Measurement PSC903 Bluetooth Pressure Sensor User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2956995
Application ID	1d20bRjMdKYdUejqrqbSGw==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	53.31kB (666399 bits)
Date Submitted	2016-04-12 00:00:00
Date Available	2016-04-12 00:00:00
Creation Date	2016-03-30 13:44:35
Producing Software	OpenOffice 4.1.1
Document Lastmod	0000-00-00 00:00:00
Document Title	User Manual
Document Creator	Writer

r Pressure-Sensor.com \
Precision Scnwr Solutions from Pressure Sensor Limited m pressuresensm mm
Mdre;s:11751 Rock Lans‘ng Drive Suite H77 Newpm News, VA 23506 LLSA
Tel-(u 757 705-3795 szslll757 240-5350 Email'salcsapressuresensor com
PSC903 pressure sensor Operation and Specification
Operation:
Press button once, sensor powers on into broadcast Mode.
..... - Green/Red light blinks
-Sensor advertises for 2 minutes looking for a connection before sensor powers off automatimlly;
After sensor is connected with App. sensor will then blink solid green light every 5 seconds.
'Sensor starts transmission data to App after connection
Sensor can be shut down by holding the sensor button for 3 seconds
-Sensor will flash red LED two time upon successful shutdown and power off.
—Sensor will flash green two times and return to the current state H the button is not held for a long enough
period of time.
When sensor disconnects with iOS device unexpectedly under below events, sensor will go into broadcast mode for
2 minutes looking to reconnect.
'Turn off the Bluelooth radio for iOS device
'Force shut down app
-Take sensors out of range of iOS device
'Shut off iOS device
Application environment:
~ The appliance intends to use into the equipment such as air conditioners and similar equipment
- Operating tempemture (Media Temperature): ADC to 125C
~ Operating temperature (Product environment): 0 to 75C performance
Install information:
Bluetooth Pressure Sensor
- The male thread will be installed into the female thread of the test equipment, see fig.1
119.1
Battery specification
- Battery mode: ER14250
'Inpulvoltage: 3.6V
-lnstall information: ER14250 Li-SOCIZ Primary Lithium Battery cell will be put into the battery box, the positive pll'l
should match the polarity matched on the battery box, then assemble the battery box to the production(pillar to the
groove). See 119.3, figA
Warranty:
This appliance can be used by children aged from 8 years and above and personswith reduced physical,
sensory or mental capabilities or lack of experience and knowledge it they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved. This appliance is not
intended lor use by persons (including children)with reduced physical, sensory or menial capabilities, orlack of
experience and knowledge unless they have been given supervision or instruction concerning use olthe appliance
by a person responsible for their safety.
Children shall not play With the appliance. Cleaning and user maintenance shall not be made by children Without
supervision.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions. (1) this device may not cause interference. and (2) this device must accept any interference,
including interference that may cause undesired operation ofthe device
Le present appareil est conforme aux CNR d'lndustrie Canada applicables aux apparells radio exempts de licence.
L'exploltation est autorisee aux deux conditions suivantes : (1) l'appareil ne doit pas produire de broulllage, et (2)
l‘utilisateur de l'appareil doit accepter tout broulllage radloelectrique subi, meme si le brouillage est susceptible d'en
compromettre le fonctlonnement
FCC STATEMENT:
This device complies With Part 15 of the FCC Rules. Operation is subject to the folloWing two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received. including interference that may cause undesired
operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void
the usei‘s authority to operate the equipment
NOTE. This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation
This equipment generates uses and can radiate radio frequency energy and. if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one ormore of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in ponable
exposure condition without restriction.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Page Count                      : 5
Language                        : en-US
Creator                         : Writer
Producer                        : OpenOffice 4.1.1
Create Date                     : 2016:03:30 13:44:35+02:00

EXIF Metadata provided by EXIF.tools