press and hold the transmit switch (P-T-T) when not actually
wishing to transmit.
NOTE: This radio operates in FCC regulated frequency bands. All radios must be
licensed by the FCC before use. Because this radio contains a transmitter, Federal law
prohibits unauthorized use or adjustments of this radio.
Service Information
Service
Do not tamper with internal adjustments. Damage to the equipment and/or improper operation
may result. There are no user serviceable items inside the radio. It is recommended that you
return your radio to a qualified Maxon Dealer for any service or repairs.
Recycling/Disposal of Batteries
The battery should be recycled at the end of its useful life. Under various state or local laws,
such batteries must be recycled or disposed of properly and cannot be dumped in landfills or
incinerators. For jurther information on how to safely dispose of four used batteries, contact
your reseller.
Maintenance
Your SP1402 Radio is designed to be maintenance free. To keep your radio in good working
condition:
Clean external surfaces with a clean cloth dampened in a solution of dishwasher detergent
diluted in water. Apply the solution sparingly to avoid any moisture leaking into cracks and
crevices. Do not submerge the radio. Use a non-metallic brush to dislodge stubborn particles, if
necessary. Dry the surface thoroughly with a soft, lint free cloth.
DO NOT use solvents or spirits for cleaning - they may permanently damage the housing.
Clean the battery contacts on the back of the radio with a lint free cloth to remove dirt, grease,
or other foreign material that may impede good electrical contact.
Limited Warranty
Maxon shall have no obligation to make repairs or to cause replacement required which result
from normal wear and tear or necessitated in whole or in part by catastrophe, fault or negligence
of the user, improper or unauthorized alterations, repairs to the Product, use of the Product in a
manner for which it was not designed, or by causes external to the Product. This warranty is
void if the serial number is altered, defaced or removed.
Maxon's sole obligation hereunder shall be to repair or replace the Product covered in the
above warranty.
Frequency Information
RSS-119 and SRSP-501 only allow for operation of devices in the 406.1-430 MHz and 450-470
MHz UHF bands. Consequently, this device will only be certified and listed in the Industry
Canada REL for the frequency band 450-470 MHz, although testing has been performed at 440
MHz. It is not possible to list the frequency range 440-470 MHz in the REL.

Navigation menu